12-1615.fm Page 1 Friday, August 13, 1999 9:29 AM
Cat. No. 12-1615
OWNER’S MANUAL
Please read before using this equipment.
CR-315
AM/FM Clock Radio with 1.8-Inch Display
12-1615.fm Page 3 Friday, August 13, 1999 9:29 AM
PREPARATION
Follow these steps to install the back-up
battery once you have connected the
clock to AC power.
CONNECTING POWER
To operate the clock, plug the power
cord into a standard AC outlet. The dis-
play flashes 12:00 until you set the
time (see “Setting the Time” on Page 4).
Caution: The clock radio’s AC power
cord is equipped with a polarized plug to
prevent electric shock. One blade on the
cord’s plug is wider than the other and
the plug only fits an outlet one way. if
you can not easily insert the plug, turn it
over and try again. Do not force it.
INSTALLING A BACK-UP
BATTERY
1. Press the battery compartment
cover’s tab in the direction of the
arrow, then lift off the cover to
remove it.
If AC power fails, the clock radio has a
Battery Sentinel back-up power system
that continues to operate the clock for
up to 8 hours with the display turned off
to conserve power. This lets the alarm
sound for at least 10 minutes at the set
time, even if AC power fails.
2. Snap the battery into the connector
in the battery compartment and
place the battery in the compart-
ment. The BATTERY SENTINEL
indicator turns off.
3. Replace the cover.
The BATTERY SENTINEL indicator
lights if there is either no battery in-
stalled or the installed battery requires
replacement.
Caution: Always remove an old or
weak battery. Batteries can leak
chemicals that can destroy elec-
tronic parts.
Your clock radio requires a 9-volt battery
(not supplied) for its back-up power sys-
tem. For the best performance and long-
est life, we recommend a RadioShack
alkaline battery.
Warning: Dispose of old batteries
promptly and properly. Do not bury
or burn them.
Caution: Use only a fresh battery of the
required size and recommended type.
3
12-1615.fm Page 4 Friday, August 13, 1999 9:29 AM
OPERATION
4. Rotate TUNING. A pointer indicates
the station’s frequency on the dial
below the clock.
SETTING THE TIME
To set the hour, hold down TIME and re-
peatedly press (or hold) HOUR until the
desired hour appears. PM lights to indi-
cate a PM hour.
Note: The AM antenna is built-in.
Rotate the clock radio for the best
AM reception. The AC power cord
also serves as the FM antenna. For
the best FM reception, fully extend
the AC power cord.
5. To turn off the radio, slide ALARM/
AUTO/OFF/ON to OFF.
To set minutes, hold down TIME and re-
peatedly press (or hold) MINUTE until the
desired minutes appear.
USING THE SLEEP TIMER
You can set the radio to play for up to 2
hours and then automatically turn off.
Follow these steps to set the play time.
ADJUSTING THE DISPLAY
BRIGHTNESS
1. Slide ALARM/AUTO/OFF/ON to the
desired alarm sound (AUTO for the
radio, or ALARM for the buzzer).
Set DIMMER HI/LO to HI or LO to adjust
the display’s brightness as desired.
2. To play the radio for 1 hour, press
SLEEP. The radio turns on, plays 1
hour then automatically turns off.
PLAYING THE RADIO
To set the play time between 1 and
2 hours, press SLEEP. The radio
turns on and 0:59 appears. Then
hold down SLEEP and press HOUR.
The time changes to 1:59.
1. Rotate VOLUME to the left to turn
down the volume.
2. To turn on the radio, slide ALARM/
AUTO/OFF/ON to ON.
3. Slide BAND to FM or AM then rotate
VOLUME to a comfortable listening
level.
4
12-1615.fm Page 5 Friday, August 13, 1999 9:29 AM
To decrease the play time, hold
down SLEEP and repeatedly press
MINUTE until you reach the desired
play time.
USING THE RADIO
ALARM
1. Slide
ALARM/AUTO/OFF/ON
to
3. To turn off the radio before it auto-
AUTO. At the preset alarm time, the
radio turns on for up to 1 hour, 59
minutes.
matically turns off, press SNOOZE.
Note: If you press SLEEP again, the
sleep time is reset to 0:59.
2. To turn off the radio at any time,
slide ALARM/AUTO/OFF/ON to OFF.
3. To reset the alarm, slide ALARM/
AUTO/OFF/ON to ON or AUTO (for the
radio).
SETTING THE ALARM
TIME
1. Slide ALARM/AUTO/OFF/ON to OFF.
USING SNOOZE
2. Hold down ALARM and repeatedly
press (or hold down) HOUR until you
reach the desired alarm hour. PM
lights to indicate a PM hour.
To temporarily turn off the alarm, press
SNOOZE. The alarm or radio sounds or
turns on again in about 9 minutes. Each
time you press SNOOZE, the alarm or ra-
dio turns off for another 9 minutes. The
alarm or radio continues to sound every
9 minutes until you slide ALARM/AUTO/
OFF/ON to OFF.
