FW950 Integrated Frost Free
fridge freezer
Manual for Installation, Use and Maintenance
Customer Care Department • The
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
Download from Www.Somanuals.com. All Manuals Search And Download.
Important
Never store inflammable or explosive items and strong corrosive acids or alkalis in the appliance.
This is a household appliance, which is produced in accordance with the national standard. It is intended for food
storage only, not for storage of blood, medicine and biological products.
To prevent risk of fire, keep the appliance away from petrol or any other inflammables.
To prevent risk of electromagnetic interference or other accidents, do not place a microwave oven on top of the
refrigerator or use any electric appliance inside the refrigerator.
Do not allow children to play with or near the appliance.
The internal surface of freezer compartment is very cold when the appliance is running. Do not touch the surface
especially when hands are wet.
Do not splash water onto the appliance. Keep it away from places of high humidity that may have adverse effect on
the electric insulation performance.
This appliance is designed to be used in ambient temperatures between 16 and 32 C. Use outside of this range may
˚
cause the appliance to fail.
Before first use
You must allow the fridge to settle for at least twenty four hours prior to switching the power on.
It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda
and warm water and then thoroughly drying the interior.
The fridge may have an odour to it at first use. This will disappear as the appliance cools.
The green power light and the red temperature warning light on the control panel will be lit when you have plugged
the appliance in to the power supply. There will be an intermittent beep and the temperature warning light will remain
on until the appliance reaches the required temperature. To switch off the beep, press the alert button.
Please note:
The appliance will work continuously until it comes down to the correct temperature.
If the appliance is switched off, you should allow five minutes before switching it on again to prevent unnecessary
damage to the compressor.
2
Download from Www.Somanuals.com. All Manuals Search And Download.
Use
Fridge
•
•
Never put liquids in the refrigerator uncovered.
Never put hot foods in the refrigerator. Warm food should be allowed to cool to room temperature before being
put into the refrigerator.
•
Nothing should rest against the rear wall of the refrigerator, as this will cause frost and possible condensation
problems which will be difficult to remove.
•
•
Make sure food is clean and any extra water is wiped away before putting into the fridge.
Wrap or cover food before putting into the fridge. This will help prevent the loss of moisture, keep food fresh
and avoid unpleasant odours.
•
Sort foods prior to storing. Any foods to be used soon should be stored at the front of the shelf to prevent
deterioration caused by the door being open for prolonged periods.
•
•
Do not overfill the fridge. There should be sufficient space between the foods to allow the cool air to circulate.
Thawing frozen foods in the fridge compartment will help to keep the temperature low and save energy.
Freezer
•
•
•
The freezer compartments are designed to store only frozen food.
Never put hot or warm foods in the freezer, allow them to cool fully before putting them into the freezer.
Follow the instructions on the food packaging for storage of frozen food. If no information is provided, foods
should not be stored for more than three months after the purchase date.
•
Store food in small packages (ideally less than 2.5kg). This reduces the freezing time and improves the quality of
the food after thawing.
•
•
•
Wrap food before putting into the freezer. To stop the wrapping sticking together, ensure it is dry.
Label the food before freezing with information including type of food and dates of storage and expiry.
Once food is thawed, it must not be refrozen unless it has been completely cooked. Only defrost as much food
as is required to prevent wastage.
•
•
Bottled or canned drinks should not be stored in the freezer compartment as they could explode.
Check the rating plate to confirm the maximum amount of fresh food that can be frozen within a 24 hour period.
Do not attempt to freeze more than the maximum amount.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
Storage
The fridge section is for short term food storage. Although
the temperature can be maintained between 0-10
periods of food storage is not recommended.
˚
C, extended
As the cold air circulates within the fridge, the temperature can
vary between the different sections. As such, foods should be
stored in different sections according to type. Section 6 is the
coldest part of the fridge.
1. Butter
alarm
2. Food in jars and bottles
3. Drinks , e.g. milk
4. Cooked food
1
2
4
5
5. Yogurts and cheese
6. Fresh meat and fish
7. Fruit and vegetables
6
7
3
fig. 1
The fridge shelves can be moved according to the storage
requirements within the fridge section.
