READ AND SAVE THESE INSTRUCTIONS
TM
Coffee Maker
ADDITIONAL IMPORTANT
SAFEGUARDS
WARNING: This appliance generates heat and escaping
steam during use. Proper precautions must be taken to
prevent the risk of burns, fires, or other injury to persons or
damage to property.
• All users of this appliance must read and understand this
Owner’s Manual before operating or cleaning this appliance.
• The cord to this appliance should be plugged into a 120V AC
electrical outlet only.
• Use water only in this appliance! Do not put any other liquids or
food products in this appliance. Do not mix or add anything to
the water placed in this appliance, except as instructed in the
User Maintenance Instructions to clean the appliance.
• DO NOT attempt to move an appliance containing hot liquids.
Allow appliance to cool completely before moving.
• Keep appliance at least 4 inches away from walls or other
objects during operation. Do not place any objects on top of
appliance while it is operating. Place the appliance on a surface
that is resistant to heat.
• If this appliance begins to malfunction during use, immediately
unplug the cord. Do not use or attempt to repair the
malfunctioning appliance.
• If this appliance falls or accidentally becomes immersed in water
or any other liquid, unplug it immediately. Do not reach into the
water! Do not use this appliance after it has fallen into or has
become immersed in water. Contact Consumer Service for
examination and repair.
• Do not leave this appliance unattended during use.
• The appliance must be left to cool down sufficiently before
adding more water to avoid splattering.
• Always use fresh, cool water in your appliance.Warm water or
other liquids, except as listed in cleaning section, may cause
damage to the appliance.
• DO NOT lift Filter Basket Lid until brewing is complete, and all
parts have cooled.
• The Mugs are designed for use with this appliance. They must
never be used on a range top.
• DO NOT put mugs into a microwave.
3
SHORT CORD INSTRUCTIONS: A short power supply cord is
provided to reduce the risk resulting from becoming entangled
in or tripping over a longer cord.
Do not use an extension cord with this product.
POLARIZED PLUG: This appliance has a polarized plug, (one
blade is wider than the other). To reduce the risk of electric
shock, this plug is intended to fit into a polarized outlet only one
way. If the plug does not fit fully in the outlet, reverse the plug. If
it still does not fit, contact a qualified electrician. Do not attempt
to modify the plug in any way.
PLASTICIZER WARNING:
CAUTION: To prevent Plasticizers from migrating from the finish
of the countertop or tabletop or other furniture, place NON-
PLASTIC coasters or placemats between the appliance and the
finish of the countertop or tabletop.
Failure to do so may cause the finish to darken, permanent
blemishes may occur or stains can appear.
ELECTRIC POWER: If the electric circuit is overloaded with
other appliances, your appliance may not operate properly. It
should be operated on a separate electrical circuit from other
appliances.
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT REMOVE THE BOTTOM COVER. NO USER-
SERVICEABLE PARTS INSIDE. REPAIR SHOULD BE DONE BY
AUTHORIZED SERVICE PERSONNEL ONLY.
Before Using Your
™
Take 2 Coffee Maker
Before using your Take 2™ Coffee Maker for the first time, we
suggest you become familiar with all of its parts. Read all
instructions and cautions carefully.
CAUTION: Press the Power Switch with Indicator Light so
that the light is off. Unplug from outlet.
IMPORTANT: Never place Thermal Mugs on a hot stove or in
a microwave. Never let Thermal Mugs stand in water.
Before brewing coffee, follow instructions for cleaning. See “Care
and Cleaning,” page 7.
CAUTION: Do not immerse cord, plug, or coffee maker unit
in water or other liquids.
4
Your product may vary slightly from illustration.
Parts Identification
Water Chamber Lid
Filter
Basket
(P/N 31131)
Water Chamber
with Water Level
Indicator
Flow
Nozzle
(P/N 31130)
Filter Basket
Holder
Thermal Mug
Lids
(P/N 30909)
FIGURE B
Thermal
Mugs
(P/N
30911CHR)
Drip Tray
(P/N 31064)
Overflow
Tray
(P/N 31065)
Base
Power Switch with
Indicator Light
FIGURE A
FIGURE C
FIGURE D
5
Brewing
1. Plug into 120V ~ 60 Hz outlet.
2. Make sure unit is in the OFF position. The Indicator Light will
be off.
IMPORTANT: Place coffee maker on a level surface.
3. Markings on the Water Level Indicator indicate the amount of
water required to brew the desired number of Thermal Mugs.
Lift up the hinged Water Chamber Lid and fill to desired level
with cold, fresh water for the number of Thermal Mugs (one
or two), using the Water Level Indicator on the Water Window.
WARNING: When making one Thermal Mug, do not fill
above level 1.
IMPORTANT: If cream or milk will be added to Thermal
Mugs, use less water for brewing.
4. For optimal holding temperature, rinse the inside of Thermal
Mugs with warm water before brewing. Place Lids securely
on tops of Thermal Mugs. Press down on the Lids to ensure
proper fit.
NOTE: You can brew either one Thermal Mug or two
Thermal Mugs at once. Place Thermal Mugs snugly on
Base of unit as shown in Figure A (for two Thermal Mugs)
or Figure D (for one Thermal Mug). The contoured design
on the Base should be used as a guide for Thermal Mug
alignment.
5. Insert a #2 paper cone filter into the Removable Filter Basket
and add coffee grounds. Use approximately 1-1/2 to 2
tablespoons for each Thermal Mug of coffee. Close Water
Chamber Lid.
6. Press Power Switch ON. The Indicator Light will turn on.
CAUTION: Avoid contact with heated water.
