Bogen Car Speaker Model ASWB1 User Manual

Amplified Wall Baffle Speaker  
Model ASWB1  
Installation and Use Manual  
Description  
Bogen’s self-amplified wall baffle speaker is an 8-inch, cone-type loudspeaker, complete with built-in 1W amplifier and  
volume control mounted in a wood grain baffle (WB8). The ASWB1 requires 1 Current Unit (CU) of power.*  
Installation Instructions for ASWB1  
The loudspeaker should be installed at a recommended height of 8 to 12 feet above the floor, depending on need.  
Note: Do not mount the speaker near noise generating equipment (fans, motors, etc.) and do not use where a normal  
conversation cannot be conducted.  
1. Mark the point from which to hang the speaker. Drill an appro-  
WALL  
HANGER  
NOTCH  
priately sized hole in the wall and insert an anchor. Drive a  
screw into the anchor leaving approximately 1/2" of the screw  
exposed from which to hang the speaker.  
2. A. Make the power supply connections using the two screw  
terminals on the ASWB1. Connect the positive power supply  
to the terminal labeled “GND,” and the negative power sup-  
ply to the terminal labeled “-24V.”  
SCREW  
TERMINALS  
NOTE: The speaker will not be damaged if these connections  
are reversed. However, the speaker will not work.  
B. Make the audio connections using the two screw terminals  
labeled “TIP” and “RING.” When wiring more than one speak-  
er into a system, the “TIP” terminal must be wired to the other  
“TIP” terminals, and the “RING” terminal to the other “RING”  
terminals.  
NOTE: If two adjacent speakers have reversed audio wiring  
connections, they will tend to cancel each other’s bass  
response, thereby diminishing the sound quality.  
BOTTOM  
OF SPEAKER  
RECESSED VOLUME CONTROL  
Turn in a clockwise motion (as  
viewed from front of speaker)  
to increase volume.  
3. If it is necessary to adjust the volume, insert a thin, flat  
blade screwdriver into the access hole at the bottom of the  
wall baffle, then turn the volume control clockwise (as  
viewed from the bottom front of the baffle) to increase the  
volume.To reduce the volume, simply turn the volume con-  
trol counterclockwise. Be careful not to unhook the speaker  
from the wall anchor.  
© 2005 Bogen Communications, Inc.  
All rights reserved.  
Specifications subject to change without notice.  
54-2133-01B 0510  
*1CU = 50mA  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Belkin Network Card F5D6230 3 User Manual
Black Box Marine Safety Devices 1101 User Manual
Bogen Headphones HAA20 User Manual
Bowers Wilkins Speaker 600 Series 3 User Manual
Bowers Wilkins Speaker CWM7 User Manual
BOXLIGHT Projector CP 324i User Manual
Bradford White Corp Water Heater BMT2H User Manual
Braun Electric Shaver 350CC 3 User Manual
Breville Espresso Maker BES820 User Manual
Briggs Stratton Air Cleaner 441700 Series User Manual