ETI Sound Systems INC Stereo Amplifier LG 200AS User Manual

1
Download from Www.Somanuals.com. All Manuals Search And Download.  
FRONT PANEL VIEW  
CLEAN CHANNEL  
OVERDRIVE CHANNEL  
CH. SEL.  
GAIN SW.  
10  
0
10  
0
10  
0
0
10  
0
10  
0
10  
0
10  
0
10  
0
10  
0
10  
0
10  
MIDDLE  
LEVEL  
TREBLE  
BASS  
LEVEL  
TREBLE  
MIDDLE  
BASS  
INPUT  
CONTOUR  
GAIN2  
GAIN1  
17  
12  
8
9
14  
15  
16  
13  
21  
11  
10  
19  
20  
18  
(13)  
(14)  
Overdrive Channel Level: Controls the complete  
signal of the overdrive channel.  
Overdrive Channel Treble: Adjusts the amount  
of high frequency boost or cut as desired in the  
overdrive channel.  
Overdrive Channel Middle: Adjusts the amount  
of mid frequency boost or cut as desired in  
overdrive channel.  
Overdrive Channel Bass: Adjusts the amount of  
low frequency boost or cut as desired in overdrive  
channel.  
channel (LED for Gain 2 indicates when Gain 2  
channel is in use).  
Gain 1: Adjusts the amount of distortion in Gain 1  
channel (LED for Gain1 indicates when Gain 1  
channel is in use).  
(20)  
(21)  
(15)  
(16)  
Input: Connects the electric guitar.  
AMPLIFIER PRECAUTIONS  
Do not attempt to service the LG-200AS by  
yourself. Refer all servicing to a B-52  
Authorized dealer. Service is required when  
the LG-200AS has had liquid spilled on it or  
has been damaged in any way, the amplifier  
has been exposed to rain or moisture, does not  
operate normally or has been dropped.  
(17)  
(18)  
Gain Switch: Selects Gain 1 or Gain 2 in O.D.  
channel.  
Contour: Adjusts the overall tone quality of Gain  
2 channel. Low Contour setting emphasize middle  
frequency. A higher setting will notch the mid-  
range to produce the crunch sound characteristic  
in most heavy metal sound.  
(19)  
Gain 2: Adjusts the amount of distortion in Gain 1  
REAR PANEL VIEW  
MONO  
RIGHT  
LEFT  
CAUTION  
RISK OFF ELECCTTRIC SHOCK  
DO NOT OPEN  
AUTION - TO REDUCE THE RISK OF FIRE,  
EPLACE ONLY WITH THE SAME TYPE OF FUSE.  
ARNING: TO REDUCE THE RISK OF FIRE  
R ELECTRICALSHOCK, DO NOT EXPOSE  
HIS EQUIPMENT TO RAIN OR MOISTURE  
BRIDGE  
STEREO  
LIFT  
GND  
MINI LOAD  
TOTAL 8 OHM  
MINI LOAD  
TOTAL 4 OHM  
MINI LOAD  
TOTAL 4 OHM  
32  
31  
30  
35  
36  
33  
37  
34  
(30)  
Mono Speaker Jack: Connects the external  
speaker mono signal at with a minimum impedance  
of 8 ohms.  
Bridge switch: Switches amplifier to bridge mode  
Stereo switch: Switches amplifier to stereo  
WARNING: SHOCK HAZARD!  
To reduce the risk of fire or electrical shock, do not expose  
this unit to rain or moisture. Do not operate your  
LG-200AS near a pool or other standing water. Make sure  
all blades on the polarized power plug are fully inserted  
into the power source. Ensure the powercord is not  
stretched, pinched or otherwise abused. Ensure the  
power cord is routed to avoid foot traffic. Your LG-200AS  
amplifier should be cleaned only with a dry cloth.  
(31)  
(32)  
(33&34) External Speaker Jacks: Connects the external  
speaker(s) with a minimum impedance of 4 ohms.  
Ground-Lift: Remove ground from the circuit to  
eliminate excessive 60 cycle hum.  
Fuse Holder: Contains primary fuse  
AC Inlet: Connects AC power cord.  
(35)  
(36)  
(37)  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
FEATURES  
1/4” high input jack  
WARRANTY  
Overdrive channel with gain 1, gain 2 with contour, 3-band EQ and level  
control  
Clean channel with level control and 3-band EQ  
Thank you for choosing this B-52 Pro-Audio sound prod-  
uct. B-52 manufactures some of the world’s best sound-  
ing and most reliable professional speaker systems and  
components. E.T.I. Sound Systems, Inc., manufacturers  
of B-52, takes great pride in thoroughly testing each  
B-52 product prior to shipment. Please read the warran-  
ty terms and conditions below and carefully read the pro-  
vided Limited Warranty Card for additional terms and  
conditions.  
