Hotpoint Ventilation Hood HTN41 User Manual

EN  
Instructions for use  
English, 10  
HTN41  
Download from Www.Somanuals.com. All Manuals Search And Download.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
8
Download from Www.Somanuals.com. All Manuals Search And Download.  
9
Download from Www.Somanuals.com. All Manuals Search And Download.  
English  
The hood can look different to that illustrated in the drawings in this  
booklet. The instructions for use, maintenance and installation, however,  
remain the same.  
Closely follow the instructions set out in this manual. All responsibility, for  
any eventual inconveniences, damages or fires caused by not complying with the  
instructions in this manual, is declined. The extractor hood has been designed  
exclusively for domestic use.  
ELECTRICAL CONNECTION  
EN  
The mains power supply must correspond to the rating indicated on the plate  
situated inside the hood. If provided with a plug connect the hood to a socket in  
compliance with current regulations and positioned in an accessible area, after  
installation. If it not fitted with a plug (direct mains connection) or if the plug is not  
located in an accessible area, after installation, apply a double pole switch in  
accordance with standards which assures the complete disconnection of the  
mains under conditions relating to over-current category III, in accordance with  
installation instructions.  
!
!
!
It is important to conserve this booklet for consultation at any moment. In  
the case of sale, cession or move, make sure it is together with the product.  
Read the instructions carefully: there is important information about  
installation, use and safety.  
Do not carry out electrical or mechanical variations on the product or on the  
discharge conduits.  
Warning! Before re-connecting the hood circuit to the mains supply and  
checking the efficient function, always check that the mains cable is correctly  
assembled.  
Replacing the power cable  
Warning! Power cable replacement must be undertaken by the authorised  
service assistance centre or similar qualified person.  
GENERAL SAFETY  
The minimum distance between the supporting surface for the cooking  
equipment on the hob and the lowest part of the range hood must be not less  
than 50cm from electric cookers and 65cm from gas or mixed cookers.  
If the instructions for installation for the gas hob specify a greater distance, this  
must be adhered to.  
AIR VENT  
(for the suction versions)  
Connect the hood and discharge holes on the walls with a diameter equivalent to  
the air outlet (connection flange).  
Expansion wall plugs are provided to secure the hood to most types of  
walls/ceilings. However, a qualified technician must verify suitability of the  
materials in accordance with the type of wall/ceiling. The wall/ceiling must be  
strong enough to take the weight of the hood. Do not tile, grout or silicone this  
appliance to the wall. Surface mounting only.  
Using the tubes and discharge holes on walls with smaller dimensions will cause  
a diminution of the suction performance and a drastic increase in noise.  
Any responsibility in the matter is therefore declined.  
!
!
!
!
!
!
Use a duct of the minimum indispensible length.  
Use a duct with as few elbows as possible (maximum elbow angle: 90°).  
Avoid drastic changes in the duct cross-section.  
Use a duct with an as smooth as possible inside.  
The duct must be made of certified material.  
WARNING! Do not connect the appliance to the mains until the installation is  
fully complete.  
Before any cleaning or maintenance operation, disconnect hood from the mains  
by removing the plug or disconnecting the mains electrical supply.  
Always wear work gloves for all installation and maintenance operations.  
The appliance is not intended for use by children or persons with impaired  
physical, sensorial or mental faculties, or if lacking in experience or knowledge,  
unless they are under supervision or have been trained in the use of the  
appliance by a person responsible for their safety.  
This appliance is designed to be operated by adults, children should be  
monitored to ensure that they do not play with the appliance.  
This appliance is designed to be operated by adults. Children should not be  
allowed to tamper with the controls or play with the appliance.  
Never use the hood without effectively mounted grating!  
The company declines any responsibility whenever these regulations are  
not respected.  
FILTERING OR DUCTING ?  
!
Your cooker hood is ready to be used in suction version.  
To use the hood in filtering version the special ACCESSORY KIT must be  
installed.  
Check on the first pages of this manual if the ACCESSORY KIT is furnished  
or must be bought separately.  
Note: If furnished, in certain cases, the additional activated carbon filtering  
system may be installed on the hood.  
Information about the conversion of the hood from suction version to filtering  
version is present in this manual.  
The hood must NEVER be used as a support surface unless specifically  
indicated.  
The premises where the appliance is installed must be sufficiently ventilated,  
when the kitchen hood is used together with other gas combustion devices or  
other fuels.  
The ducting system for this appliance must not be connected to any existing  
ventilation system which is being used for any other purpose such as discharging  
exhaust fumes from appliances burning gas or other fuels.  
The flaming of foods beneath the hood itself is severely prohibited.  
The use of exposed flames is detrimental to the filters and may cause a fire risk,  
and must therefore be avoided in all circumstances.  
Any frying must be done with care in order to make sure that the oil does not  
overheat and ignite.  
Accessible parts of the hood may became hot when used with cooking  
appliance.  
Ducting version  
In this case the fumes are conveyed outside of the building by means of a  
special pipe connected with the connection ring located on top of the hood.  
Attention! The exhausting pipe is not supplied and must be purchased apart.  
Diameter of the exhausting pipe must be equal to that of the connection ring.  
In the horizontal runs the exhausting pipe must be slightly slanted (about 10°)  
and directed upwards to vent the air easily from the room to the outside.  
Attention! If the hood is supplied with active charcoal filter, then it must be  
removed.  
Filter version  
One active charcoal filter is needed for this and can be obtained from your usual  
retailer.  
The filter removes the grease and smells from the extracted air before sending it  
back into the room through the upper outlet grid.  
