Front features
Connecting a DVD or Blu-ray DVD player, cable
box, satellite receiver or game station
Using HDMI (best)
Connecting to a computer
Back of TV
Back of TV
24" LED-LCD TV
Computer
Remote control
sensor
QUICK SETUP GUIDE
HDMI cable
Power indicator
DX-24E150A11
(not included)
Audio cable
D-Sub cable (analog RGB)
(stereo mini plugs)
HDMI device
Volume
+/-
Menu Power button
Channel Input
+/-
Using component (better)
Connecting headphones
Installing the stand
1 Remove the stand, stand column, and screws from the box.
2 Lay the TV flat (screen down) on a flat, cushioned surface. Align the bottom side
of the TV with one edge of the table.
Back of TV
3 Insert the stand column into the TV stand and secure it with the three stand
column screws.
Back of TV
Component video device
Smaller screws (3)
Stand column
Remote control
and
2 AAA batteries
Composite video
cable
Component
video cable
Component audio cable
(not included)
Connecting power
Note: Cable connectors and jacks are often color-coded. Match the colors when
you connect the AV cable.
Connect the power cable to a power outlet.
TV stand and screws
4 Align the holes in the stand with the holes on the stand column, then secure the
stand to the column with the larger screw provided.
Connecting an antenna
Important: The wide portion of the stand should go towards the front of the TV.
Connect a 75 ohm cable (not included) to the ANT/CABLE IN jack on the back of
your TV and the RF OUT jack on the antenna.
Back of TV
Large screw
Stand
Power cord
Power outlet
75-Ohm coaxial cable
Antenna, cable TV,
or satellite RF jack
Installing a wall-mount bracket
1 Carefully place your TV screen face-down on a cushioned, clean surface to
protect the screen from damages and scratches.
Connecting a VCR, camcorder, or game
(good)
2 Remove the three screws holding the stand column to your TV, then remove the
stand and the stand column.
3 Secure the wall-mount bracket (not included) to the back of your TV using the
four screws provided with the bracket.
Quick Setup Guide
Setting up your remote control
1 While pressing the release button on the
battery compartment cover on the back
of the remote, lift the cover off the remote.
2 Insert two AAA batteries into the battery
compartment. Make sure that the + and -
symbols on the batteries align with the
+ and – symbols in the battery compartment.
3 Replace the cover.
Back of TV
Back of VCR
WE ARE GOING GREEN!
A copy of the User Guide is not provided in the box
AV cable
To program your existing remote control to work with your Dynex TV, see the table
below for common codes. If you have problems programming your remote, or
remote control code information.
Back of camcorder
or game
Universal remote control TV codes (for all Dynex TVs manufactured after Jan. 1, 2007)
Universal remote control makers and models
Set-top box makers and models
Note: Cable connectors and jacks are often color-coded. Match the colors when
you connect the AV cable.
Philips
RCA
One for All
URC-6690
Sony
RM-VL600
Comcast
M1057
Dish Network
Motorola
DRC800
TIVO
Series 3, HD
DirectTV
RC23
PHDVD5, PH5DSS,
PMDVR8, PDVR8
RCU807
VIP508, VIP622
115
135
0464
8043
0463
720
0463
0091
10463
Download from Www.Somanuals.com. All Manuals Search And Download.
|