High Gain Omni Directional
Antenna User Guide
Honeywell
Industrial Measurement and Control
2500 W. Union Hills Drive
Phoenix AZ, 85927
34-XY-25-10
Rev 4
0806
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
Table of Contents
2.1. Package Contents ..................................................................................................................................................................3
2.2. Antenna & Lightning Arrestor Connection........................................................................................................................4
INSTALLING THE HIGH GAIN ANTENNA.......................................................................................................... 6
3.1. Package Contents ..................................................................................................................................................................6
3.2. Antenna Connection..............................................................................................................................................................7
Rev. 4
0806
User Manual
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
Rev. 4
0806
User Manual
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
1. About the High Gain Omni Directional
Antenna
High gain and remote antennas can increase the transmission distance of the
Honeywell Wireless Sensors. For even greater transmission distance, a high gain
directional antenna (Yagi) may be purchased as an integral part of a field unit.
Any Base Radio with an Omni Directional antenna is for
ordinary locations only.
This manual will guide you through the steps to connect a High Gain Omni
Directional Antenna with or without a lightning arrestor to a Base Radio. If you
are using a lightning arrestor, go to section 2. If you are not using a lightning
arrestor, go to section 3.
The following model numbers are covered in this guide. Both Base Radios
models can be used with any of the High Gain Remote Antenna models below.
Antennas
Description
HBW-00-TE-HA-9X
NEMA 4X Base Radio w/10 ft cable, RS-485 & Modbus, for rmt
antenna with Omni Directional 6 dBd Pole remote antenna
HBW-00-TE-HB-9X
HBW-00-TE-HC-9X
NEMA 4X Base Radio w/10 ft cable, RS-485 & Modbus, for rmt
antenna with Omni 6 dBd remote antenna w/lightning arrestor & 10 ft
cable
NEMA 4X Base Radio w/10 ft cable, RS-485 & Modbus, for rmt
antenna with Omni 6 dBd remote antenna w/lightning arrestor & 25 ft
cable
HBW-00-TW-HA-9X
HBW-00-TW-HB-9X
NEMA 4X Base Radio w/25 ft cable, RS-485 & Modbus, for rmt
antenna with Omni Directional 6 dBd Pole remote antenna
NEMA 4X Base Radio w/25 ft cable, RS-485 & Modbus, for rmt
antenna with Omni 6 dBd remote antenna w/lightning arrestor & 10 ft
cable
HBW-00-TW-HC-9X
NEMA 4X Base Radio w/25 ft cable, RS-485 & Modbus, for rmt
antenna with Omni 6 dBd remote antenna w/lightning arrestor & 25 ft
cable
Rev. 4
0806
User Manual
1
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
Rev. 4
0806
User Manual
2
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
2. Installing the High Gain Antenna with the
Lightning Arrestor
This section will show you how to install the high gain antenna with the
lightning arrestor. If you are not using the lightning arrestor, go to Section 3. For
additional information about the Base Radio see the Base Radio User Manual.
Any of the Base Radio model numbers mentioned in section 1 may be used with
the following remote antenna models:
WBH-00-TE-HB-9X Omni 6 dBd remote antenna w/lightning arrestor &
10 ft cable
WBH-00-TE-HC-9X Omni 6 dBd remote antenna w/lightning arrestor &
25 ft cable
WBH-00-TW-HB-9X Omni 6 dBd remote antenna w/lightning arrestor &
10 ft cable
WBH-00-TW-HC-9X Omni 6 dBd remote antenna w/lightning arrestor &
25 ft cable
2.1. Package Contents
The high gain Omni 6 dBd antenna with the lightning arrestor kit comes
complete with:
[1]
[2]
[3]
High gain antenna pole
2 Mounting brackets for the high gain antenna
Lightning arrestor assembly consisting of lightning arrestor and 10’ of 10
AWG ground wire
[4]
Coaxial cable assembly attached to the lightning arrestor:
10’ length for the WBH-00-TE-HB-9X and WBH-00-TW-HB-9X
25’ length for the WBH-00-TE-HC-9X and WBH-00-TW-HC-9X
Waterproofing material for the antenna coaxial connection
[5]
The following comes attached to the Base Radio:
[6]
Coaxial cable assembly:
10’ length for the WBH-00-TE-HB-9X and WBH-00-TE-HC-9X
25’ length for the WBH-00-TW-HB-9X and WBH-00-TW-HC-9X
Rev. 4
0806
User Manual
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
2.2. Antenna & Lightning Arrestor Connection
Attention!
For installation in
ordinary locations
only.
