Series
3
390cc-3
350cc-3
r
fu
ll
low
clean
p
la
e
r
c
e
8
s
m
h
o
t
n
390cc
Download from Www.Somanuals.com. All Manuals Search And Download.
A
B
3
on
full
90°
o n
o n
o f
f
o f
f
Download from Www.Somanuals.com. All Manuals Search And Download.
C
1
2
1
2
3
4
a
b
c
min
min
min
5
3 9 0 c c
s
h t
n
o
m
6
1
e
c
a
l
p e
r
c l e a n
l o w
f u l l
l o c k
3 9 0 c c
3 9 0 c c
n
o
m
s h
t
o
m
8
n
t
h
s
p
l
e c a
c l e a n
l o w
r
e
p
e c a l
f u l l
3 9 0 c c
o
m
c l e n
l o
n
s h
t
3 9 0 c c
n o m 6
p
l
e c a
h
t
c l e a n
l o w
r
e
p
l
e c a
l o c k
c l e a n
l o w
f u l l
f u l l
f u l l
l o c k
o f
f
l o c
k
4
Download from Www.Somanuals.com. All Manuals Search And Download.
5
Download from Www.Somanuals.com. All Manuals Search And Download.
6
Download from Www.Somanuals.com. All Manuals Search And Download.
7
Download from Www.Somanuals.com. All Manuals Search And Download.
8
Download from Www.Somanuals.com. All Manuals Search And Download.
9
Download from Www.Somanuals.com. All Manuals Search And Download.
10
Download from Www.Somanuals.com. All Manuals Search And Download.
English
Our products are designed to meet the
highest standards of quality, functionality and
design. We hope you enjoy your new Braun
Shaver.
Please read the use instruction carefully and
thoroughly before using the appliance.
• When charging for the first time, leave the
shaver to charge continuously for 4 hours.
Subsequent charges will take about 1 hour.
• A full charge provides up to 45 minutes of
cordless shaving time depending on your
beard growth.
• Shave without the cord. With normal use
the shaver will be charged automatically
after every cleaning in the Clean&Renew™
(see «C Clean&Renew™»).
• Maximum battery capacity will only be
reached after several charging/discharging
cycles.
Warning
Your shaving system is provided with a
special cord set, which has an integrated
Safety Extra Low Voltage power supply. Do
not exchange or tamper with any part of it,
otherwise there is risk of an electric shock.
This appliance is not intended for use by
children or persons with reduced physical or
mental capabilities, unless they are given
supervision by a person responsible for their
safety. In general, we recommend that you
keep the appliance out of reach of children.
Children should be supervised to ensure that
they do not play with the appliance.
• 5-minute quick charge (with the special
cord set (10)) is sufficient for a shave.
•
If the rechargeable batteries are discharged,
you may also shave by connecting the
shaver to an electrical outlet via the special
cord set.
Charging lights (5)
The green charging lights show the charge
status of the batteries. The green charging
light blinks when the shaver is being charged
or switched on. When the battery is fully
charged, all green charging lights shine
permanently, provided the shaver is switched
on or connected to an electrical outlet.
Description
1 Foil & Cutter cassette
2 Long hair trimmer
3 Precision setting switch («lock»)
(390cc only)
4 On/off switch
5 Charging lights (green)
6 Low-charge light (red)
7 Cleaning light (yellow)
8 Replacement light for shaving parts
(390cc only)
9 Shaver power socket
10 Special cord set
Low-charge light (6)
The red low-charge light flashes when the
battery is running low.
You should be able to finish your shave.
A Shaving
Press the on/off switch (4) to operate the
shaver (picture).
The flexible shaving foils automatically adjust
to every contour of your face (picture).
11 Travel pouch (390cc only)
12 Foil protection cap (350cc only)
Long hair trimmer (2)
To trim sideburns, moustache or beard, slide
the long hair trimmer upwards.
Charging
The best environmental temperature for
charging is between 15 °C to 35 °C. Do not
expose the shaver to temperatures higher
than 50 °C for extended periods of time.
• Using the special cord set (10), connect the
shaver to an electrical outlet with the motor
switched off.
Precision setting switch («lock») (3)
(390cc only)
For precise handling in hard to shave areas
(e.g. under the nose) slide the switch (3) to
the right to position «lock». The centre trim-
mer and one foil will be lowered.
11
Download from Www.Somanuals.com. All Manuals Search And Download.
substances. Rinse off all foam and let the
shaver run for a few more seconds.
• Next, switch off the shaver, remove the
shaver Foil & Cutter cassette (1) and let it
dry.
• If you regularly clean the shaver under
water, then once a week apply a drop of
light machine oil onto the long hair trimmer
(2) and shaver Foil & Cutter cassette (1).
Tips for the perfect shave
For best results, Braun recommends you
follow 3 simple steps:
1. Always shave before washing your face.
2. At all times, hold the shaver at right
angles (90°) to your skin.
3. Stretch your skin and shave against the
direction of your beard growth.
Alternatively, you may clean the shaver using
a brush:
• Switch off the shaver. Remove the shaver
Foil & Cutter cassette and tap it out on a
flat surface.
B Keeping your shaver in top
shape
Cleaning indicator
Your shaver should be cleaned daily in the
Clean&Renew™, and certainly when the
yellow cleaning light (7) shines constantly
after shaving. If this is not done, the yellow
light will go out after some time. The shaver’s
electronics will then assume it has been
cleaned manually and a new calculation of
the time when the next cleaning is required
will be started. During the cleaning process in
the Clean&Renew™ the yellow light will flash
and will go off after approx. 4 hours when
cleaning is finished.
• Using a brush, clean the inner area of the
shaver head. However, do not clean the
shaver Foil & Cutter cassette with a brush
as this may damage it.
