MODEL T25448/T25449
DUST COLLECTOR
REMOTE SWITCH
INSTRUCTIONS
For questions or help with this product contact Tech Support at (570) 546-9663 or [email protected]
Introduction
The Model T25448/T25449 Dust Collector
Remote Switch (Figure 1) allows you to remotely
turn a dust collector ON/OFF from a distance of
up to 75 feet.
To ensure safe operation:
• Only connect the switch box to power sup-
ply that meets the listed specifications.
• Do not connect the switch box to a dust
collector with a motor that exceeds the
listed specifications.
Read and understand this entire document before
installation to make sure this switch box fits the
intended application.
Switch
box
• This remote switch is ONLY designed to
be used on dust collectors with standard
ON/OFF toggle or push-button switches—
not with magnetic switches.
• If you are unsure about the type of dust
collector switch you have, contact the dust
collector manufacturer for more informa-
tion.
Remote
Controller
• Using this switch box for applications
other than dust collectors may cause the
unit to fail and will void the warranty.
Figure 1. Model T25448/T25449 remote switch
components.
Specifications
Model T25448:
Replacement remote controllers (Model
T25507) can be purchased by contacting
Grizzly at (800) 523-4777. Before the new
remote controller can be used, the switch
box must be programmed to work with it
(refer to Programming Switch Box on Page
2 for detailed instructions).
Power Supply ....................120V, 15a, 60 Hz
Outlet Type .................................NeMa 5-15
Max. Dust Collector HP..................... 1.5 HP
Model T25449:
Power Supply ................... 240V, 20a, 60 Hz
Outlet Type .................................NeMa 6-20
Max. Dust Collector HP........................ 3 HP
Remote battery ..........................Type 23ae, 12V
Communication Type........Radio Frequency (RF)
Max. Communication Distance ................... 75 ft.
COPYRIGHT © FebRuaRY, 2013 bY GRIZZLY INDuSTRIaL, INC.
NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE
OR FORM WITHOUT THE WRITTEN APPROVAL OF GRIZZLY INDUSTRIAL, INC.
FOR MODeLS MaNuFaCTuReD SINCe 8/13 #TS15583 PRINTeD IN TaIwaN
Download from Www.Somanuals.com. All Manuals Search And Download.
4. Press either button on the remote controller
(see Figure 5)—you will hear three beeps
and the red receiving light on the switch box
will flash three times.
Operation
1. Make sure the switch box is properly installed
and correctly programmed with the remote
controller.
2. Turn the dust collector ON/OFF switch to ON.
Sliding
Cover
ON button
3. Press the remote controller ON button once
to turn the dust collector ON. The green
power light on the switch box will also illumi-
nate (see Figure 6).
OFF button
Figure 5. Remote controller buttons.
Green
Power
Light
5. wait approximately five seconds and you will
hear another beep—the switch box is now
programmed to work with this remote control-
ler.
Figure 6. Green power light on switch box.
4. Press the remote controller OFF button once
to turn the dust collector OFF. The green
power light on the switch box will turn OFF.
Un-programming Switch Box
If necessary, the switch box can be un-pro-
grammed so that it will not operate with any
remote controller. In such case, you will have
to re-program the switch box to operate with a
remote controller.
To un-program the switch box:
1. Press and hold the black programming but-
ton on the switch box for approximately five
seconds—you will hear one long beep and
the red receiving light will flash once.
2. The switch box is now un-programmed.
-3-
Model T25448/T25449 (Mfg. Since 8/13)
Download from Www.Somanuals.com. All Manuals Search And Download.
Troubleshooting
Review the troubleshooting and procedures in this subsection if a problem develops. If you need additional
help with a procedure, call our Technical Support at (570) 546-9663.
Note: Please gather the serial number and manufacture date of your switch before calling.
Symptom
Possible Cause
Possible Solution
Switch box will not
turn ON.
1. Switch box not connected to power.
1. Connect switch box to correct power source (Page 2).
2. Remote controller not properly programmed 2. Properly program remote controller to operate switch
to operate switch.
(Page 2).
3. Remote controller battery weak/dead.
4. Switch box circuit breaker has tripped.
3. Replace remote controller battery (this page).
4. Press the circuit breaker reset button on rear of
switch.
5. Remote controller is out of range with 5. Operate the remote controller within 75 ft. of the
switch.
switch.
6. wall circuit breaker has tripped.
6. Reset wall circuit breaker. Make sure breaker is in
good condition and circuit is properly sized for dust
collector in use.
7. Remote controller/switch at fault.
7. Test/replace.
Dust collector will
not turn ON.
1. Dust collector ON/OFF switch not turned 1. Turn dust collector ON/OFF switch ON.
ON.
2. Dust collector not connected to switch box. 2. Properly connect dust collector to switch box
(Page 2).
3. Switch box not connected to power.
4. wall circuit breaker has tripped.
3. Connect switch box to correct power source (Page 2).
4. Reset wall circuit breaker. Make sure breaker is in
good condition and circuit is properly sized for dust
collector in use.
5. Dust collector at fault.
5. Refer to dust collector manual for troubleshooting;
contact dust collector manufacturer for technical
help.
Replacing Remote Controller Battery
The remote controller is independently powered
by a Type 23ae, 12V internal battery. If the switch
box stops responding to the remote controller,
replace the battery as the first course of resolu-
tion.
To replace the remote controller battery:
1. Place the remote controller upside down on a
stable, protective surface.
Figure 7. Remote controller components.
2. use a #00 Phillips screwdriver to remove the
three screws that secure the components
together.
4. Replace the battery, then re-assemble the
remote controller.
3. Carefully separate the covers, circuit board,
and battery, as shown in Figure 7.
-4-
Model T25448/T25449 (Mfg. Since 8/13)
Download from Www.Somanuals.com. All Manuals Search And Download.
|