JBS15M
GE® 30" Free-Standing Electric Range
Dimensions and Installation Information (in inches)
KW Rating
10.2
7.7
240V
208V
30-7/8"
29-7/8
Breaker Size
All 30" GE gas and electric range backguards
are 30-7/8" wide.*
40 Amps†
Note: 30" ranges conform to U.L. requirements
for 0" spacing from adjacent walls below
46-1/4
†
Note: Check local codes for required breaker size.
countertops. To reduce possible scorching of
walls, engineering recommends a minimum of
1-1/2" spacing to allow for possible extended,
high heat, no-load heating element operation.
Effective January 1, 1996, the National Electrical
Code requires that new construction (not existing)
utilize a 4-conductor connection to an electric range.
Receptacle Locations: Locally approved flexible
service cord or conduit must be used because
terminals are not accessible after range installation.
See shaded area in drawing for location of electrical
outlet box. Recommended outlet locations allow
range to be installed directly against wall.
*Except these models: JGBS07, JGBS04, JGBP90,
all GE Profile free-standing electric and gas
ranges
Fits most countertop backsplash applications.
Consult Use & Care Manual for detailed
installation instructions.
26-1/4*
46-1/4
Note: 30" ranges conform to U.L. requirements for
0" spacing from adjacent walls below countertops.
To reduce possibility of scorching walls, engineering
recommends a minimum of 1-1/2" spacing to allow
for possible extended, high-heat, no-load heating
element operation.
*Dimension from wal
of closed door hand
7-1/2
7
7-1/2
5
3-1/2
2-1/4
REAR
WALL
Installation information: Before installing, consult
installation instructions packed with product for
current dimensional data.
2-1/4
CENTER LINE
For answers to your Monogram,® GE Profile™ or
GE® appliance questions, visit our website at
ge.com or call GE Answer Center® service,
800.626.2000.
*Dimension from wall to front of closed door handle is 27-3/4".
All GE ranges are equipped with
an Anti-Tip device. The installation
Listed by
of this device is an important,
required step in the installation
of the range.
Underwriters
Laboratories
Specification Revised 10/08
322037
Download from Www.Somanuals.com. All Manuals Search And Download.
|