With regards to the technical and safety measures to be adopted for fume  
discharging it is important to closely follow the regulations provided by the local  
authorities.  
The hood must be regularly cleaned on both the inside and outside (AT LEAST  
ONCE A MONTH).  
This must be completed in accordance with the maintenance instructions  
provided in this manual). Failure to follow the instructions provided in this user  
guide regarding the cleaning of the hood and filters will lead to the risk of fires.  
Do not use or leave the hood without the lamp correctly mounted due to the  
possible risk of electric shocks.  
We will not accept any responsibility for any faults, damage or fires caused to the  
appliance as a result of the non-observance of the instructions included in this  
manual.  
10  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Maintenance of the charcoal filter  
CONTROLS  
EN  
It absorbs unpleasant odours caused by cooking.  
The saturation of the charcoal filter occurs after more or less prolonged use,  
depending on the type of cooking and the regularity of cleaning of the grease  
filter.  
In any case it is necessary to replace the cartridge at least every four mounths.  
The charcoal filter may NOT be washed or regenerated.  
Remove the grease filters.  
a. ON/OFF lighting  
b. OFF motors  
c. - d. - e. Minimum suction power (c.), medium (d.), maximum (e.).  
Apply one charcoal filter each side and hook in onto the hood.  
Refit the grease filter.  
MAINTENANCE  
ATTENTION! Before performing any maintenance operation, isolate the hood  
from the electrical supply by switching off at the connector and removing the  
connector fuse.  
Or if the appliance has been connected through a plug and socket, then the plug  
must be removed from the socket.  
Cleaning  
The cooker hood should be cleaned regularly (at least with the same frequency  
with which you carry out maintenance of the fat filters) internally and externally.  
Clean using the cloth dampened with neutral liquid detergent. Do not use  
abrasive products. DO NOT USE ALCOHOL!  
WARNING: Failure to carry out the basic cleaning recommendations of the  
cooker hood and replacement of the filters may cause fire risks.  
Therefore, we recommend observing these instructions.  
The manufacturer declines all responsibility for any damage to the motor or any  
fire damage linked to inappropriate maintenance or failure to observe the above  
safety recommendations.  
Replacing lamps  
Disconnect the hood from the electricity.  
Warning! Prior to touching the light bulbs ensure they are cooled down.  
Access the lamp housing area:  
remove the lamp holder using a small screwdriver or similar tool as a lever.  
Replace the damaged light bulb.  
Use only 40W max (E14) olive shape light bulbs.  
Then close the lamp housing (snap lock).  
Maintenance of the anti-grease filters  
Traps cooking grease particles.  
Paper filter must be replaced once a month or if colouring appears on upper  
side, in such cases the colouring is evident through the grill openings.  
To access the grease filter R open the suction grill S via the release hooks T and  
free from the supports U.  
11  
Download from Www.Somanuals.com. All Manuals Search And Download.  
LI2YMD  
06/2011  
DISPOSAL  
EN  
This appliance is marked according to the European directive 2002/96/EC on  
Waste Electrical and Electronic Equipment (WEEE). By ensuring this product is  
disposed of correctly, you will help prevent potential negative consequences for  
the environment and human health, which could otherwise be caused by  
inappropriate waste handling of this product.  
The symbol  
on the product, or on the documents accompanying the  
product, indicates that this appliance may not be treated as household waste.  
Instead it should be taken to the appropriate collection point for the recycling of  
electrical and electronic equipment. Disposal must be carried out in accordance  
with local environmental regulations for waste disposal.  
For further detailed information regarding the process, collection and recycling of  
this product, please contact the appropriate department of your local authorities  
or the local department for household waste or the shop where you purchased  
this product.  
MALFUNCTIONS  
If something appears not to be working properly, do the following simple checks  
before calling Technical Service:  
If the hood is not working:  
Check that:  
- The power has not been disconnected.  
- A speed has been selected.  
If the hood performs inefficiently:  
Check that:  
- The motor speed selected is sufficient for the amount of smoke and  
vapours released.  
- The kitchen is sufficiently ventilated to allow air intake.  
- The charcoal filter is not worn (hood in filtering version).  
If the hood has turned off during normal functioning:  
Check that:  
- The power has not been disconnected.  
- the omnipolar disconnection device has not tripped.  
If the hood fails to operate correctly, briefly disconnect it from the mains power  
supply for almost 5 sec. by pulling out the plug. Then plug it in again and try once  
more before contacting the Technical Assistance Service.  
TECHNICAL DATA  
Model HTN41  
Height 40 cm  
Width 59,9 cm  
Depth 27- 48 cm  
Gross weight: 9,9 Kg  
Total absorption 140 W  
Motor absorption 100 W  
Lamp absorption 1x40 W (E14)  
Exhaust pipe Ø 12 cm  
This appliance conforms to the following EEC Directive:  
“Low Voltage Equipment” Directive 2006/95/EC (12-12-2006)  
Electromagnetic Compatibility” Directive 2004/108/EC (15-12-2004)  
Components not provided with the product  
12  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Graco Inc Pressure Washer 247549 User Manual
Grandstream Networks Telephone Accessories 486 User Manual
Grizzly Power Roller T25100 User Manual
Harbor Freight Tools Pressure Washer 67596 User Manual
Harbor Freight Tools Work Light 92043 User Manual
Honeywell TV Mount 46 00911 User Manual
HP Hewlett Packard Electric Heater 11744195 User Manual
HP Hewlett Packard Switch AA RSB6B TE User Manual
Husqvarna Tiller 650CRT User Manual
Hyundai IT Computer Monitor U90P User Manual