To move the shelf, lift up the front section and then pull it
outwards. To replace, slide the shelf back into the slot, and the
lower the front section.
fig. 2
4
Download from Www.Somanuals.com. All Manuals Search And Download.
Control panel
A
C
D
alarm
B
fig. 3
The control panel for the fridge has two lights:
A. Green Power light
This light is illuminated when the power supply to the appliance is on.
B. Red Temperature Warning light
When the freezer is over temperature, this light will switch on. The light will remain on until the freezer temperature
is below 5 C.
˚
C. Audio Alert release / Force Defrost button
When the freezer is over temperature, a series of intermittent beeps will serve as an alert. To switch off the beeps,
press this button.
To force a defrost cycle, press and hold this button for approximately five seconds, as explained on page six.
D. Thermostat dial
The temperatures in both compartments are regulated by the same thermostat dial.
The thermostat can be set between fully anticlockwise (least cold) and fully clockwise (coldest).
5
Download from Www.Somanuals.com. All Manuals Search And Download.
Care and cleaning
Always disconnect the appliance from the power supply before any cleaning or maintenance.
The fridge and freezer sections should be cleaned using a solution of bicarbonate of soda and lukewarm water. Do not
use abrasive products or detergents. After washing, rinse and dry thoroughly.
Clean the shelves and balconies separately by hand with soap and water. Do not put them in the dishwasher.
The water drain hole at the back of the fridge compartment and the evaporating tray should be cleaned periodically to
prevent the defrosted water from collecting inside the fridge compartment. The drain plug can be used to clean the
drain hole.
Once cleaning is complete, then reconnect the power.
If the appliance is not to used for prolonged periods of time, unplug and clean the appliance. The doors should be left
slightly open to prevent the formation of mildew and smell.
Defrosting the fridge
The fridge is self-defrosting. Any water created will run out of the fridge through the channel at the back of the fridge.
It is important to keep the channel clear at all times. The defrosted water is collected in the evaporating tray at the back
of the appliance.
fig. 4
Defrosting the freezer
The freezer is frost free and as such is designed not to require defrosting.
To switch off the compressor for a short period of time and so to force a defrost cycle, push and hold the Audio Alert
Release / Force Defrost button for approximately five seconds. After 20 seconds, the defrosting process will begin.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
Changing the light bulb
Disconnect the appliance from the power.
•
•
•
Release the light cover by pressing on the hooks at the back of the cover, then slide it towards the back of the fridge to remove it.
Unscrew the light bulb to remove it and replace with a new bulb of the same rating (not more than 15W).
Replace the light cover and reconnect the power.
Troubleshooting
If you have any problems with your appliance, you should check the troubleshooting prior to calling CDA Customer Care
to prevent unnecessary service calls and potential cost.
If the appliance is not working
•
•
•
•
•
Check there is power to the appliance.
The green light on the control panel is lit.
The house fuses are intact and the fuse in the plug has not blown.
The thermostat is not set to off.
The plug socket is functioning fine. To check this, plug another electrical appliance in to see if the socket is faulty.
The appliance is working, but not very well
•
•
•
•
•
The appliance is not overloaded.
The thermostat is set to an appropriate temperature.
The doors are closing properly.
The cooling system at the rear of the appliance is clean and free of dust, and not touching the rear wall.
There is enough ventilation at the side and rear walls.
The appliance is noisy
•
•
•
The appliance is level and stable.
The side and rear walls are clear, and there is nothing resting on the appliance.
The cooling gas in the refrigerator will make a slight bubbling noise, even when the compressor is not running.
There is water in the lower part of the refrigerator compartment
The drain hole in the channel at the back of the compartment is clear.
•
Ice has formed on the back wall of the fridge
•
•
It is normal for some ice droplets to form on the back wall of the fridge. This does not constitute a fault with the appliance.
Ensure that no items inside the fridge are in contact with the back wall.
If the temperature warning light flashes, contact CDA Customer Care.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
Installation And Ventilation
This appliance must never be installed close to heat sources, e.g. heating elements, cookers or in damp places.
•
•
•
To ensure the appliance is level, you should use the height adjustable feet at the front of the appliance.
