Roper Range FEP310K User Guide

®
30" Freestanding Electric Range  
PRODUCT MODEL NUMBERS  
OVERALL DIMENSIONS  
FEP310K  
FEP320K  
FEP330K  
FES330K  
Electrical: This range can be direct wired to a  
four-wire or three-wire, 8 gauge copper or 6  
gauge aluminum wire wiring system or a range  
power supply cord can be used. A four-wire or  
three-wire, single-phase, 120/240-volt, 60 Hz,  
AC-only, electrical supply is required on a 40 amp  
circuit, (or, if specified on the model/serial rating  
plate, a four-wire or three-wire, single-phase  
120/208-volt, 60 Hz, AC-only electrical supply is  
available, a 40 amp circuit), fused on both sides  
of the line. A time-delay fuse or circuit breaker is  
recommended. The model/serial rating plate is  
located on the oven frame behind the storage  
drawer panel.  
27-1/8" (68.9 cm)  
depth with handle  
46-7/8"  
(119.1 cm)  
overall  
height  
36"  
(91.4 cm)  
cooktop  
height  
24-13/16"  
(63 cm)  
29-7/8" (75.9 cm) width  
CABINET OPENING DIMENSIONS  
Cabinet opening dimensions shown  
are for:  
13" (33 cm) max.  
25" (63.5 cm) countertop depth,  
24" (61 cm) base cabinet depth,  
36" (91.4 cm) countertop height  
upper cabinet depth  
30" (76.2 cm) min.  
cabinet opening width  
For minimum  
clearance to the  
top of the cooktop,  
see NOTE.**  
30-1/8" (76.5 cm)  
opening width  
18" (45.7 cm) min.  
clearance upper side  
cabinet to countertop  
Do not pinch  
the power  
4" (10.2 cm) min. clearance  
from both sides of range to  
side wall or other combustible  
material above the countertop  
Wall receptacle —  
8" (20.3 cm) to 22"  
supply cord  
between the  
(55.9 cm) from either  
cabinet, 5-1/2"  
5-1/2"  
(14.0 cm)  
max.  
range and the  
wall.  
(14.0 cm) max. from  
floor. Position  
receptacle as shown.  
Do not seal the  
range to the  
side cabinets.  
*
NOTE: 24" (61 cm) min. when bottom of wood  
or metal cabinet is protected by not less than 1/4"  
(6.4 mm) flame retardant millboard covered with  
not less than No. 28 MSG sheet steel, 0.015" (0.4  
mm) stainless steel, 0.024" (0.6 mm) aluminum or  
0.020" (0.5 mm) copper.  
30" (76.2 cm) min. clearance between the top of the  
cooking platform and the bottom of an unprotected  
wood or metal cabinet.  
Because Whirlpool Corporation policy includes a continuous commitment to improve our  
products, we reserve the right to change materials and specifications without notice.  
Dimensions are for planning purposes only. For complete details, see Installation  
Instructions packed with product. Specifications subject to change without notice.  
Ref. 9759923  
05-20-04  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Raymarine GPS Receiver Heading Sensor User Guide
Ricoh All in One Printer 2051 2060 2075 User Guide
Roland Electronic Keyboard MP 60 User Guide
RuggedCom Marine Radio RS900W User Guide
Ryobi Trimmer RY30542 User Guide
Saitek Headphones TM A 350 User Guide
Samsung Flat Panel Television LA40A330J1 User Guide
Samsung Refrigerator RF24FSEDBSR User Guide
Schneider Electric Stroller 840 USE 106 0 User Guide
Sears Battery Charger 20071210 User Guide