Graco Inc Power Roller 243066 User Manual

Operating Instructions  
309047  
Rev. A  
This manual contains important  
warnings and information.  
READ AND KEEP FOR REFERENCE.  
INSTRUCTIONS  
Pressure Roller  
Model 243066, Series A  
D 20 in. (50 cm) heavy-duty extension  
D 45_ swivel adapter  
D 9 in. (23 cm) roller frame  
D 1/2 in. (13 mm) nap roller cover  
3600 psi (24.8 MPa, 248 bar) Maximum Fluid Inlet Pressure  
*
This maximum pressure is only possible if the roller frame is  
completely plugged. The best operating pressure is the lowest  
pressure that provides an even paint supply to the roller and  
typically does not exceed 300 psi (2.1 MPa, 21 bar).  
*
9593A  
Airless spray  
gun not included  
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 55440–1441  
ECOPYRIGHT 2000, GRACO INC.  
Graco Inc. is registered to I.S. EN ISO 9001  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Flushing  
This is the procedure for flushing the pressure roller.  
The pump and gun you are using may have additional  
flushing steps, such as cleaning filters and screens.  
See the pump and gun flushing instructions.  
Parts Drawing  
Pressure Roller,  
Model 243066, Series A  
NOTE: Leave the pressure roller attached to the gun  
for this procedure.  
diffuser  
retaining nut  
6
See Pressure Relief  
Procedure on page 2.  
1
2
1. Relieve the pressure.  
2. Remove roller cover (6) and diffuser from roller  
frame as follows (see Parts Drawing at right):  
3
a. Hold roller cover, and unscrew retaining nut.  
b. Slide diffuser and roller cover off of roller fame.  
c. Pull roller cover off of diffuser.  
3. Clean roller cover with compatible fluid, and clean  
diffuser by shaking vigorously in pail of compatible  
fluid to remove wet paint. Use soft bristled brush to  
remove any dried paint on diffuser.  
4
5
4. Place roller frame (1) in empty waste pail.  
5. Prime pump with flushing fluid compatible with  
paint you are using, and use the lowest pressure  
setting at which pump primes.  
6. Put pump prime/drain valve in position that  
delivers fluid to hose.  
NOTE: Perform Step 7 at the lowest pressure  
possible.  
2
3
7
7. Trigger gun until flushing fluid coming out of roller  
2*  
3*  
frame is relatively clear.  
9593A  
8. Shut off the pump, and relieve the pressure.  
HINT:  
9. To prevent corrosion, lubricate paint holes in roller  
frame with lightweight oil that does not contain  
silicone.  
When replacing gasket (2*) and  
o-ring (3*) in swivel adapter (7),  
position o-ring first, then press  
gasket into place.  
Storage  
If you are going to store the airless equipment for an  
extended period of time after flushing with water-base  
fluid, flush again with Graco Pump Armor or mineral  
spirits/paint thinner. Leave the fluid in the system  
during storage.  
Parts List  
Ref.  
No.  
Part No. Description  
Qty.  
1
2
3
4
240005  
162863  
114049  
232122  
195804  
107590  
FRAME, roller; 9 in. (23 cm)  
GASKET, non-metallic  
PACKING, o-ring  
TUBE, extension; 20 in. (50 cm)  
LABEL, warning  
1
3
3
1
1
Additional Roller Covers  
The following pressure roller covers are available at  
your local distributor:  
5Y  
6
COVER, roller;  
107589  
107590  
107591  
107592  
9 in. (23 cm); 3/8 in. (9.5 mm) nap  
9 in. (23 cm); 1/2 in. (13 mm) nap  
9 in. (23 cm); 3/4 in. (19 mm) nap  
9 in. (23 cm); 1-1/4 in. (32 mm) nap  
9 in. (23 cm); 1/2 in. (13 mm) nap 1  
7
224399  
ADAPTER, 45_ swivel  
1
Y Call 1–800–328–0211 for free extras.  
309047  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
Graco Warranty  
Graco warrants all equipment manufactured by Graco and bearing its name to be free from defects in material and workmanship on the  
date of sale by an authorized Graco distributor to the original purchaser for use. With the exception of any special, extended, or limited  
warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment  
determined by Graco to be defective. This warranty applies only when the equipment is installed, operated and maintained in  
accordance with Gracos written recommendations.  
