1
warm fuzzy instructions
MA0410
Phone: (805) 541-2554 Fax: (805) 543-8464, 3641 Sacramento Dr. #3 San Luis Obispo, California 93401
Congratulations on your purchase of the BOB Warm Fuzzy. It is
Owner’s Manual supplied with
your stroller.
designed to provide your child with added comfort. Proper installation
and care will provide years of reliable service.
CARE INSTRUCTIONS
Before attempting to install your new Warm Fuzzy, read and
understand these instructions completely to insure proper
Hand wash warm, dry flat, do
not dry clean or iron.
installation.
If you are unclear on any point, contact your dealer or BOB before
use.
Crotch
Strap
LIMITED WARRANTY
Crotch
Buckles
Fastened
Through
Slot
Warnings
BOB Trailers Inc. takes pride
in its workmanship and strives
to manufacture the best
products possible. Therefore,
we warranty the Warm Fuzzy
against defects in material and
workmanship subject to the
conditions listed below. Since
no product is indestructible, it
does not cover defects
.
Installation of the Warm Fuzzy requires removal and reinstallation
of the safety harness straps. It is imperative the safety harness
straps are reinstalled correctly. Failure to correctly install the safety
harness can result in your child not being properly secured in the
stroller and possible injury.
Fig. 3 Crotch Strap and
Buckles Installed
.
These instructions are written specifically for the installation of the
Warm Fuzzy in a BOB Stroller. If you are installing the Warm Fuzzy
in another brand of stroller, you need to insure that it is installed
correctly and does not interfere with the proper function of the child
restraint system. Failure to do so can result in injury to your child.
attributable to or resulting from
normal wear, abuse or
alteration.
Harness
Strap
1. Figure 1 illustrates the components of the safety harness system.
To correctly install the Warm Fuzzy, you will need to first remove the
safety harness as follows:
.
The Warm Fuzzy is
Ladder-
lock
warranted for one year from
the date of original
purchase.
A) Unfasten the crotch and
.
Ladder
Locks
sternum strap buckles (note
older model strollers do not
have sternum straps).
Warranty is only valid for
the original purchaser.
Ladderlock
Upper
Ladderlock
Lower
.
Proof of purchase is
Harness
Straps
B) Remove the harness straps
from the ladderlocks by
required to exercise this
warranty.
Slot
Slot
.
threading backwards through
ladderlocks.
Labor and freight charges
Fig. 4 Install Harness Straps
are not included.
.
C) Position the straps so they
are not in the seat area where
the Warm Fuzzy will be placed.
Normal wear, neglect,
abuse, accidents, and
improper use are not
covered by this warranty.
Sternum
Strap
.
2. You are now ready to place
the Warm Fuzzy in the stroller
seat. There are three slots in
the Warm Fuzzy. Place the
Warm Fuzzy in the seat so the
two parallel slots are located
on the seat back as shown in
figure 2. Next, locate the crotch
strap in figure 2 and route it
through the single slot as
shown. Make sure harness
straps are placed above the
Warm Fuzzy.
Warranty claims must be
made through an
authorized dealer.
Buckle
Harness Strap
Through
Lower
.
This warranty is limited to
the repair or replacement
of the defective part. BOB
shall in no event be
responsible for
Crotch
Buckles
Slot
Fig. 1 Safety Harness System
consequential or special
damages.
.
This Limited Warranty is the
Upper
Slots
only express or implied
warranty applicable to
BOB. Any implied
warranties, including
warranties of
Fig. 5 Straps Installed Correctly
3. With the harness straps
above the Warm Fuzzy,
connect the crotch buckles to
the crotch strap, as shown in
figure 3. Make sure the straps
are not twisted.
merchantability and fitness
shall be limited in scope
and duration in accordance
with this limited warranty.
Harness Straps
Above Warm
Fuzzy
Crotch
4) Locate the ladderlocks
behind the upper slots in the
Warm Fuzzy, figure 2, and
expose them so you can attach
the harness strap. Attach the
harness strap by threading it
through the back of the ladder
lock upper slot as shown in
figure 4. Next thread it through
the lower slot from the front
side. Repeat this sequence for
Strap
Fig. 2 Warm Fuzzy In Seat
both ladderlocks. When installed correctly it will look like figure 5.
Fig. 6 Warm Fuzzy Correctly
Installed
5) Figure 6 shows the Warm Fuzzy and Safety Harness correctly
installed. To properly secure your child in the stroller, refer to the
Download from Www.Somanuals.com. All Manuals Search And Download.
|