IMPORTANT: Do not remove Thermal Mugs until the
Indicator Light has turned OFF. The Indicator Light will
turn OFF approximately two minutes after brewing is
complete. This delay will allow the last drops of coffee to
flow into the Thermal Mugs.
7. After Indicator Light turns off, Thermal Mugs may be safely
removed.
8. If brewing more than one cycle, allow unit to cool for 10
minutes between cycles.
6
Helpful Hints for Brewing
• Always use fresh, cold water for brewing. In areas with hard
water or where water contains a high mineral content, use
cold filtered water for optimal coffee taste.
• For best results, use Melitta® #2 paper cone filters and
Melitta® Premium Fine Grind Roast Coffee.
• The markings on the Water Level Indicator reflect the quantity
of fresh water to be used. The quantity of brewed coffee is
less because the coffee grounds absorb water.
Care and Cleaning
1. Make sure Power Switch is in the OFF position. The Indicator
Light will be off.
2. Unplug and allow to cool completely before cleaning.
3. Open Water Chamber Lid and lift up on the tab of Filter
Basket. Discard any paper filter and coffee grounds.
4. Remove Flow Nozzle by pulling down away from the Filter
Basket Holder.
5. Wash removable Filter Basket, Drip Tray and Overflow Tray,
Flow Nozzle, Mugs and Mug Lids in warm, soapy water. Rinse
and dry thoroughly. Or, you may wash the Mugs and Lids in
the top rack of a dishwasher.
6. Clean the outside of the coffee maker with a damp cloth.
CAUTION: DO NOT IMMERSE CORD, PLUG OR COFFEE
MAKER UNIT IN WATER OR OTHER LIQUID.
7. Replace Filter Basket, Flow Nozzle, Drip Tray and Overflow
Tray for next use.
7
Descaling
We recommend that you descale your coffee maker once a month
because mineral deposits can form a coating in the coffee maker,
causing slower brewing time and possibly an off flavor in the
coffee. Use a cleaner recommended for coffee makers. To
descale your unit:
1. Pour two ounces of vinegar or coffee cleaner into the Water
Chamber. Add cold water to the level 2 indicator.
2. Place a clean #2 paper cone filter in the filter basket and close
Water Chamber Lid. Place both Mugs in proper position on
Base of unit.
3. Follow “Brewing” instructions (without coffee).
4. When the Indicator Light turns off, wait 15 minutes and pour
solution from Mugs back into coffee maker. Be sure that the
Filter Basket is still in proper position.
5. Turn unit on again. Allow all solution to empty into Mugs.
When Indicator Light turns off, discard solution.
6. Allow unit to cool 10 minutes. To rinse unit, fill Water Chamber
with fresh, cold water up to the level 2 indicator. Insert a fresh
paper filter into Filter Basket. Close Water Chamber Lid.
Place both Mugs in proper position on Base of unit and turn
Power Switch on.
7. At end of cycle, allow unit to cool, discard water and paper
filter.Wash and dry Mugs and other removable parts.
8. Unplug coffee maker from outlet. When coffee maker has
cooled, wipe exterior with a damp cloth.
8
LIMITED ONE-YEAR WARRANTY
Warranty Coverage: This product is warranted to be free from defects in
materials or workmanship for a period of one (1) year from the original purchase
date. This product warranty is extended only to the original consumer
purchaser of the product and is not transferable. For a period of one (1) year
from the date of original purchase of the product, our Repair Center will, at its
option, either (1) repair the product or (2) replace the product with a
reconditioned comparable model. These remedies are the purchaser's exclusive
remedies under this warranty.
Warranty Service: To obtain warranty service, you must call our warranty
service number at 1-800-233-9054 for return instructions on how to deliver the
product, in either the original packaging or packaging affording an equal degree
of protection to the Repair Center specified below. You must enclose a copy of
your sales receipt or other proof of purchase to demonstrate eligibility for
warranty coverage.
To return the appliance, ship to:
To contact us, please write to, call, or email:
ATTN: Repair Center
708 South Missouri Street
Macon, MO 63552 USA
Consumer Relations Department
PO Box 7366
Columbia MO 65205-7366 USA
1-800-233-9054
E-mail:[email protected]
What Is Not Covered: This warranty does not cover damage resulting from
misuse, accident, commercial use, improper service or any other damage
caused by anything other than defects in material or workmanship during
ordinary consumer use. This warranty is invalid if the serial number has been
altered or removed from the product. This warranty is valid only in the United
States and Canada.
LIMITATION ON DAMAGES: THERE SHALL BE NO LIABILITY FOR ANY
INCIDENTAL OR CONSEQUENTIAL DAMAGES FOR BREACH OF ANY
EXPRESS OR IMPLIED WARRANTY OR CONDITION ON THIS PRODUCT.
DURATION OF IMPLIED WARRANTIES: EXCEPT TO THE EXTENT
PROHIBITED BY APPLICABLE LAW, ALL IMPLIED WARRANTIES AND
CONDITIONS, INCLUDING, WITHOUT LIMITATION, IMPLIED WARRANTIES
AND CONDITIONS OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR
PURPOSE OR USE ON THIS PRODUCT ARE LIMITED IN DURATION TO THE
DURATION OF THIS WARRANTY.
Some jurisdictions do not allow the exclusion or limitation of incidental or
consequential damages, or allow limitations on how long an implied warranty
lasts, so the above limitations or exclusions may not apply to you. This
warranty gives you specific legal rights and you may have other rights under the
laws of your jurisdiction.
For more information on our products, visit our website:
©2005 All rights reserved.
Made in China
P/N 61384CHR
7/05
|