Lenoxx Electronics Telephone 601 User Manual

®
DESIGNER PHONE  
MODEL: PH-600, BP-600 AND BP-601  
OPERATING INSTRUCTIONS  
TONE/PULSE SWITCHABLE DIALING  
RECEIVER VOLUME CONTROL  
MUTE BUTTON - FOR TEMPORARY HOLD  
FLASH BUTTON - FOR NEW DIAL TONE  
REDIAL BUTTON - FOR BUSY SIGNALS  
DESK OR WALL MOUNTABLE  
FULLY MODULAR JACKS  
MODERN CONTEMPORARY STYLING  
NOTE: READ AND FOLLOW THESE INSTRUCTIONS BEFORE USING YOUR TELEPHONE  
E
PH-600082799 MS V.2  
Download from Www.Somanuals.com. All Manuals Search And Download.  
IMPORTANT TELEPHONE COMPANY & FCC INFORMATION  
CAUTION : TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK  
AND PERSONAL INJURY, DO NOT OPEN CABINET.  
WE SUGGEST THAT YOU REVIEW THE FOLLOWING INFORMATION  
PROVIDED BY THE FCC (FEDERAL COMMUNICATIONS COMMISSION).  
FCC REGISTRATION  
This telephone set is registered with the FCC based upon compliance with Part 68 of its rules. Con-  
nection of this telephone to the nationwide telecommunications network must be through a standard  
network jack (RJ11W or RJ11C) which you can order from your telephone company, if not already  
installed.  
NOTE : FCC registration does not constitute an expressed or implied guarantee of performance. Only  
the Lenoxx warranty in this booklet covers the performance of this telephone set.  
IMPORTANT FCC INFORMATION  
In the event that terminal equipment causes harm to the telephone network, the telephone company  
should notify the customer,if possible,that service may be stopped. However, where prior notice is  
impractical, the company may temporarily cease service providing that they:  
1. promptly notify the customer.  
2. give the customer an opportunity to correct the problem with their equipment.  
3. inform the customer of the right to bring a complaint to the Federal Communications Commission  
pursuant to procedures set out in FCC Rules and Regulations Subpart E of Part 68.  
The telephone company may make changes in its communications facilities, equipment, operations or  
procedures, where such action is reasonably required in the operation of its business and is not  
inconsistent with the rules and regulations in FCC Part 68. If such changes can be reasonably ex-  
pected to render any customer terminal equipment incompatible, the customer shall be given adequate  
notice in writing, to allow the customer an opportunity to maintain uninterrupted service.  
RINGER EQUIVALENCE NO. (REN):  
The REN is useful to determine the quantity of devices you may connect to your telephone line and still  
have all of those devices ring when your telephone number is called. In most, but not all areas, the sum  
of the REN’s of all devices connected to one line should not exceed five (5.0). To be certain of the  
number of devices you may connect to your line, as determined by the REN, you should contact your  
local telephone company to determine the maximum REN for your calling area.  
NOTE :  
This equipment has been tested and found to comply with the limits for a Class B digital device, pur-  
suant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against  
harmful interference in a residential installation. This equipment generates, uses, and can radiate  
radio frequency energy and, if not installed and used in accordance with the instructions, may cause  
harmful interference to radio communications. However, there is no guarantee that interference will  
not occur in a particular installation. If this equipment does cause harmful interference to radio or  
television reception, try the following:  
1. Reorient or relocate the receiving antenna.  
2. Increase the separation between the equipment and receiver.  
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is  
connected.  
4. Consult the dealer or an experienced radio/TV technician for assistance.  
GENERAL  
The FCC prohibits customer-provided terminal equipment to be connected to party lines or to be used  
in conjunction with coin telephone service.  
This phone is hearing aid compatible.  
2
E
PH-600082799 MS V.2  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Congratulations for purchasing a Lenoxx Sound telephone. Some of the features of  
the PH-600, BP-600 and BP-601 are:  
LAST NUMBER REDIAL - Useful if line is busy.  
DESK OR WALL MOUNTABLE - No special hardware needed.  
TONE/PULSE SWITCHABLE - Select the desired dialing mode.  
ADJUSTABLE HANDSET VOLUME CONTROL - Adjusts and raises volume of  
receiver.  
FLASH BUTTON - For alternate pay service such as call waiting or getting a new dial  
tone quickly.  
FULLY MODULAR JACKS - For easy plug-in installation.  
REVERSIBLE HANDSET HOLDER FOR WALL USE - Holds Handset in up-right  
position, if your phone is wall mounted.  
YOUR SALES RECEIPT  
You will need your sales receipt should you ever need warranty service. You should  
also save the packing material if you want to move or ship this phone.  
INSTALLATION INSTRUCTIONS  
HANDSET  
INSTALLATION  
TELEPHONE BASE  
STRAIGHT TELEPHONE CORD  
COILED HANDSET CORD  
To Telephone Jack  
1. Insert the modular plugs of the Coiled Handset Cord into the jack of the Telephone  
Handset and into the jack on the SIDE of the Telephone Base (either end can be  
plugged in).  
2. Insert the modular plugs of the Straight (not coiled) cord into the modular jack at the  
TOP of the Telephone Base and into the Telephone Jack. (either end can be  
plugged in ).  
NOTE: To insure your phone is properly connected, lift Handset and listen for dial  
tone.  
RINGER ON/OFF SWITCH  
ON - Normal setting, rings on incoming calls.  
OFF - The ringer does not sound, for undisturbed privacy.  
NOTE: If your Ringer Switch is in OFF position, only THIS phone will not ring, other  
phones in your home on the same line will ring.  
TONE/PULSE SWITCH  
TONE - The phone will operate using tone dialing.  
PULSE - The phone will dial using rotary dial type pulse.  
