LU63PB/PW
INSTALLATION/OWNER’S MANUAL
Indoor/Outdoor 3-Way Loudspeakers
®
Download from Www.Somanuals.com. All Manuals Search And Download.
®
LU63PB/PW PLACEMENT
Speaker Placement
Mounting Placement Mounting both speakers on a common solid surface facing
the listening area will provide the best audio results.
Do NOT mount speakers on surfaces that have hazards
such as electrical wires or plumbing behind them. Be sure
that your mounting surface is capable of supporting the
weight of the speakers.
Wall and Ceiling Mounting brackets are included for wall and ceiling
Placement applications. The LU63 speakers have two standard 1/4-20
brass inserts incorporated into the rear of the enclosure for
aftermarket mounting systems.
Experiment for Better We recommend that you take the time to experiment with
Sound different speaker placements. Sound quality and imaging
are widely dependent on the location of your speakers as
well as room acoustics. Angling each speaker toward the
listening position often provides the most realistic imaging
experience. The amount of perceived bass increases as you
move a speaker closer to solid intersecting room surfaces
(wall, ceiling, floor).
3
Download from Www.Somanuals.com. All Manuals Search And Download.
®
LU63PB-LU63PW INSTALLATION
Placement & Mounting Speakers
Outdoor Placement The DUAL LU63 has been tested for environmental usage and
is deemed weather resistant, but not waterproof. Occasional
moisture will not affect performance. The speakers should
always be allowed to ventilate and dry after water exposure.
The speakers can be placed permanently outdoors for year-
round enjoyment. To maximize speaker life, position in areas
protected from the elements, such as the underside of eaves
or overhangs. Popular locations include decks, gazebos,
porches, atriums, garages, and covered spa areas.
For temporary placement, remove the speaker from the
mounting brackets and replace the thumb screws to maintain
stability if placing the speakers on end.
Each speaker has a DUAL logo that can be rotated. The logo
is located on the face of the grille and comes positioned for
vertical installation. If mounting the speakers horizontally,
we recommend rotating the logo accordingly.
The logo is spring-loaded. To rotate, elevate both ends
equally by placing your fingernail under and lifting lightly.
While the logo is elevated, turn the logo to the desired
orientation and release.
Mounting
Your Speakers
For ease of installation, we have included an easily
removable mounting bracket. Once mounted, the bracket
allows the speaker to be angled to its ideal position. The
included thumb screws will hold the selected speaker
position when properly tightened.
Before attempting the installation, carefully evaluate the
mounting surface to ensure that its composition and
construction are capable of safely supporting the weight of
the speaker. If you are unsure about the type of mounting
hardware to use, consult a professional contractor or a
knowledgeable hardware store.
Note: Anchors and screws needed to mount brackets are not
included and must be purchased separately.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
®
LU63PB-LU63PW CONNECTION
Connecting Speakers
Connecting Speaker Wire -We recommend the use of two conductor
Your Speakers 18-gauge speaker wire to connect the speakers to your
receiver. When connecting the speakers in a stereo
configuration, the wire length should be similar. One length
should not be dramatically longer or shorter then the other.
Maintaining similar wire lengths will provide superior sound
quality.
Polarity - Speaker wire polarity is indicated by either a
color stripe on the insulation, ridges molded into one side
of the insulation, the color of the insulation case around the
wire, or by the color of the wire itself (copper or silver).
LU63PB
Connect speaker wire using the positive (+) terminal on
the receiver to the positive (+) speaker terminal, and
the negative (-) terminal on the receiver to the negative
(-) speaker terminal. All speakers in a system must be
connected with the same relative polarity.
Connection - It is recommended that the speaker wire
insulation be stripped back approximately 3/8”, allowing
the wire conductor to make a proper connection. The gold
terminals have red (positive) and black (negative) polarity
indicators. Loosen the gold terminals by turning counter-
clockwise. Insert the wire end and re-tighten.
Banana style connectors may also be used. The connection
is made by connecting the speaker wire to the banana
plugs, and then inserting the banana plug into the top
portion of the binding posts.
