BAR SINKS
BS-1515
TOOLS REQUIRED
• Ruler
• Drill
• Caulk
• Saber Saw
(if counter top
cutout is required)
BS-2515
TRACE COMPLETELY
AROUND EDGE OF SINK
DRAW A 1-1/2؆ RADIUS
AT EACH CORNER
DRILL STARTER HOLE
INSIDE OF CUTOUT LINE
CUT INSIDE OF LINE
5/16Љ
CUTOUT LINE
1. If it is necessary to cut out
the counter top, invert sink
and position onto the counter
top. Locate sink front to rear
and so that the bowl will not
interfere with the cabinets
below. Trace a pencil line
around the outside edge of
the sink and remove the sink
from the counter top.
2. Measure in 5/16Љ from the
initial sink outline and draw a
second line inside the first.
Draw a 1-1/2Љ radius at each
corner. This second interior
line will be your cutout line.
3. Drill starter hole inside of
cutout line.
4. Using a saber saw, cut
inside of cutout line. Trial fit
sink to check proper fit.
Check Cutout
Line Measurements
Model
BS-1515
BS-2515
Width
14-3/8Љ
24-3/8Љ
Depth
14-3/8Љ
14-3/8Љ
Measure the cutout or the
pre-cut opening to be sure it
conforms to the sizes listed.
OWNER’S MANUAL
MODEL NOS.
BS-1515
CAUTION:
Read ALL instructions carefully
BEFORE starting your installation.
Save this manual for future reference.
Installation
Care and
Cleaning
BS-2515
Download from Www.Somanuals.com. All Manuals Search And Download.
|