Braun Mixer MR740cc User Manual

®
Multiquick 7  
Cordless Hand Processor  
MR 740 cc  
Download from Www.Somanuals.com. All Manuals Search And Download.  
3
7
A
1
4
2
6
10  
a
5
8
1
b
c
2
9
d
B
1
4
2
3
10  
e
f
5
6
7
1
2
C
+
1cm  
1cm  
250 g  
200 g  
45  
200 g  
15  
30 g  
15  
30  
15  
250 g  
5
350 g  
15  
400 g 150 g + 700 ml  
+
30  
15  
60  
15  
Download from Www.Somanuals.com. All Manuals Search And Download.  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
4
Download from Www.Somanuals.com. All Manuals Search And Download.  
5
a
b
c
d
2
2
3
1
1
4
3
e
g
f
2
3
1
1
2
j
i
h
1
1
2
2
m
l
k
1
2
Download from Www.Somanuals.com. All Manuals Search And Download.  
6
Download from Www.Somanuals.com. All Manuals Search And Download.  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
8
English  
Our products are engineered to meet the highest  
standards of quality, functionality and design. We  
hope that you thoroughly enjoy your new Braun  
appliance.  
6
7
8
9
Blender shaft  
Beaker  
Charging unit (incl. cord storage)  
Special cord set  
10 Chopper attachment  
(a) Gear lid  
Please read the use instructions carefully and  
completely before using the appliance.  
(b) Blade  
(c) Chopper bowl  
(d) Anti-slip base/lid  
(e) Ice blade  
Caution  
The blades are very sharp! Handle blades  
with utmost care in order to prevent  
injuries.  
(f) Ice crusher insert  
• High risk of injury by switching on the appliance  
unintentionally. As this is a rechargeable  
appliance, it is ready for use anytime (when  
charged).  
• Do not expose the appliance to direct sunlight.  
• When the blades are blocked remove motor part  
from blender shaft, before removing the food/  
blockage.  
• Before cleaning, remove blender shaft from motor  
part.  
• The appliance is constructed to process normal  
household quantities.  
• This appliance is provided with a special cord set  
with an integrated Safety Extra Low Voltage  
power supply. Do not exchange or manipulate any  
part of it. Otherwise there is risk of electric shock.  
• Only use the appliance with the charging unit  
supplied.  
Charging  
The ideal temperature range for charging is between  
15 °C and 35 °C.  
Make sure that the charging unit (8) is located on a  
level surface. Connect the charging unit to the mains  
via the special cord set.  
For charging, place the complete handblender in the  
charging unit (8) – (motor part alone also possible).  
The green pilot light confirms that the appliance is  
properly inserted in the charging unit and that it is  
being charged.  
• Full charge: ca. 2 hours  
• Fully charged: the pilot light flashes with longer  
intervals  
• The charging unit can remain permanently  
connected to the mains.  
• Operation time is ca. 20 minutes (depending on  
way of usage)  
• Protect the motor part, the charging unit and  
special cord set against humidity. Motor part and  
power supply of special cord set must no longer  
be used after they have been immersed in water.  
• This appliance is not intended for use by children  
or persons with reduced physical or mental  
capabilities, unless they are given supervision by  
a person responsible for their safety. In general,  
we recommend that you keep the appliance out of  
reach of children. Children should be supervised  
to ensure that they do not play with the appliance.  
• Before use, make sure that charging unit and  
special cord set are not damaged. Braun electric  
appliances meet applicable safety standards.  
• Repairs or the replacement of the mains cord  
must only be done by authorised service  
personnel.  
After every usage, place the appliance back onto  
the charging unit for recharging. This will make sure  
that it is always ready for use with optimum charging  
conditions. You may as well store the appliance on  
the charging unit. Even if not in use for a long period  
of time, the lithium ion batteries implemented main-  
tain their charging level to a large extent.  
The batteries are protected against deep discharge.  
A completely discharged appliance has to be  
charged for at least ca. 15 minutes before it can be  
used for an application (e.g. soup).  
Pilot Light  
• Faulty, unqualified repair work may cause  
considerable hazards to the user.  
Appliance in  
charging unit  
(connected to the  
mains)  
Charging or operation  
conditions  
Description  
1
2
3
4
5
Pilot light  
Switch release button  
On switch  
Green flashing  
Battery is charging  
Green flashing  
(in longer intervals)  
Battery is fully charged  
Motor part  
Push buttons for releasing the accessories  
Download from Www.Somanuals.com. All Manuals Search And Download.  
9
Auto Off  
Switch release  
button (2) pressed  
down  
Charging or operation  
conditions  
For safety reasons the appliance turns off after  
4 minutes of permanent usage. The appliance can  
be turned directly on again.  
Green  
Battery is fully charged  
Red/green flashing  
Charge sufficient for at  
least one usage  
Red  
Red  
Battery is discharged  
Using your handblender  
The handblender is perfectly suited for preparing  
dips, sauces, soups, mayonnaise and baby food as  
well as for mixing drinks and milkshakes.  
a) Remove knife protection at the bottom of the  
blender shaft by removing the adhesive tape.  
Insert the motor part (4) into the blender shaft (6)  
until it locks.  
b) Introduce the handblender vertically into the  
vessel, keep the switch release (2) pressed down,  
then press the On switch (3).  
Overheating protection  
active (go to Safety  
features A Overheat  
protection)  
Safety features  
Switching on the appliance / Switch lock  
The appliance has a switch lock. To safely switch it  
on, follow these points:  
c) To remove the blender shaft from the motor part,  
press push buttons (5).  
