The IR-2005 includes these items:
CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in material or
workmanship which occurs during normal use of this product with new or rebuilt
parts, free of charge in the USA, for two years from the date of original purchase.
This is a no hassle warranty with no mail in warranty card needed. This warranty
does not cover damages in shipment, failures caused by other products not
supplied by Channel Vision Technology, or failures due to accident, misuse,
abuse, or alteration of the equipment. This warranty is extended only to the
original purchaser, and a purchase receipt, invoice, or other proof of original
purchasedatewillberequiredbeforewarrantyrepairsareprovided.
IR-2005
(rear view)
Screwless decorator style trim ring
Single-gang decorator style IR wall plate
Mail in service can be obtained during the warranty period by calling (800) 840-
0288 toll free. AReturnAuthorization number must be obtained in advance and
canbemarkedontheoutsideoftheshippingcarton.
IR-2400 Plasma proof IR receiver
This warranty gives you specific legal rights and you may have other rights
(which vary from state to state). If a problem with this product develops during or
after the warranty period, please contact ChannelVisionTechnology, your dealer
oranyfactory-authorizedservicecenter.
IR-2005
(front view)
500-181 rev A
How IR repeating works
Specifications (typical)
The IR receiver is wired to
the IR hub which routes the
signal to IR emitters
Voltage requirements:
IR Freq. range supported:
IR pickup range:
8 - 12 VDC
30 kHz - 60 kHz
40 ft. @ 38kHz, 25 ft. @ 56kHz
Single-gang box or ring
White
Mounting requirements:
Color:
Specifications subject to change without notice.
n
Point an
IR remote control
at the IR receiver
sio
an
xp
E
e
n
Zo
bal
lo
G
r
Pw
Model
P-1205
IR
Receiver
HANN
I
S
I
C
V
IR receiver window
l
a
b
lo
G
IR
r
e
iv
e
c
Emitters
e
R
e
n
o
Z
C
A
D
2
1
+
m
0
5
2
Features:
CD player
And the emitter
repeats the IR signal
in the other room.
!
!
!
Plasma Proof IR receiver
Status LEDs for IR signal indication
Mounts in a single-gang box or low-voltage ring
Be sure the emitter is attached directly over the
component’s IR receiver. To locate the IR receiver, shine a
flashlight into the unit and look for the sensor.
Download from Www.Somanuals.com. All Manuals Search And Download.
|