Master volume and spring reverb  
Foot switch for channel select, reverb on/off, gain select & stereo chorus  
on/off  
Push switch for channel / gain select and stereo chorus on/off  
B-52 AMPLIFIER: E.T.I. Sound Systems, Inc. warrants  
the original purchaser that the B-52 amplifier will be free  
from defects in material and workmanship for a period of  
(2) TWO YEARS from the original purchase date. A  
dated sales receipt will establish coverage under this  
warranty. This warranty will automatically terminate (2)  
two years after the original sales date. If this product is  
defective in materials or workmanship as warranted  
above, your sole remedy shall be repair or replacement  
as provided above. See provided Limited Warranty Card  
for additional terms and conditions.  
Headphones line out  
Effects send and return with level controls  
Line out with level control  
External speaker jacks  
Ground lift switch  
Stereo chorus with depth and rate controls  
Stereo / bridge switch  
B-52 CABINETS: E.T.I. Sound Systems, Inc. offers a  
LIFETIME warranty to the original purchaser that B-52  
cabinet’s construction will be free from defects in materi-  
al and workmanship. A dated sales receipt will establish  
coverage under this warranty. The warranty does not  
cover service or parts to repair damage caused by neg-  
lect, abuse, normal wear & tear and cosmetic appear-  
ance of the cabinetry not directly attributed to defects in  
material or workmanship, or service & repair, modifica-  
tions to the cabinet which has not be authorized or  
approved by E.T.I. Sound Systems, Inc. If this product is  
defective in materials or workmanship as warranted  
above, your sole remedy shall be repair or replacement  
as provided above. See provided Limited Warranty card  
for additional terms and conditions.  
SPECIFICATIONS  
Output Power  
100 + 100 watts RMS @ 8 ohms stereo  
120 + 120 watts RMS @ 4 ohms stereo  
200 watts RMS @ 8 ohms bridged  
500K Ohms  
-45dB  
160 Watts  
Input Impedance:  
Maximum Input Level:  
Power Consumption:  
S/N Ratio:  
Greater Than 100 dB  
Load Impedance 1K Ohm or Greater  
-8 dB  
100K Ohms  
-8 dB  
Affects Send:  
Nominal Output Level:  
Effects Return Impedance:  
Optimum Input Level:  
Line Out:  
INCIDENTAL OR CONSEQUENTIAL DAMAGE: In no  
event E.T.I. Sound Systems, Inc. be liable for any inci-  
dental or consequential damages arising out of the use  
or inability to use of any B-52 product, even if, E.T.I.  
Sound Systems, Inc. or a B-52 dealer has been advised  
of the possibility of such damages, or any other claim by  
any other party. Some States do not allow the exclusion  
or limitation of consequential damages, so the above lim-  
itation and exclusion may not apply to you. This warran-  
ty gives you specific legal rights and you may also have  
other rights that may vary from State to State. See pro-  
vided Limited Warranty card for additional terms and  
conditions.  
0dB / 1V RMS  
Phones:  
Equalization:  
60mW into 8ohm  
Bass : +/- 15dB at 50Hz  
Middle : +/- 10dB at 600Hz  
Treble : +/- 18dB at 3KHz  
28” (W) x 10” (D) x 11” (H)  
41 lbs  
Dimensions:  
Weight:  
E.T.I. Sound Systems is dedicated to product excellence and therefore continuously  
attempts to improve each and every model we manufacture. This ongoing process  
includes refinements in design, materials and workmanship, which may result in prod-  
ucts that differ than those described in our literature. All features, specifications, and  
prices are therefore subject to change without notice.  
RETURN PROCEDURES: In the unlikely event that a  
defect should occur, follow the procedure outlined below.  
Defective products must be shipped together with a  
proof of purchase, freight prepaid and insured to the  
Authorized B-52 Dealer from whom you purchased the  
product or directly E.T.I. Sound Systems, Inc. If a prod-  
uct must be returned directly to E.T.I. Sound Systems,  
Inc. for warranty replacement/repair,  
a
Return  
Authorization Number (RAN) must be obtained from our  
Customer Service Department prior to shipping the prod-  
uct. You may obtain RAN by calling 800-344-4ETI.  
FOR YOUR PROTECTION: Please complete and mail  
the Purchase Information Card within (10) ten days of  
the date of purchase so that we may contact you direct-  
ly in the event a safety notification is issued in accor-  
dance with the 1972 Consumer Product Safety Act. In  
addition, we ask that you complete the brief question-  
naire so me may analyze your answers and in this way,  
help us evaluate our customer needs. See provided  
Limited Warranty card for additional terms and condi-  
tions.  
E.T.I. SOUND SYSTEMS, INC.  
3383 Gage Avenue, Huntington Park, CA, 90255  
Phone: 323-277-4100 Fax: 323-277-4108  
National: 1-800-344-4ETI  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  

Eton Radio G4000A User Manual
Fender Stereo Amplifier MB 1200 User Manual
Fisher Paykel Oven OB60S9DE User Manual
Frigidaire Microwave Oven FPMC3085K User Manual
Frigidaire Refrigerator FFPT12F3M User Manual
Gardena Water Dispenser C 1030 plus Art 1862 User Manual
GE Cooktop 169166 User Manual
GE Monogram Cooktop ZGU122LPSS User Manual
Generac Power Systems Portable Generator 04389 2 04456 2 04390 2 User Manual
GE Universal Remote 20622 User Manual