Antenna Connected to Lightning Arrestor and Base Radio
Rev. 4
0806
User Manual
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
Warning: Always use caution when installing this antenna. You can be
seriously injured if this antenna comes near or in contact with a power line.
Follow all local and national electrical code requirements when installing the
Base Radio with the high gain antenna.
[1]
Select the locations for the high gain antenna, the lightning arrestor and
Base Radio.
Any Base Radio with an Omni Directional antenna is for
ordinary locations only.
It is recommended that the lightning arrestor be mounted in close
proximity to the building egress. The lightning arrestor should be
mounted indoors unless you have the weatherproof enclosure.
The location for the high gain antenna should be selected based on
optimal positioning for RF communications with the field units and allow
for sufficient length of coaxial cable to reach the building egress.
The Base Radio should be installed in a location where there is sufficient
coaxial cable available to reach the building egress.
[2]
[3]
Position the antenna so that the gold sleeve clears any obstructions.
Mount the antenna using the
2 mounting brackets. One
clamp must be placed at the
center of the gold sleeve, the
other at any point below.
[4]
[5]
Connect the Base Radio coaxial cable to the lightning arrestor and tighten
by hand.
Attach the ground wire to a suitable earth ground connection. Keep this
wire as short as possible. Make sure this connection conforms to
electrical code requirements.
[6]
[7]
Connect the lightning arrestor coaxial cable to the antenna and hand
tighten.
Install a drip loop in the cable to insure proper drainage.
[8] Wrap the antenna connection with the supplied waterproofing material.
Note: Do not cover the drain holes on the bottom of the antenna as they
provide drainage for moisture.
[9]
Finished.
Rev. 4
0806
User Manual
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
3. Installing the High Gain Antenna
This section will show you how to install the high gain antenna without a
lightning arrestor. If you are using a lightning arrestor, go to section 2. For
additional information about the Base Radio see the Base Radio User Manual.
This configuration is for indoor use only. If you are mounting
the antenna outdoors, a lightning arrestor must be used.
Any of the Base Radio model numbers mentioned in section 1 may be used with
the following remote antenna model:
WBH-00-TE-HA-9X Omni Directional 6 dBd Pole remote antenna
WBH-00-TW-HA-9X Omni Directional 6 dBd Pole remote antenna
3.1. Package Contents
The high gain Omni 6 dBd antenna kit comes complete with:
[1]
[2]
[3]
High gain antenna pole
2 Mounting brackets for the high gain antenna
Waterproofing material for the antenna coaxial connection
The following comes attached to the Base Radio:
[4]
Coaxial cable assembly:
10’ length for the WBH-00-TE-HA-9X
25’ length for the WBH-00-TW-HA-9X
Rev. 4
0806
User Manual
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
Warning: Always use caution when installing this antenna. You can be
seriously injured if this antenna comes near or in contact with a power line.
Follow all local and national electrical code requirements when installing the
Base Radio with the high gain antenna.
[1]
Select the locations for the high gain antenna and Base Radio. The
location for the high gain antenna should be selected based on optimal
positioning for RF communications with the field units.
Any Base Radio with an Omni Directional antenna is for
ordinary locations only.
[2]
[3]
Position the antenna so that the gold sleeve clears any obstructions.
Mount the antenna using the
2 mounting brackets. One
clamp must be placed at the
center of the gold sleeve, the
other at any point below.
[4]
[5]
Connect the Base Radio coaxial cable to the antenna and hand tighten.
Wrap the connection with the supplied waterproofing material.
Note: Do not cover the drain holes on the bottom of the antenna as they
provide drainage for moisture.
[6]
Finished.
Rev. 4
0806
User Manual
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
4. Technical Specifications
Base Radio High Gain Omni Directional Antenna
Length
65”
Gain
6 dBd (less cable loss ≈ 0.04 dBd/ft)
Weight
6 lbs
Polarization
Vertical
Mounting
Heavy wall gold anodized 1 ¼” aluminum with brackets included
10’ or 25’
Base Radio coaxial cable length
Rev. 4
0806
User Manual
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Honeywell Industrial Wireless
High Gain Omni-Directional Antenna
Mounting Bracket Dimensioned Drawing
Rev. 4
0806
User Manual
10
Download from Www.Somanuals.com. All Manuals Search And Download.
Download from Www.Somanuals.com. All Manuals Search And Download.
*17414*
Honeywell
Industrial Measurement and Control
2500 W. Union Hills Drive
Phoenix AZ, 85927
Download from Www.Somanuals.com. All Manuals Search And Download.
|