| 	
		 HAMBURGER PRESS   
					Model 93414   
					ASSEMBLY AND OPERATING INSTRUCTIONS   
					® 
					3491 Mission Oaks Blvd., Camarillo, CA 93011   
					
					Copyright© 2005 by Harbor Freight Tools®. All rights reserved. No portion of this   
					manual or any artwork contained herein may be reproduced in any shape or form   
					without the express written consent of Harbor FreightTools.   
					For technical questions and replacement parts, please call 1-800-444-3353   
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				10. Check for damaged parts. Before using the Hamburger Press, any part that   
					appears damaged should be carefully checked to determine that it will operate   
					properly and perform its intended function. Check for alignment and binding of   
					moving parts; any broken parts or mounting fixtures; and any other condition   
					that may affect proper operation. Any part that is damaged should be properly   
					repaired or replaced by a qualified technician.   
					11. Do not operate Hamburger Press if under the influence of alcohol or   
					drugs. Read warning labels on prescriptions to determine if your judgment   
					or reflexes are impaired while taking drugs. If there is any doubt, do not   
					operate the Hamburger Press.   
					12. Clean thoroughly. Clean before and after each use. Wash in the   
					dishwasher in warm water, with antibacterial soap. After cleaning, dry all of   
					the components and store in a dry location.   
					Warning:The warnings, cautions, and instructions discussed in this instruction   
					manual cannot cover all possible conditions and situations that may occur. It   
					must be understood by the operator that common sense and caution are factors   
					which cannot be built into this product, but must be supplied by the operator.   
					Unpacking   
					When unpacking, check to make sure the parts listed on page 5 are included. If   
					any parts are missing or broken, please call Harbor Freight Tools at the number   
					on the cover of this manual.   
					SKU 93414   
					Page 3   
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				Operation   
					Warning! To avoid health hazards, thoroughly wipe off Hamburger Press parts   
					with a clean rag. Then, clean all of the parts in a dishwasher using hot or warm   
					water, and an antibacterial soap. Always follow this procedure before and after   
					each use. Failure to follow these precautions may result in serious injury due to   
					food poisoning.   
					1. Weigh out or approximate 1/4 to 1/3 Lb. of ground meat.   
					2. The distance between the Middle Plate (#4) and the Upper Base (#3)   
					determines the thickness of the patty. To make the thickest patty (1/2”), leave the   
					Middle Plate (#4) flush against the Upper Base (#3). For a thinner patty, loosen   
					the Nut (#2) and lower the Middle Plate (#4) to achieve the desired thickness.   
					Tighten the Nut (#2).   
					3. Lift the tab on the Upper Base (#3).   
					4. Roll the beef into a ball and place it squarely on the center of the   
					Lower Base (#5).   
					5. Lower the tab on the Upper Base (#3) and gently press down.   
					Note: The meat might stick to the Lower Base (#5) or the Middle Plate (#4), depending   
					on the fat content of the meat. Try spraying both parts with a light coat of vegetable   
					oil prior to pressing.   
					Maintenance   
					1. Disassemble by turning the Nut (#2) counterclockwise to loosen, Remove the   
					Upper Base (#3) and the Middle Plate (#4).   
					2. Clean as per the instructions in the above Warning.   
					3. Dry thoroughly with a clean dishcloth.   
					4. If you store the Hamburger Press for extended periods of time, spray a light   
					coating of vegetable oil on it and wrap it in a plastic bag,   
					SKU 93414 Download from Www.Somanuals.com. All Manuals Search And Download.   
					Page 4   
				Assembly Drawing   
					1 
					2 
					3 
					Parts List   
					Part No.   
					Description   
					1 
					2 
					3 
					4 
					5 
					6 
					Cap   
					Nut   
					Upper Base   
					Middle Plate   
					Lower Base   
					Bolt   
					4 
					6 
					5 
					SKU 93414   
					Page 5   
					Download from Www.Somanuals.com. All Manuals Search And Download.   
				 | 
Grizzly Saw G8994 User Manual
Harman Kardon Flat Panel Television RCP 5 User Manual
Harman Kardon Home Theater System SB15 230 User Manual
Havis Shields Automobile Accessories KK K9 F12 K User Manual
HP Hewlett Packard Network Card YELLOWJACKET PLUS User Manual
HP Hewlett Packard Power Supply Power Management System User Manual
Hubbell Work Light UE24 User Manual
Hughes Network Router R BGAN User Manual
Husqvarna Chainsaw 952802154 User Manual
IKEA Oven IBS550PWS00 User Manual