This warranty does not cover, and Graco shall not be liable for general wear and tear, or any malfunction, damage or wear caused by  
faulty installation, misapplication, abrasion, corrosion, inadequate or improper maintenance, negligence, accident, tampering, or  
substitution of non-Graco component parts. Nor shall Graco be liable for malfunction, damage or wear caused by the incompatibility of  
Graco equipment with structures, accessories, equipment or materials not supplied by Graco, or the improper design, manufacture,  
installation, operation or maintenance of structures, accessories, equipment or materials not supplied by Graco.  
This warranty is conditioned upon the prepaid return of the equipment claimed to be defective to an authorized Graco distributor for  
verification of the claimed defect. If the claimed defect is verified, Graco will repair or replace free of charge any defective parts. The  
equipment will be returned to the original purchaser transportation prepaid. If inspection of the equipment does not disclose any defect  
in material or workmanship, repairs will be made at a reasonable charge, which charges may include the costs of parts, labor, and  
transportation.  
THIS WARRANTY IS EXCLUSIVE, AND IS IN LIEU OF ANY OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING BUT  
NOT LIMITED TO WARRANTY OF MERCHANTABILITY OR WARRANTY OF FITNESS FOR A PARTICULAR PURPOSE.  
Gracos sole obligation and buyers sole remedy for any breach of warranty shall be as set forth above. The buyer agrees that no other  
remedy (including, but not limited to, incidental or consequential damages for lost profits, lost sales, injury to person or property, or any  
other incidental or consequential loss) shall be available. Any action for breach of warranty must be brought within two (2) years of the  
date of sale.  
Graco makes no warranty, and disclaims all implied warranties of merchantability and fitness for a particular purpose in connection  
with accessories, equipment, materials or components sold but not manufactured by Graco. These items sold, but not manufactured  
by Graco (such as electric motors, switches, hose, etc.), are subject to the warranty, if any, of their manufacturer. Graco will provide  
purchaser with reasonable assistance in making any claim for breach of these warranties.  
In no event will Graco be liable for indirect, incidental, special or consequential damages resulting from Graco supplying equipment  
hereunder, or the furnishing, performance, or use of any products or other goods sold hereto, whether due to a breach of contract,  
breach of warranty, the negligence of Graco, or otherwise.  
FOR GRACO CANADA CUSTOMERS  
The parties acknowledge that they have required that the present document, as well as all documents, notices and legal proceedings  
entered into, given or instituted pursuant hereto or relating directly or indirectly hereto, be drawn up in English. Les parties  
reconnaissent avoir convenu que la rédaction du présente document sera en Anglais, ainsi que tous documents, avis et procédures  
judiciaires exécutés, donnés ou intentés à la suite de ou en rapport, directement ou indirectement, avec les procedures concernées.  
ADDITIONAL WARRANTY COVERAGE  
Graco does provide extended warranty and wear warranty for products described in the Graco Contractor Equipment Warranty  
Program.  
Graco Phone Number  
TO PLACE AN ORDER, contact your Graco distributor, or call this number to identify the distributor closest to you:  
18006902894 Toll Free  
All written and visual data contained in this document reflect the latest product information available at the time of publication.  
Graco reserves the right to make changes at any time without notice.  
Sales Offices: Minneapolis, Detroit  
Foreign Offices: Belgium, Korea, Hong Kong, Japan  
GRACO INC. P.O. BOX 1441 MINNEAPOLIS, MN 554401441  
PRINTED IN USA 309047 02/2000  
4
309047  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Haier Microwave Oven HIL 2810EGCB User Manual
Haier Washer HWM70 A User Manual
Hamilton Beach Slow Cooker 840149601 User Manual
HANNspree Flat Panel Television 1506 0B86000 User Manual
Hans Grohe Car Video System HL190 User Manual
Hotpoint Clothes Dryer NBXR333 User Manual
HP Hewlett Packard Computer Drive 418408 B21 User Manual
HTC Cell Phone EVO Shift 4G User Manual
IBM Fan DB2 9 User Manual
IBM Laptop 510Cs User Manual