10.1t
I N ST R U C T I O N S
KAPPASERIES
®
Thank you
for purchasing the Infinity Kappa Series
10.1t tweeter. We’ve organized this manual to make your installa-
tion as simple and trouble-free as possible. Please read it thor-
oughly before proceeding. Remember to keep your sales receipt
with this manual in a safe place so both are available for future
reference.
Download from Www.Somanuals.com. All Manuals Search And Download.
A NOTE ON POWER HANDLING
GENERAL CARE
SPECIFICATIONS
The Kappa 10.1t tweeters are designed to
produce reasonable volume levels with little
amplifier power. However, the addition of
an amplifier to drive your speakers and a
subwoofer will enhance the dynamic range
of your system, and help overcome the
ambient noise in a moving vehicle. Kappa
speakers are designed to handle the power
of a dedicated amplifier driven at or below
its rated power. If an amplifier is driven far
above its rated power, the output signal will
“clip,” and the additional power present in a
clipped signal can damage any speaker.
Distorted or “fuzzy” sound from your
The loudspeaker grilles may be cleaned with a
slightly damp cloth. Do not use any cleaners or
solvents on the grilles or the speaker drivers.
10.1t
Type:
Speaker Impedance:
Power Handling:
ComponentTweeter
4 ohms
50 watts per channel
with crossover
Frequency
Response (± 3dB):
Sensitivity:
Crossover Frequency:
Cut-out DiameterTweeter: 1-5/8" (42 mm)
8kHz ~ 22kHz
89Hz @ 2.83 V, 1 watt
8000Hz
speakers is an indication that the amplifier
has exceeded its rated power, and you
should reduce the volume level.
Figure 3. After the Kappa10.1t tweeter is in its cup,
hand tighten the nut to flush-mount the assembly on
the panel.
NOTE:You must use the crossover supplied
with the 10.1t tweeter.The crossover is con-
tained in the shrink tube attached to the
included speaker wire. If you must shorten
the wire, do not remove the crossover, and
be sure that its orientation is correct (indi-
cated by position of connectors).
DECLARATION OF CONFORMITY
We, Infinity Systems A/S
Kongevejen 194B
DK-3460 Birkerød
DENMARK
declare in own responsibility, that the product described in this owner’s manual is in compliance with technical standards:
EN 50 081-1/1992
Steen Michaelsen
Infinity Systems A/S
Birkerød. DENMARK. 2/98
EN 50 082-1/3.1995
Infinity Systems, Inc. • 250 Crossways Park Drive,
Woodbury, NY 11797 USA • (516) 496-3400 • FAX (516) 682-3583
®
- 3 -
Download from Www.Somanuals.com. All Manuals Search And Download.
|