Battery installation and charging
Push to talk (PTT)
Make, answer and end a call
Make a call
Install the battery as shown below. After
installing the battery, you may be able to make
and receive short calls. For best performance,
charge the handset battery for at least 16 hours
before use.
You can directly broadcast messages from one
handset to the speakerphone of one or all other
handsets. Any handset you call can respond by
pressing PUSH TO TALK to begin a two-way
communication.
1. Press
/FLASH or
.
You hear a dial tone.
2. Dial the number.
Quick start guide
When the connection is made, both the caller
and the destination handsets display Press
and hold [PTT] to talk and beep once.
Only one handset can be talk at a time. To do
so, press and hold PUSH TO TALK.
Make a predial call
for models LS6325/LS6325-2/LS6325-3/
LS6325-4/LS6325-5/LS6326-5
1
2
1. Dial the number.
Plug the battery
If the battery
2. Press
/FLASH or
.
connector securely
into the socket inside
the handset battery
compartment, matching
the color-coded label.
compartment cover is on
the handset, press on the
indentation and slide the
cover to remove.
Answer a call
For complete PTT instructions, please refer
to your user’s manual.
Install the telephone base and
charger(s)
Install the telephone base and charger(s) as
shown below.
Press
/FLASH,
or any of the dialing keys
(0-9, #, TONE ).
End a call
Press OFF/CLEAR or put the handset in the
Telephone
wall jack
Telephone
base power
adapter
telephone base or charger.
Charger
adapter
If you have
DSL high
speed
Electrical
Internet
outlet not
4
3
service, a
controlled by
a wall switch
DSL filter (not
included) is
required.
Place the battery with
Align the cover flat
the label THIS SIDE UP against the battery
facing up and the wires compartment, then slide
inside the battery
compartment.
it towards the center of
the handset until it clicks
into place.
Telephone
line cord
Charger
Telephone base
• Use only the power adapters and batteries
supplied with your VTech telephone.
5
• For complete feature instructions, please
refer to your user’s manual.
Charge the handset by
placing it in the telephone
base or charger. The
CHARGE
light
CHARGE light is on when
the handset charges.
|