Lytecaster® Recessed Downlighting 1102TM1
Page 1 of 1
6 3/4 ” Aperture Low Profile 2 Lt. 13W Emergency Fluorescent Frame-In Kit
Complete Fixture consists of Reflector Trim & Frame-In Kit. Select each separately.
Frame-In Kit
Reflector Trims — See Individual Reflector Trim Specification Sheets
Enclosed
Diffusers
Wall
Washer
Open Downlight
Cone
Baffles
Cross Blade
1102TM1
1102TM2
HPF 120V 1113TGD
HPF 277V 1113TCL
1105T
1105TWH
1132T
1126T
1128T
1178T
1135T
Features
Electrical
1. Mounting Frame: .036" (#20 ga.) galvanized steel. Accommodates all
ceilings up to 1" thick. Low profile 3 7/8" depth including ceiling material and
reflector trim. For ceilings thicker than 5/8", depth from finished ceiling will
be ceiling thickness (max. 1") plus 3 1/4". Push-in/twist-out rotoclips hold
reflector flush to ceiling.
120V
31
0.28
277V
42
0.17
HPF Input Watts
Amps
Minimum starting time is 32° F.
Options & Accessories
Concealed Spline Ceiling Kit:
Plaster Ceiling Ring:
2. Junction Box: .063" (#14 ga.) galvanized steel. Rated for 8 #12 AWM
through branch circuit wires suitable for 90° C, for end of run 75° C. Quick
release “L” shaped cover for access to wiring. Integral cable clamps permit
attachment of nonmetallic Romex® or armored cable without need of
additional connectors.
3. Mounting Bars: Die-formed steel, #16 ga. Four bars, 13" long, extend to
27", permit off-center mounting; bars rotate 90° and lock in both directions;
integral poised nailer for wood joists, locking tabs for T-bar runners.
4. Socket Housing: 22 ga. galvanized spring steel; snap-in quick assembly for
precise lamp location.
1965 - set of (4), 1 1/2” to 2 1/2” Mtg. Ht.
1961 - 7/8" depth for wet plaster ceilings.
Labels
UL (Suitable for Damp Locations), I.B.E.W.
Romex® is a registered trademark of General Cable Industries Inc.
US Patent No.: patent pending
5. Socket: Two-pin base, molded thermoplastic; prewired with #18 AWM leads
to 4" x 3 1/2” x 2" junction box.
6. Thermally Protected Ballast: 2 light electromagnetic, encased and potted,
class "P" high power factor. Insulation must be kept 3" away from fixture
sides and wiring compartment and must not be placed above fixture as to
entrap heat.
Job Information
Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
7. Emergency Power Pack: Electronic, fully encased and pre-wired nickel
cadmium long life battery, replaceable from below. Meets requirements of
National Electric Code and Life Safety Code. Test switch and charge light
included in easy to install recessed switch box with 4 1/2” diameter matte
white cover plate, 24" long flexible cable; may be installed up to 50 feet from
fixture. One lamp operates at 61% initial output for 90 minutes when power
fails.
Lightolier a Genlyte company
631 Airport Road, Fall River, MA 02720 • (508) 679-8131 • Fax (508) 674-4710
We reserve the right to change details of design, materials and finish.
© 2006 Genlyte Group LLC • E0506
Download from Www.Somanuals.com. All Manuals Search And Download.
|