3. Hold down ALARM and repeatedly
press (or hold down) MINUTE until
you reach the desired alarm minute.
4. Rotate VOLUME to set the desired
alarm sound level.
To confirm the alarm time, press
ALARM.
USING THE ALARM
To set the alarm, slide ALARM/AUTO/
OFF/ON to ALARM. At the preset time,
the alarm sounds for up to 1 hour, 59
minutes then automatically turns off.
To turn off the alarm at any time, slide
ALARM/AUTO/OFF/ON to OFF. Slide it
back to ALARM or AUTO (for radio) to re-
set the alarm.
5
12-1615.fm Page 6 Friday, August 13, 1999 9:29 AM
CARE
THE FCC WANTS YOU TO
KNOW
To enjoy your AM/FM Clock Radio for a
long time:
Your clock radio might cause TV or ra-
dio interference even when it is operat-
ing properly. To determine whether your
clock radio is causing the interference,
turn off your clock radio. If the interfer-
ence goes away, your clock radio is
causing the interference. Try to elimi-
nate the interference by:
• Keep the clock radio dry. If it gets
wet, wipe it dry immediately.
• Use and store the clock radio only in
normal temperature environments.
• Handle the clock radio gently and
carefully. Don’t drop it.
• moving your clock radio away from
the TV or radio
• Keep the clock radio away from dust
and dirt.
• connecting your clock radio to an
outlet that is on a different electrical
circuit from the TV or radio
• Wipe the clock radio with a damp
cloth occasionally to keep it looking
new.
• contacting your local RadioShack
store for help
Modifying or tampering with the clock ra-
dio’s internal components can cause a
malfunction and invalidate its warranty.
If your clock radio is not performing as it
should, take it to your local RadioShack
store for assistance.
6
12-1615.fm Page 7 Friday, August 13, 1999 9:29 AM
SPECIFICATIONS
Bands ............................................................................................. AM 530–1710 kHz
FM 88–108 MHz
Power Output (maximum)............................................................................... 500 mW
Speaker ....................................... 3 Inches (7.6 cm), Ferrite, Dynamic Type, 8 ohms
Power Requirements .......................................................... 120V AC, 60 Hz, 6 Watts
Backup Battery.................................................................................................. DC 9V
7
15
8
16
Dimensions (HWD) .................................................................. 4 / × 8 / × 4 Inches
(123 × 227 × 103 mm)
Weight ....................................................................................................... 1 lb., 11 oz.
(754 g)
Specifications are typical; individual units might vary. Specifications and designs are
subject to change and improvement without notice.
7
12-1615.fm Page 8 Friday, August 13, 1999 9:29 AM
Limited Ninety-Day Warranty
This product is warranted by RadioShack against manufacturing defects in material and workman-
ship under normal use for ninety (90) days from the date of purchase from RadioShack company-
owned stores and authorized RadioShack franchisees and dealers. EXCEPT AS PROVIDED
HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES,
INCLUDING THOSE OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,
ARE LIMITED IN DURATION TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES
CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, RadioShack SHALL HAVE NO LIABIL-
ITY OR RESPONSIBILITY TO CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RE-
SPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DIRECTLY OR INDIRECTLY BY USE
OR PERFORMANCE OF THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS WAR-
RANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAMAGES RESULTING FROM INCONVE-
NIENCE, LOSS OF TIME, DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES, EVEN IF RadioShack HAS BEEN AD-
VISED OF THE POSSIBILITY OF SUCH DAMAGES.
Some states do not allow the limitations on how long an implied warranty lasts or the exclusion of in-
cidental or consequential damages, so the above limitations or exclusions may not apply to you.
In the event of a product defect during the warranty period, take the product and the RadioShack
sales receipt as proof of purchase date to any RadioShack store. RadioShack will, at its option, un-
less otherwise provided by law: (a) correct the defect by product repair without charge for parts and
labor; (b) replace the product with one of the same or similar design; or (c) refund the purchase
price. All replaced parts and products, and products on which a refund is made, become the prop-
erty of RadioShack. New or reconditioned parts and products may be used in the performance of
warranty service. Repaired or replaced parts and products are warranted for the remainder of the
original warranty period. You will be charged for repair or replacement of the product made after the
expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or attributable to acts of God, abuse,
accident, misuse, improper or abnormal usage, failure to follow instructions, improper installation or
maintenance, alteration, lightning or other incidence of excess voltage or current; (b) any repairs
other than those provided by a RadioShack Authorized Service Facility; (c) consumables such as
fuses or batteries; (d) cosmetic damage; (e) transportation, shipping or insurance costs; or (f) costs
of product removal, installation, set-up service adjustment or reinstallation.
This warranty gives you specific legal rights, and you may also have other rights which vary from
state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor, Fort Worth, TX 76102
04/99
We Service What We Sell
RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
08A99
Printed in the Philippines
|