1 First press the switch release button (2) with your  
thumb and hold.  
2 Then press the On switch (3). During operation,  
you can stop pressing the switch release button.  
• If the On switch (3) is not pressed within  
5 seconds, the appliance cannot be switched  
on. The pilot light goes off.  
When operating the handblender in hot liquids do  
not immerse the blender shaft into – or remove it  
from the liquid while the appliance is switched on.  
Recipe example:  
Mayonnaise  
200–250 ml oil,  
• In order to switch the appliance on, start again  
with step 1.  
1 egg (yolk and white),  
1 tbsp. lemon juice or vinegar,  
salt and pepper to taste  
Overheat protection  
When the overheat protection feature is active,  
the appliance turns off and the pilot light shines  
permanently red.  
Put all ingredients into the beaker according to the  
a.m. order. Introduce the handblender to the base of  
the beaker. After switching on, keep the handblender  
in this position until the oil emulsifies. Then, without  
switching off, slowly move it up and down until the  
mayonnaise is well combined.  
Reason  
Trouble shooting  
1. Remove motor part  
2. Remove the food/  
blockage  
Blade is blocked  
3. Place the motor part  
into the charging unit  
(connected to the mains)  
for at least 1 second  
4. Processing can be  
continued  
Using your chopper attachment  
The chopper is perfectly suited for chopping meat,  
cheese, onions, herbs, garlic, carrots, walnuts,  
almonds, prunes etc.  
N.B.: Do not chop extremely hard food, such as  
nutmeg, coffee beans and grains.  
Appliance is  
overheated  
Follow points 1.-4.  
If the pilot light still shines  
red when switching on the  
appliance, place the motor  
part back into the charging  
unit and let it cool down  
for ca. 1 hour. During this  
time, the pilot light flashes  
green.  
Before chopping ...  
• pre-cut meat, cheese, onions, garlic, carrots, chilis  
(see processing guide S. 5)  
• remove stalks from herbs, un-shell nuts  
• remove bones, tendons and gristle from meet.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
10  
Chopping  
(see picture section A)  
Cleaning  
Before cleaning remove the motor part. Do not  
immerse the motor part (4) and charging unit (8) in  
water nor hold them under running water. These  
parts can only be cleaned with a damp cloth.  
The chopper gear box (10a) is not dishwasher-proof.  
All other parts are dishwasher-proof.  
When processing foods with colour (e.g. carrots),  
the plastic parts of the appliance may become  
discoloured. Wipe these parts with vegetable oil  
before cleaning them.  
1. Carefully remove the plastic cover from the blade  
(10b). Caution: the blade is very sharp! Always  
hold it by the upper plastic part.  
Press the blade onto the centre pin of the chopper  
jug (10c) until it locks. Always place the chopper  
jug on the anti-slip base (10d).  
2. Place the food in the chopper jug.  
3. Put the gear lid (10a) on the chopper jug.  
4. Insert the motor part into the gear lid until it locks.  
5. Keep the switch release button (2) pressed down  
and press the ON switch (3) to operate the  
chopper. During processing, hold the motor part  
with one hand and the chopper jug with the other.  
When chopping hard foods, press down the motor  
part.  
For electric specifications, please see printing on the  
special cord set. The special cord set automatically  
adapts to any worldwide AC voltage.  
6. After use, press buttons to remove the motor part.  
7. Then remove the gear lid.  
Subject to change without notice.  
8. Carefully take out the blade.  
This appliance contains Li-Ion rechargeable  
batteries. Please do not dispose of the  
product in the household waste at the end  
of its useful life. Disposal can take place at  
a Braun Service Centre or at appropriate  
collection points provided in your country.  
9. Remove the processed food from the chopper  
jug. The anti-slip base also serves as an airtight lid  
for the chopper jug.  
Shakes, drinks, purées  
For purées, when very fine results are preferred, you  
may also use the handblender shaft in the jug.  
Light dough (pancake batter)  
First pour liquids into the jug, then add flour and  
finally eggs.  
Crushed ice  
(see picture section B)  
1. Place the ice crusher insert (10f) into the jug.  
Ensure it fits properly.  
2. Place the shaft of the ice blade (10e) into the  
centre hole of the ice crusher insert and press it  
down.  
3. Fill ice cubes into the ice crusher insert.  
4. Fit the gear lid on the jug.  
5. Insert the motor part into the gear lid until it locks.  
6. Keep the switch release button (2) pressed down  
and press the ON switch (3) to operate the  
chopper. After use, press buttons to remove the  
motor part. Then remove gear lid, ice blade and  
ice crusher insert.  
7. Remove the crushed ice or simply fill your drink  
into the jug for serving at the table.  
Alternative: First mix fruits in the jug with the  
chopper blade (10b), filling it up to 0.5 litres  
maximum. Remove the blade and place the ice  
crusher insert into the jug in order to crush ice  
directly into the pureed fruits.  
Download from Www.Somanuals.com. All Manuals Search And Download.  
11  
99676583/VIII-10  
China/GB  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Black Decker Power Screwdriver 618492 01 User Manual
Bose Whiteboard Accessories PDF259774_00 User Manual
Briggs Stratton Pressure Washer 020330 0 User Manual
Brother Sewing Machine 884 T09 User Manual
Canon Camera Lens EF8 15MM F 4L User Manual
Carrier Heat Pump 50QE900 250FS User Manual
Casio Calculator ClassPad OS Version 303 User Manual
Casio Calculator fx 50F User Manual
Chauvet Range 64C User Manual
Chauvet Welder F 40 User Manual