CDA Freezer FW282 User Manual

FW282 integrated under  
counter freezer  
Manual for Installation, Use and Maintenance  
Customer Care Department • The  
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY  
T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Important  
Never store inflammable or explosive items and strong corrosive acids or alkalis in the appliance.  
This is a household appliance, which is produced in accordance with the national standard. It is intended for food storage only,  
not for storage of blood, medicine and biological products.  
To prevent risk of fire, keep the appliance away from petrol or any other inflammables.  
To prevent risk of electromagnetic interference or other accidents, do not place a microwave oven on top of the refrigerator  
or use any electric appliance inside the refrigerator.  
Do not allow children to play with or near the appliance.  
The internal surface of freezer compartment is very cold when the appliance is running. Do not touch the surface especially  
with wet hands.  
Do not splash water onto the appliance. Keep it away from places of high humidity that may have adverse effect on the  
electric insulation performance.  
Please remove the door, door seal and shelves before disposal of the old appliance and put them away in a safe place to  
prevent children from being entrapped.  
Before first use  
You must allow the freezer to settle for at least twenty four hours prior to switching the power on.  
It is recommended that you clean the interior of the appliance prior to first use, using a solution of bicarbonate of soda and  
warm water and then thoroughly drying the interior.  
The freezer may have an odour to it at first use. This will disappear as the appliance cools.  
Please note:  
The appliance will work continuously until it comes down to the correct temperature.  
If the appliance is switched off, you should allow five minutes before switching it on again to prevent unnecessary damage  
to the compressor.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Use  
Freezer  
The freezer compartments are designed to store only frozen food.  
Never put hot or warm foods in the freezer, allow them to cool fully before putting them into the freezer.  
Follow the instructions on the food packaging for storage of frozen food. If no information is provided, foods  
should not be stored for more than three months after the purchase date.  
Store food in small packages (ideally less than 2.5kg). This reduces the freezing time and improves the quality of the  
food after thawing.  
Wrap food before putting into the freezer. To stop the wrapping sticking together, ensure it is dry.  
Label the food before freezing with information including type of food and dates of storage and expiry.  
Once food is thawed, it must not be refrozen unless it has been completely cooked. Only defrost as much food as is  
required to prevent wastage.  
Bottled or canned drinks should not be stored in the freezer compartment as they could explode.  
Only open the door for as long as is necessary. Leaving the door open for long periods will affect the temperature  
inside the appliance and waste energy.  
Ensure all compartments are fully closed after use.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Control panel  
A
B
C
!
2
1
D
3
0
SF  
4
5
fig. 1  
A. Orange Compressor light  
This light is illuminated when the compressor is running (for example, when Super Freeze is switched on)  
B. Green Power light  
This light is illuminated when the power supply to the appliance is on.  
C. Red Over Temperature Light  
This light is illuminated when the interior temperature is too warm.  
D. Thermostat dial  
The thermostat can be set between 0 (least cold) and 5 (coldest)  
Super Freeze function  
Your freezer is equipped with a super freeze function, which runs the compressor continuously. Super freeze should be used  
when introducing large amounts of fresh food into the freezer.  
To switch the super freeze function on, turn the thermostat dial fully clockwise to SF. When the super freeze function is no  
longer required, turn the thermostat dial back to the required setting.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Defrosting the freezer  
Do not use heaters or defrosting sprays in this appliance.  
• Never use any metallic or sharp objects to remove the ice as this could damage the lining.  
• The freezer compartment should be defrosted regularly to ensure the most efficient running of the freezer.  
• Once the ice is more than 5mm thick, the freezer should be defrosted.  
• First remove the freezer drawers.  
To speed up the process, place a bowl of warm water in the base of the freezer compartment.  
Once defrosting is complete, dry the inside of the freezer compartment with a sponge or clean cloth.  
The freezer should be cleaned using a solution of bicarbonate of soda and lukewarm water. Do not use abrasive products or  
detergents. After washing, rinse and dry thoroughly.  