The cooling system at the rear of the appliance must not touch the rear wall.
The appliance must be installed with adequate ventilation. Ensure that there is clearance above the appliance to
allow air to escape and that there is space between the rear of the appliance and the wall.
The diagram shows the ventilation requirements for your appliance.
Failure to provide adequate ventilation can lead to increased running costs and premature failure and may invalidate the
warranty provided with the appliance.
545
57
814
25
1778
837
45
= airflow
540
300
40 - 50
300
25
fig. 5
400
8
Download from Www.Somanuals.com. All Manuals Search And Download.
Mounting the Fascia Door
x4
•
Using a screwdriver, fix the mounting brackets to the
appliance door, as shown in figure 6.
•
Position the appliance within the unit. Ensure that there
is a gap of 3 to 4 mm between the non-hinged side and
the cabinet wall.
•
•
Locate the slider in the bracket and fix the slider to
the fascia door 20 to 22 mm from the edge of the
fascia as shown in figure 7, ensuring that the slider is
positioned centrally and horizontally within the bracket.
Tighten securely by hand.
Fill the gap on the non-hinged side with the seal strip
provided, as shown in figure 8.
fig. 6
x4
20 mm
fig. 7
door gasket
fig. 8
9
Download from Www.Somanuals.com. All Manuals Search And Download.
Reversing the door
We recommend you seek the help of another individual to support the doors whilst performing this operation
1. Carefully prise off the cover cap for the top hinge and unscrew the screws fixing the top hinge to the appliance, you
should support the upper door whilst doing this.
2. Carefully remove the upper door and place it somewhere safe. Note that there are spacers between the door and the
hinge; note how many and their position.
3. Remove the central hinge by removing the 3 screws fixing it to the appliance; support the lower door whilst doing this.
4. Remove the lower door and place it somewhere safe, again noting the position of any spacer pieces.
5. Swap the bottom hinge to the opposite side.
6. Refit the lower door using any spacers and position the central hinge on the door. After removing the 3 cover caps, fix
the hinge securely to the appliance.
7. The top hinge and replacement cover hinge covers are included in the fittings pack. Refit the upper door and the new
top hinge and fix it securely to the appliance.
8. Fit the central cover caps and top hinge cover pieces in place to complete the process.
Ensuring the door seals correctly:
It is normal for the seal to be compressed after the door has been reversed.
With the door closed, use a hair dryer to cause the seal to expand and fill the gap between the door and the body of the
appliance.
Take care not to use the hair dryer too close to the appliance, which could damage the seal. A distance of approximately 10 cm
should be adequate.
When completed, allow the seal and door to cool before touching them.
Once done, the seal will remain in position.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
Electrical information
Warning! This appliance must be earthed.
The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow
the steps below:
1. Remove the fuse cover and fuse.
2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover.
3. Replace fuse cover.
Important: Do not use the appliance without the fuse cover in position.
How to connect an alternative plug
If the fitted plug is not suitable for your socket outlet, then it should be cut off and disposed of safely to avoid possible shock
hazard. A suitable alternative plug of at least 13 Amp rating to BS 1363 should be used.
As the colours of the wires in the mains lead of this appliance may not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows:-
•
•
•
The wire which is coloured GREEN and YELLOW must be connected to the terminal which is marked with letter (E) or
by the Earth symbol or coloured GREEN and YELLOW.
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter (N), or
coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter (L) or
coloured RED.
If in doubt regarding the electrical connection of this appliance, consult a qualified electrician. Do not shorten the
supply cable, the appliance may require removing for servicing.
N.B. Ensure that the plug socket is situated in an easily accessible place after installation.
11
Download from Www.Somanuals.com. All Manuals Search And Download.
12
Download from Www.Somanuals.com. All Manuals Search And Download.
11
Download from Www.Somanuals.com. All Manuals Search And Download.
12
Download from Www.Somanuals.com. All Manuals Search And Download.
To contact our Customer Care Department, or for Service,
please contact us on the details below.
Customer Care Department • The
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
Download from Www.Somanuals.com. All Manuals Search And Download.
|