Replacement light for shaving parts/Reset
(390cc only)
To maintain 100% shaving performance,
replace the shaver Foil & Cutter cassette (1),
when the replacement light for shaving parts
(8) comes on (after about 18 months) or when
worn.
The replacement light will remind you during
the next 7 shaves to replace the foil and
cutter cassette. Then the shaver will auto-
matically reset.
After you have replaced the Foil & Cutter
cassette (1), press the on/off switch (4) for at
least 5 seconds to reset the counter.
While doing so, the replacement light blinks
and goes off when the reset is complete. The
manual reset can be done at any time.
Automatic cleaning
Once the shaver is put into the
Clean&Renew™, it is cleaned automatically
(see «C Clean&Renew™»).
Manual cleaning is recommended only when
the Clean&Renew™ is not available, e. g.
when travelling.
Manual cleaning
The shaver head is suitable for
cleaning under running tap water.
Warning: Detach the shaver from the
power supply before cleaning the
shaver head in water.
Model 350cc: To maintain 100% shaving
performance, replace the shaver Foil & Cutter
cassette (1), at least every 18 months or
when worn.
Regular cleaning ensures better shaving
performance. Rinsing the shaver head under
running water after each shave is an easy
and fast way to keep it clean:
• Switch the shaver on (cordless) and rinse
the shaver head under hot running water.
You may use liquid soap without abrasive
Preserving the batteries
In order to maintain the optimum capacity
of the rechargeable batteries, the shaver
has to be fully discharged (by shaving) every
6 months approximately. Then recharge the
shaver to full capacity.
12
Download from Www.Somanuals.com. All Manuals Search And Download.
Before using Clean&Renew™
Installing the cartridge
Environmental notice
This product contains rechargeable
batteries. In the interest of protecting
the environment, please do not
dispose of the product in the house-
hold waste at the end of its useful life.
Disposal can take place at a Braun Service
Centre or at appropriate collection sites
provided in your country.
•
Press the lift button (3) to open the housing.
• Hold the cartridge down on a flat, stable
surface (e.g. table). Carefully remove the lid
from the cartridge. Slide the cartridge into
the base as far as it will go.
• Slowly close the housing by pushing it
down until it locks.
Replacing the cartridge
After having pressed the lift button to open
the housing, wait for a few seconds before
removing the used cartridge.
Before discarding the used cartridge, make
sure to close the openings using the lid of the
new cartridge, since the used cartridge will
contain contaminated cleaning solution.
The used cartridge can be disposed in the
household waste.
C Clean&Renew™
Braun Clean&Renew™ has been developed
for cleaning, charging and storing your shaver.
Clean your shaver daily in the Clean&Renew™.
During the automated cleaning process, the
shaver is switched on and off at intervals
to obtain best cleaning results. Since the
specially formulated cleaning fluid contains a
small amount of oil, the cleaning procedure
also fulfils the lubrication needs of the shaver.
Operating your
Clean&Renew™
Important
• Only use the power supply cord set
supplied with the shaver.
• Connect your Clean&Renew™ with the
cord set to the mains electricity supply.
The special socket at the back is adjust-
able to save space. After each shave,
switch the shaver off and put it into the
Clean&Renew™, upside down and with
the front showing.
• Push the start/release button (1) to lock
and connect the shaver. The cleaning
process will start. The yellow light on the
shaver will flash during the complete
process (approx. 2 minutes cleaning,
min. 4 hours drying).
• In order to avoid any leakage of the
cleaning fluid, place the appliance on a flat,
stable surface. Do not tip, move suddenly
or transport in any way if a cleaning
cartridge is installed.
• Do not place the appliance in a mirror
cabinet, nor store it over radiators, nor
place it on polished or lacquered surfaces.
Do not expose to direct sunlight.
• The appliance contains highly flammable
liquid. Keep it away from sources of
ignition. No smoking.
• Keep out of reach of children. Do not refill
cartridge. Use only original Braun refill
cartridge.
• Do not interrupt the cleaning process, as it
leaves the shaver wet and not fit for use. If
interruption is needed nonetheless, press
the start/release button (1).
• When cleaning is finished, the yellow light
will go off and the shaver is ready for use.
To release it, push the start/release button.
• A cleaning cartridge should be sufficient for
about 30 cleaning cycles. When the level
indicator (4) has reached the «min» mark,
the remaining fluid in the cartridge is
Description
1
2
3
4
5
Start/release button
Contact bow
Lift button for cartridge exchange
Level indicator
Cleaning cartridge
13
Download from Www.Somanuals.com. All Manuals Search And Download.
sufficient for about 5 more cleaning cycles.
Then the cartridge should be replaced,
when used daily approx. every 4 weeks.
• The hygienic cleaning solution cartridge
contains alcohol which, once opened,
will naturally evaporate slowly into the
surrounding air. Each cartridge, if not used
daily should be replaced after approx.
8 weeks.
• The cleaning cartridge also contains
lubricates, which may leave residual marks
on the shaver head after cleaning.
However, these marks can be removed
easily by wiping gently with a cloth or soft
tissue paper.
• Clean the housing from time to time with a
damp cloth, especially the opening where
the shaver rests.
Accessories
Available at your dealer or Braun Service
Centres:
• Foil & Cutter cassette: 32S/32B
• Cleaning cartridge Clean&Renew™: CCR
Subject to change without notice.
For electric specifications, see printing on the
special cord set.
Please do not dispose of the product
in the household waste at the end
of its useful life. Disposal can take
place at a Braun Service Centre or at
appropriate collection points provided in
your country.
99499156/IV-10
China/GB
14
Download from Www.Somanuals.com. All Manuals Search And Download.
|