Clean the drawers separately by hand with soap and water. Do not put them in the dishwasher.  
Once cleaning is complete, then reconnect the power.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Troubleshooting  
If you have any problems with your appliance, you should check the troubleshooting prior to calling CDA Customer Care to  
prevent unnecessary service calls and potential cost.  
If the appliance is not working  
Check there is power to the appliance:  
The house fuses are intact and the fuse in the plug has not blown.  
The thermostat is not set to 0 (off position).  
The plug socket is functioning fine. To check this, plug another electrical appliance in to see if the socket is working.  
The temperature of the room is adequate (10oC or above).  
The appliance is working, but not very well  
The appliance is not overloaded.  
The thermostat is set to an appropriate temperature.  
The door is closing properly.  
The cooling system at the rear of the appliance is clean and free of dust, and not touching the rear wall.  
There is enough ventilation at the side and rear walls.  
The temperature of the room is adequate (10oC or above).  
The appliance is noisy  
The appliance is level and stable.  
The side and rear walls are clear, and there is nothing resting on the appliance.  
The cooling gas in the refrigerator will make a slight bubbling noise, even when the compressor is not running.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installation  
This appliance must never be installed close to heat sources i.e. heating elements, radiators, cookers or in  
damp places  
The appliance should be mounted on a piece of wood (for example a section of worktop or kitchen carcass) if  
a raised floor is to be fitted, if the kitchen floor is to be tiled after installation, or if the installation height of  
the appliance is greater than 850 mm.  
Contents and Tools Required  
Fig. 1 - Installation kit contents  
2
1
1. Wood screw (17 pcs)  
3
2. Decor door fixing bracket  
4
3. Decor door base fixings (2 pcs)  
6
5
4. Decorative cover  
5. Screw  
KIT  
6. Top bracket  
fig. 1  
Fig. 2 - Tools required  
7. Spirit level  
7
8
8. Spanner  
9. Setsquare  
10. Flathead screwdriver  
10  
10  
9
9
fig. 2  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installation  
Fig. 3 - Dimensions of the appliance  
600  
min  
550  
548  
595  
820-  
890  
819-  
889  
100- 170  
min 25  
fig. 3  
Fig. 4 - Fitting the worktop bracket  
5
Remove the screw (5) on the top of the appliance, locate the  
top bracket(6) and fix the bracket with screw(5).  
6
fig. 4  
Fig. 5 - Fitting the spacer piece  
Take out the spacer piece (11) located on the side panel and  
remove the protective tape. Stick the spacer piece on the  
opposite side to the door hinges of the appliance.  
11  
11  
11  
11  
fig. 5  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installation  
Fig. 6 - Adjusting the appliance height  
The height of the appliance can be adjusted by the help of  
adjustable feet to fit the furniture height. Use a spirit level to  
ensure the appliance is level.  
7
7
8
fig. 6  
Fig. 7 - Aligning the appliance  
Slide the appliance into the kitchen unit and align the hinge  
surface with front surface of the kitchen unit.  
9
9
fig. 7  
Fig. 8 - Fixing the appliance  
1
Screw the hinges and metal bracket to the kitchen unit using  
screws (1)  
1
fig. 8  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installation  
Fig. 9 - Fitting the decor door bracket  
C
Unscrew and remove the nuts and washers from the appliance  
door. Place fixing bracket on the appliance door by inserting  
the holes to adjustment bolts.  
B
Dimension B= Measure from the underside surface of kitchen  
unit to the bottom of fixing bracket.  
fig. 9  
Dimension C= Measure from the underside surface of kitchen  
unit to the top of next unit door.  
Fig. 10 - Fitting the decor door bracket  
Substract C from B and put the fixing bracket (2) in place using  
this measurement for vertical position and place to the centre  
for horizontal position. Secure the fixing bracket (2) using  
screws(1).  