Note: Do not allow the positive and negative speaker wire
from the receiver to make contact at any time, as this will
cause a short.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
®
LU63PB-LU63PW TROUBLESHOOTING
Troubleshooting & Specifications
If you hear obvious distortion from the speakers, immediately
Distortion/Knocking
lower the volume level of your receiver. Distortion often
indicate that either the receiver or the speaker is being
overdriven, and damage can result in playing your source
material (music-CDs-DVD-MP3) at high volume levels for
prolonged periods of time. You should also avoid turning the
bass or treble controls up and using your "Loudness button"
when the volume level is at or above normal listening levels.
Note: The Loudness button on most receivers is designed to
add depth when your system is being used for background
music or at very low volume.
Distorted or unnatural sound can indicate poor connections,
defective electronics, damaged source material or speaker
failure. If only one speaker has poor sound quality, check the
speaker wire and audio connections. If that doesn’t fix the
problem, try putting each speaker in place of one another
(swapping). If the sound remains poor on the suspect speaker
after swapping location and the distortion moves with the
speaker to the new location, the speaker may be the problem.
If the distortion remains in the original location then the
problem is elsewhere in your audio/video system.
Model LU63
Frequency Response 60Hz-20kHz
Woofer 6.5" Polypropylene with rubber surround
Midrange 25mm polypropylene
Tweeter 20mm Piezo Dome
Sensitivity 89dB
Specifications
Nominal Impedance 8 ohms
Power Handling 140 Watts
Dimensions (Inches H x W x D) 11” x 7 7/16” x 7 3/4”
Weight 3.9 lbs.
Finish Black or White
All Rights Reserved. All specifications subject to change without notice.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Limited Two-Year Warranty
This warranty gives you specific legal rights. You may
also have other rights which vary from state to state.
What to do?
1. Before you call for service, check the
troubleshooting guide in your owner’s manual.
A slight adjustment of any custom controls or
connections discussed in your instruction booklet may
save you a service call.
Dual Electronics Corp. warrants this product to the
original purchaser to be free from defects in material
and workmanship for a period of two years from the
date of the original purchase.
2. If you require service during the warranty period,
you must carefully pack the product (preferably in the
original package) and ship it by prepaid transportation
with a copy of the original receipt from the retailer to
an authorized service center.
Dual Electronics Corp. agrees, at our option, during
the warranty period, to repair any defect in material
or workmanship or to furnish an equal new, renewed
or comparable product (whichever is deemed
necessary) in exchange without charges, subject to
verification of the defect or malfunction and proof
of the date of purchase. Subsequent replacement
products are warranted for the balance of the original
warranty period.
3. Please describe your problem in writing and
include your name, a return UPS shipping address
(P.O. Box not acceptable), and a daytime phone
number with your shipment.
Who is covered? This warranty is extended to the
original retail purchaser for products purchased and
used in the U.S.A.
4. For more information and for the location of the
nearest authorized service center please contact us
by one of the following methods:
What is covered? This warranty covers all defects
in material and workmanship in this product. The
following are not covered: installation/removal costs,
damage resulting from accident, misuse, abuse,
neglect, product modification, improper installation,
incorrect line voltage, unauthorized repair or failure
to follow instructions supplied with the product, or
damage occurring during return shipment of the
product.
Call us toll-free at 1-866-382-5476
E-mail us at [email protected]
Exclusion of Certain Damages: This warranty is
exclusive and in lieu of any and all other warranties,
expressed or implied, including without limitation
the implied warranties of merchantability and fitness
for a particular purpose and any obligation, liability,
right, claim or remedy in contract or tort, whether or
not arising from the company’s negligence, actual or
imputed. No person or representative is authorized
to assume for the company any other liability in
connection with the sale of this product. In no event
shall the company be liable for indirect, incidental or
consequential damages.
®
Dual Electronics Corporation
Toll Free: 1-866-382-5476
©2006 Dual Electronics Corp. All rights reserved.
NSA0306-V01
Download from Www.Somanuals.com. All Manuals Search And Download.
|