Maytag Washer Dryer TDL 0050B B User Manual

Technical Bulletin  
Date: September 2005  
Type  
Policy Letter  
Service Information  
No:  
TDL-0050B-B  
ITDL-0020A-B  
Page 1 of 4  
Attention  
Service Managers  
Supersedes TDL-0050A-B  
ITDL-0020-B  
Service and Parts Managers  
Models  
AAV1200AGW, AAV1200AJW, AAV1200AKW, AAV1200ARW,  
AAV1200AWW, AAV2200AGW, AAV2200AJW, AAV4200AGW,  
ALW221RJW,CAV1000AWW, CAV2000AGW, CAV2000AJW,  
CAV2000AKW, CAV2000AWQ, CAV2000AWW, CAV4000AWW,  
CW5000W, CW6000Q, CW6000W, CW7500Q, CW7500W, DLW231RAW,  
HAV1200ARW, HAV1200AWQ, HAV1200AWW, HAV2360AWW,  
HAV2460AWW, HAV2557AWW, HAV2558AWW, HAV3460AWW,  
HAV4200AKW, HAV4200ATW, HAV4200AWW, HAV4657AWW,  
JAV4200AWQ, LNC6760B71, LNC6762B01, LNC6762B71, LNC6764A71,  
LNC6766B71, MAV2200AJW, NAV3200AWW, NAV4200AGW,  
NAV4200AKW, PAV1200AWW, PAV2200AAW, PAV2200AGW,  
PAV2300AGW, PAV2300AWW,PAV2360AWW, PAV3200AAW,  
PAV3200AGW, PAV3240AWW, PAV3300AGW,PAV3300AKW,  
PAV3300AWW, PAV3360AWW, PAV4960AWW, PAV5000AWQ,  
PAV5000AWW, PAV5057AWW, PAV5058AWW, PAV5157AWW,  
PAV5158AWW, PAVT234AWW, PAVT244AWW, PAVT344AWW,  
PAVT444AWW  
Brand  
Admiral  
Amana  
Crosley  
Jenn-Air  
Magic Chef  
Maytag  
Maytag Performa  
Product  
Laundry  
Issue  
Wash basket leans to one side, generally to the right as you face the washer  
during spin cycle.  
Warranty  
Action  
Standard product manufacturing warranty applies.  
Replace original base with Kit 12002701. The replacement of the base, new snubber,  
and six springs (included in the Kit) will reduce tub lean to an acceptable level.  
NOTE: Some tub lean is normal.  
1. Disconnect power supply to unit.  
2. Tilt washer and remove belt from underside of base.  
3. Remove back cover to access and remove drain hose clamps.  
NOTE: There will be water remaining in the hose from the last cycle.  
© 2005 Maytag Services  
Download from Www.Somanuals.com. All Manuals Search And Download.  
7. Remove pressure switch hose from outer tub. Remove screws from sides and rear of unit around bottom,  
connecting cabinet to base. Remove cabinet from base and set aside. Be sure to lay down a protective pad  
before removing tub and transmission assembly from base. Remove tub springs using the spring removal  
tool; be careful not to let tub and transmission assembly tip over.  
8. Be sure to lay down a protective pad before removing tub and transmission assembly from base. Remove  
tub and transmission assembly, turn over and lay on protective pad.  
9. Remove dust cap, retaining ring, washer, cam, and pulley from bottom of transmission.  
Pulley  
Cam  
Retaining ring  
Washer  
Dust cap  
10. Remove stator from transmission using Brake Removal Tool 12002012, refer to Service Manual for  
disassembly procedures. Remove old snubber from transmission.  
11. Be sure to wash hands to remove any dirt or grease before handling new snubber. Clean new snubber with  
alcohol before installing. Install new snubber. Insure snubber is centered.  
Snubber  
TDL-0050B-B  
ITDL-0020A-B  
© 2005 Maytag Services  
Page 3 of 4  
9/30/2005  
Download from Www.Somanuals.com. All Manuals Search And Download.  
12. Reinstall stator by locating the dimple on the stator, and tightening the screw next to the dimple first. Next  
tighten the screw 180 degrees across from the dimple. Install and tighten remaining screws. Reinstall pulley,  
cam, washer, retaining ring, and dust cap.  
Dimple  
Stater  
13. Turn new base upside down and apply grease at bottom of the spring hole pockets to eliminate noise  
between spring and base interaction.  
Apply grease at bottom of  
spring hole pockets.  
14. Clean the dome area of new base with alcohol then apply corn starch.  
Apply corn starch to new base  
on dome area after cleaning  
with alcohol.  
15. Reinstall motor and pump to new base.  
16. Transfer transmission and outer tub onto new base. Use spring tool 22002922 to avoid over stretching the  
springs.  
17. Transfer cabinet shell onto new base and reassemble washer. Be sure to reattach pressure switch hose to  
back of tub, drain pump hoses with clamps to drain pump, and wire harness to motor. Check all hoses and  
wires to make sure they are secure.  
18. Test washer.  
Page 4 of 4  
9/30/2005  
© 2005 Maytag Services  
TDL-0050B-B  
ITDL-0020A-B  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Life Fitness Treadmill 90T XXXX 04 User Manual
Lightolier Indoor Furnishings 1050RNDL_3D User Manual
Magnadyne Car Video System M135C 4 User Manual
Magnavox Portable CD Player AZ7166 User Manual
Marantz DVD Player VC4400 User Manual
Maretron GPS Receiver BHW100 User Manual
M Audio Electronic Keyboard KeyStudio 25 User Manual
Maytag Dishwasher W10157789A User Manual
Melissa Juicer 144 002 User Manual
Melissa Vacuum Cleaner 240 116 User Manual