NOTE: Even when your phone is set to pulse service, this phone can dial tones for  
access to services that require tone sounds like computer systems or call  
directors. Just press the Tone Button  
after dialing in pulse and your  
buttons can now be used for tone signaling for this call only. After you hang  
up, the phone resets itself to pulse dialing.  
3
E
PH-600082799 MS V.2  
Download from Www.Somanuals.com. All Manuals Search And Download.  
TELEPHONE OPERATION  
1.RECEIVING A CALL: When your telephone rings, pick it up and use like any basic  
telephone.  
2.DIALING A CALL: Pick up the phone, wait for dial tone and dial the number  
desired.  
3.ENDING A CALL: After you have finished a conversation, just hang up.  
4.TO REDIAL LAST NUMBER: If you want to redial the last number quickly,  
get a new dial tone, press the Redial Button. To erase redial memory, lift the  
handset and dial any numbers.  
5.FLASH BUTTON: The button is used to get a new dial tone, also this button is used  
to activate customer calling services available through your local phone company,  
such as call waiting. These service are provided by your phone company and cost  
extra.  
6.MUTE BUTTON: Pressing the Mute Button prevents the other party from hearing  
your conversation WHILE THE BUTTON IS HELD DOWN.  
WALL MOUNTING  
The phone can be mounted on a wall phone plate.  
1.Use the SHORT Straight Wall Cord.  
2.Plug one end into the top of the phone.  
3.Plug the other end into wall jack.  
4.Route the cord into the channel as shown.  
5.Put phone over wall plate, make sure both posts fit  
into slots on the back of phone. Then push down to  
lock phone onto wall plate.  
NOTE: After your phone is mounted, listen for dial  
tone to confirm the connection is good.  
REVERSIBLE HANDSET HOLDER - When the telephone is mounted on the wall,  
the Reversible Handset Holder must be adjusted so it will hold the Handset.  
1.SLIDE OUT  
2.REVERSE  
3.REPLACE INTO PHONE  
HANDSET HOLDER  
WALL MOUNTING WITHOUT A WALL JACK  
FOLLOW THESE INSTRUCTIONS TO MOUNT THE PHONE ON THE WALL  
MOUNTING AREA  
WITHOUT A WALL JACK.  
MOUNTING  
SCREW  
1. Drill 2 holes 3 15/16" (100mm) apart.  
ANCHOR  
2. Put a screw into each hole and leave  
3/16" (5mm) of the head exposed.  
3. Connect the straight cord to the phone  
and jack.  
3 15/16”  
(100 MM)  
4. Put the keyhole slots over the screws  
and slide down to secure phone.  
LEAVE 3/16” (5 MM)  
SCREW EXPOSED  
4
E
PH-600082799 MS V.2  
Download from Www.Somanuals.com. All Manuals Search And Download.  
TROUBLE SHOOTING  
PROBLEM  
LIKELY CAUSES  
1.Plug disconnected from jack.  
2.Jack improperly wired.  
No dial tone  
1.Damaged cord.  
2.Jack improperly wired.  
3.Line out of order.  
Phone is dead  
1.Ringer Switch in OFF position.  
Slide the Switch to ON position.  
Can make calls but phone  
does not ring  
1.If your other telephones are Rotary type phones,  
move Tone/Pulse Switch to PULSE position.  
2.Contact your phone company to have your line  
changed to Tone and Pulse service.  
Can receive but cannot  
make calls  
LIMITED WARRANTY  
We warrant this product to be free from defects in material and workmanship under normal use  
for a period of 1 year after purchase and we will repair it free of charge or replace it at no charge,  
should it become defective under this warranty, providing you submit proof of purchase (sales slip)  
with the set.  
During the initial 1 year period after original purchase, we will service or exchange, at no charge,  
the set that is returned to LENOXX ELECTRONICS CORP. (LENOXX will pay the shipping back to  
you). After the initial 1 year period expires, we will repair the unit covering any part(s) that need to  
be replaced at no charge, but will charge for the cost of labor, return postage paid by LENOXX.  
This warranty does not apply to any products which have been subject to misuse, neglect or  
accident. This warranty does not cover broken headphones or cabinet. UNDER NO  
CIRCUMSTANCES WILL LENOXX ELECTRONICS CORP. BE LIABLE FOR ANY INCIDENTAL  
OR CONSEQUENTIAL DAMAGES. Some states do not allow the exclusion or limitation of incidental  
or consequential damages, so the above limitations or exclusions may not apply to you.  
This warranty gives you specific legal rights, and you may also have other rights which vary from  
state to state. The following charges apply to repairs beyond the warranty period: $5.00. Be sure to  
pack carefully and return postage paid insured together with your money order (personal checks  
will not be accepted) and sales receipt to :  
LENOXX ELECTRONICS CORP. 2 GERMAK DRIVE, CARTERET N.J. 07008  
For customer service, dial 1-800-315-5885. (MONDAY - FRIDAY 09:00 AM - 5:00 PM EST)  
© 1999 LENOXX ELECTRONICS CORP.  
2 GERMAK DRIVE  
CARTERET, N.J. 07008  
MADE & PRINTED IN CHINA  
5
E
PH-600082799 MS V.2  
Download from Www.Somanuals.com. All Manuals Search And Download.  

KTI Networks Switch KS 105F User Manual
Kyocera Cell Phone M4100 User Manual
Learning Resources Games LER5994 User Manual
LevelOne Digital Camera FCS 1000 User Manual
Liebert Network Card XDR W User Manual
Liebherr Refrigerator CS 7081411 00 User Manual
Lightolier Indoor Furnishings 1102T Series User Manual
Makita Power Hammer HR2611F User Manual
Manitowoc Ice Ice Maker s1400m User Manual
Melissa Toaster 243 012 User Manual