1
B-C  
2
fig. 10  
Fig. 11 - Fitting the decor door  
Place the decor door onto the appliance door by inserting  
adjustment bolts into the slots on the fixing bracket. Locate the  
washers and screw the nuts onto the adjustment bolts.  
fig. 11  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installation  
Fig. 12 - Aligning the decor door  
Close the door and check the alignment with the other unit  
doors. Adjust the decor door by screwing or unscrewing the  
adjustment bolts for vertical adjustment and by the help of the  
slots on the fixing bracket for other directions. Lock the screws  
into place as shown in 10.2.  
10  
10  
8
fig. 12  
Fig. 13 - Fitting the decor door base fixings  
With the appliance door open, remove the screws at the  
bottom of the appliance door. Locate the decor door base  
fixings (3) and screw the fixings to the appliance door and the  
decor door.  
3
1
fig. 13  
Fig. 14 - Fitting the decorative cover  
Fit the decorative cover (4) on the decor door fixing bracket.  
4
fig. 14  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Installation  
Fig. 17 - Fitting the plinth  
Fit the plinth section, providing minimum 25 mm gap between  
the cabinet door and fix it.  
Never cover over the ventilation slots.  
Once installed the plinth must not block the  
ventilation slots in the appliance.  
This may require cutting the plinth down. Failure  
to ensure adequate ventilation may invalidate  
the warranty.  
25mm  
min  
fig. 17  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Reversing the door  
It is possible to reverse the door on this appliance, if  
required. To do so, follow the steps below:  
1. Open the door.  
2. Loosen the hinge fixing screws (1) and remove the door.  
3. Remove the door fixing screws (2).  
4. Remove the cover caps (3).  
5. Relocate the hinges as shown.  
6. Refit the door to the hinges.  
Do not turn the door upside down  
7. Insert the cover caps (3) on the opposite side in the exposed  
holes.  
fig. 18  
Download from Www.Somanuals.com. All Manuals Search And Download.  
Electrical information  
Warning! This appliance must be earthed.  
The mains lead of this appliance has been fitted with a BS 1363A 13 amp fused plug. To change a fuse in this type of plug, follow  
the steps below:  
1. Remove the fuse cover and fuse.  
2. Fit replacement 13A fuse, ASTA approved to BS 1362 type, into the fuse cover.  
3. Replace fuse cover.  
Important: Do not use the appliance without the fuse cover in position.  
How to connect an alternative plug  
If the fitted plug is not suitable for your socket outlet, then it should be cut off and disposed of safely to prevent the risk of electric  
shock. A suitable alternative plug of at least 13 Amp rating to BS 1363 should be used.  
As the colours of the wires in the mains lead of this appliance may not correspond with the  
coloured markings identifying the terminals in your plug, proceed as follows:-  
The wire which is coloured GREEN and YELLOW must be connected to the terminal which is marked with letter (E) or  
by the Earth symbol or coloured GREEN and YELLOW.  
The wire which is coloured BLUE must be connected to the terminal which is marked with the letter (N), or  
coloured BLACK.  
The wire which is coloured BROWN must be connected to the terminal which is marked with the letter (L) or  
coloured RED.  
If in doubt regarding the electrical connection of this appliance, consult a qualified electrician. Do not shorten the  
supply cable, the appliance may require removing for servicing.  
N.B. Ensure that the plug socket is situated in an easily accessible place.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
To contact our Customer Care Department, or for Service,  
please contact us on the details below.  
Customer Care Department • The  
Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY  
T : 01949 862 012 F : 01949 862 003 E : [email protected] W : www.cda.eu  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Belkin Switch P74696 User Manual
Black Box Switch 2 Channel Component Video Splitter Switch User Manual
Black Decker Convection Oven CTO800 User Manual
Blodgett Range B36 COMBOS User Manual
Bosch Appliances Water Heater 125B LP User Manual
Boss Audio Systems Car Amplifier CH900 User Manual
Brother Printer 4570CDW User Manual
Canton Speaker CD 3500 User Manual
Casio Watch MA0407 EA User Manual
Chicago Electric Grinder 67648 User Manual