V7867
Please keep this instruction sheet for future reference,
as it contains important information.
Requires six “AAA” (LR03) alkaline batteries (not included) for operation.
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included)
Wipe with a clean, damp cloth. Do not immerse the vehicle or remote controller.
Actual product may appear different than the photos shown.
Download from Www.Somanuals.com. All Manuals Search And Download.
Table Assembly
CAUTION
This product contains small parts in an
unassembled state. Adult assembly is required.
Table Leg
Table Leg
Table Top
3
•Lay a table top with the bottom side up on a flat surface.
•Fit the leg assembly into the grooves in the table top.
Leg Supports
1
•Fit the leg supports into the slots in each table leg.
Hint: The leg supports are designed to fit onto the table
legs one way. If a leg support does not seem to fit, turn it
around and try again!
4
•Insert six screws into the holes in the leg assembly
and tighten.
•Repeat steps 1-4 to assemble the other two tables.
2
•Insert two screws into each leg support and tighten.
Storage
Drawer
5
•Slide the storage drawer into the grooves in a
storage table.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Track Setup
Long Guard
Rail
Curved Ramp
Track
1
•Fit the long guard rail onto a curved ramp track,
as shown.
5
•Fit two more bridge supports onto the bridge assembly,
as shown.
"Y" Support
Bridge Rails
2
•Fit the “Y” support onto the bottom of the curved
ramp track.
Curved
Track
Short
Guard
Rail
6
3
•Fit the bridge rails to the top of the bridge assembly.
•“Snap” the short guardrails onto the curved tracks.
Bridge Track
7
•Track pieces easily snap together.
Bridge Supports
4
•Fit the bridge track onto two bridge supports, as shown.
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Table Layouts
Slide a smooth side of a table onto any tabbed side of another
table to create the table layouts below!
Track Layout
Curved Bridge
Track
Curved Track
with Guard Rail
Ramp
Track
Crane
Bridge
Assembly
Curved Track
Long Straight
Track
Curved Tracks
Long Straight
Track
"Y" Tracks
Easy Load Track
Short
Straight
Track
Long Straight
Track
Curved Ramp
Assembly
Long Straight
Tracks
Curved Track
with Guard Rail
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Battery Installation Battery Safety
We recommend the use of alkaline batteries for longer battery life.
Information
1,5V x 6
“AAA” (LR03)
In exceptional circumstances, batteries may leak
fluids that can cause a chemical burn injury or ruin
your toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of
different types: alkaline, standard
• Locate the battery compartment on the back of
(carbon-zinc) or rechargeable (nickel-cadmium).
the vehicle.
• Insert batteries as indicated inside the
• Loosen the screws in the battery compartment door
battery compartment.
with a Phillips screwdriver. Lift the battery compartment
• Remove batteries during long periods of non-use.
door and insert three “AAA” (LR03) alkaline batteries.
Always remove exhausted batteries from the toy.
• Close the battery compartment door and tighten the
Dispose of batteries safely. Do not dispose of this
screws with a Phillips screwdriver. Do not over-tighten.
product in a fire. The batteries inside may explode
• If the vehicle begins to operate erratically, you may
or leak.
need to reset the electronics. Remove the batteries and
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type,
as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy
before charging.
replace them in the vehicle.
IMPORTANT! Under normal use conditions, the batteries
in the vehicle will require replacement more often than
the batteries in the remote controller. For additional
information, refer to the troubleshooting section.
• If removable, rechargeable batteries are used, they are
only to be charged under adult supervision.
ICES-003
• This Class B digital apparatus complies with
Canadian ICES-003.
• Operation is subject to the following two conditions: (1) this
device may not cause harmful interference and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
NMB-003
• Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
Remote Controller
• Locate the battery compartment on the bottom of the
remote controller.
• L’utilisation de ce dispositif est autorisée seulement
aux conditions suivantes : (1) il ne doit pas produire de
brouillage et (2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique reçu, même
si ce brouillage est susceptible de compromettre le
fonctionnement du dispositif.
• Loosen the screw in the battery compartment door with
a Phillips screwdriver. Remove the battery compartment
door and insert three “AAA” (LR03) alkaline batteries.
• Replace the battery compartment door and tighten the
screw with a Phillips screwdriver. Do not over-tighten.
• If the remote controller begins to operate erratically,
you may need to reset the electronics. Remove the
batteries and replace them in the remote controller.
• Protect the environment by not disposing of
this product with household waste (2002/96/
EC). Check your local authority for recycling
advice and facilities (Europe only).
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Troubleshooting
All Aboard!
Hint: We do not recommend using the vehicle on carpets.
PROBLEM
SOLUTION
For best performance, use on hard, flat surfaces.
Vehicle drives slowly
Battery power in the vehicle may be
weak. Replace all three batteries in the
vehicle with new, alkaline batteries.
POWER BUTTON
READY LIGHT
The wheels on the vehicle may be dirty.
Wipe them with a clean cloth.
Vehicle does not
respond to the
remote controller
Battery power in the remote controller
may be weak. Replace all three
batteries in the remote controller with
new, alkaline batteries.
You may be beyond the maximum
range of the remote controller which is
about 12 feet (3,6 m).
You may not have a clear path
between the remote controller and
the vehicle. This toy works best when
there are no obstructions between the
vehicle and the remote controller.
1
Bright sunlight or fluorescent lights
may affect the range of the remote
controller. Try dimming the room you
are playing in.
• Press the power button on top of the vehicle. The ready
light turns on.
The vehicle may have shut off. If you
do not operate the remote controller
for a few minutes, the vehicle shuts
off automatically and the ready light
turns off. Press the power button on
the vehicle, and operate the remote
controller to restart.
1 FORWARD
2
3
STOP
REVERSE
1
2
3
2
• Point the antenna of the remote controller toward the
vehicle and push the stick forward. The vehicle
moves forward.
• Pull the stick all the way back and the vehicle travels in
reverse. Release the stick to stop.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Consumer Information
FCC Statement (United States Only)
TNCE
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or
more of the following measures:
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Note: Changes or modifications not expressly approved
by the manufacturer responsible for compliance could
void the user’s authority to operate the equipment. This
device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference and
(2) this device must accept any interference received,
including interference that may cause
undesired operation.
Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
©2011 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN MEXICO
V7867pr-0920
Download from Www.Somanuals.com. All Manuals Search And Download.
|