Braun KF 185 User Manual

AromaSelect  
12  
Helpline  
Should you require any further assistance please call  
Braun (UK) Customer Relations on  
0 19 32 / 79 22 33.  
KF 185  
Type 3116  
Coffeemaker  
Internet:  
English  
Use Instructions  
Guarantee  
Service Centers  
Note: If the power supply is interrupted or the plug  
is pulled out of the socket, the clock will run for a fur-  
ther 15 minutes. All programmed function are also  
stored for 15 minutes.  
After having installed a new water filter cartridge,  
allow the maximum amount of fresh, cold water to  
run through the coffeemaker.  
To activate automatic operation, briefly press the  
button «automatic» s. The green control lamp r  
lights up, the pre-set brewing, time is briefly shown  
on the display m. Brewing automatically begins at  
the pre-set time.  
When the brewing process begins, the green control  
lamp rgoes off and the control lamp ulights up red  
to indicate that brewing has begun.  
manually, press the «on/off» button t. The control  
lamp ulights up red briefly and all control lamps  
then go off.  
In order to ensure the proper functioning of the filter  
cartridge, exchange it after 2 months of regularly  
using the coffeemaker. In order to remind you to  
replace the filter in time, you may set the dial d  
incorporated in the cover of the water container to  
the month when the cartridge has to be exchanged.  
Ajustable heating temperature  
Filling with coffee grounds  
Swing out the filter holder 8(a) and insert the filter.  
The heating temperature can be adjusted approxi-  
mately 5 °C using the knob «–temp.+» l. To reduce  
the temperature, turn the knob anti-clockwise. To  
increase the temperature, turn the knob clockwise.  
Put coffee grounds (not ground too finely) into the  
filter and close the filter holder again (a) until it  
snaps in place. Measure coffee according to the  
strength desired.  
If, for instance, you want to make coffee at the same  
time on the following day, you must activate the  
automatic operation again (see above). However,  
this should only be done after brewing is finished or  
the programmed time for the hotplate switch-off  
(when none of the control lamps are on), as you  
could otherwise interrupt brewing or switch off the  
hotplate 9.  
Dial for water filter exchange  
Keeping the coffee hot  
After having installed a new filter cartridge, set the  
dial d2 months furhter by turning it from the reverse  
side of the water container cover.  
The carafe can remain on the hotplate 9which  
begins to heat up when the coffeemaker is switched  
on and will keep the coffee hot until the coffeemaker  
is switched off (red control lamp goes out).  
Filling with water  
Important: When filling with water and during coffee  
preparation either the space compensator 4or the  
water filter cartridge Dmust be installed in the  
water container 3. Otherwise the water level indica-  
tor 2will not function correctly and the carafe may  
overflow.  
Pre-selecting the taste – AromaSelect dial  
By adjusting the AromaSelect dial 5, you can adjust  
the taste of your coffee to suit your personal prefer-  
ence – milder with less bitter aftertaste or stronger,  
but always with the same full flavour. The Aroma-  
Select dial 5can be adjusted in two different ways,  
both before you turn on the coffeemaker. With the  
water container lid closed, grasp the dial by the two  
raised grip points and turn in the desired direction.  
Alternatively, with the water container lid open, turn  
the dial with the attached L-shaped grip.  
Making coffee  
Automatic hotplate switch-off  
Place the carafe with the lid on onto the hotplate 9  
and snap the filter holder 8in place. Switch the  
coffeemaker on as described. Brewing time is  
approx. 50 seconds per cup (including dripping).  
A «drip stop» prevents dripping when lifting off the  
Carafe shortly. Remove the filter holder 8to empty  
grounds (see section «Cleaning»).  
The temperature sensor jin the hotplate 9regu-  
lates the temperature of the coffee irrespective of  
the amount in the jug. The coffeemaker can be set  
to stay hot after brewing for up to 4 hours. Press  
the «on/off» button tuntil the control lamp u  
begins to flash red and the heating time appears on  
the display m. Release the «on/off» button tand  
set the desired heating time with the buttons «h» n  
and «min» ofrom 3 hours 59 minutes to 0 hour 00  
minutes. When the control lamp ushining red goes  
off, the pre-set heating time is stored in the memory  
and the display shows the time of day again.  
Fill the water container with as much cold water as  
coffee is required. To do this, lift the cover for the  
water container 6and pour the cold water into the  
water container 3. The amount of water is shown on  
the water level indicator 2(maximum 12 cups –  
125 ml each).  
Space compensator  
Brewing small amounts  
(1- 3 cups – 125 ml each)  
The space compensator 4in the water container 3  
takes up the space which is intended for the water  
filter cartridge D. Unless the water filter cartridge is  
installed in the water container, the space compen-  
sator must always be inside the water container  
when filling with water and brewing to avoid overfil-  
ling. Keep the space compensator as it has to be  
installed in the water container if you have to decal-  
cify your coffeemaker.  
If you prefer milder coffee with less bitter aftertaste,  
turn the AromaSelect dial 5in the direction of the  
symbol (b). Should you prefer a more stronger  
taste, turn the AromaSelect dial towards the  
symbol. Regardless of the position you select, the  
coffee will always have the same full coffee flavour  
only a milder or stronger aftertaste. With the cover  
of the water container closed, the selected setting  
can always be seen (c).  
Switch the coffeemaker on with the «on/off» button  
t. The control lamp ulights up red.  
Press the button «1-3  
lamp plights up.  
» q. The yellow control  
After the brewing process, the control lamp ulights  
up green until the coffeemaker is automatically  
switched off at the end of the heating time. A double  
beep can be heard and all control lamps go off.  
This indicates that the function for brewing small  
amounts is activated and the coffeemaker is in  
operation. Brewing will begin.  
Cleaning  
Water filter cartridge  
Manual operation  
The facility for brewing small amounts can be pre-set  
in the automatic operation mode. Press briefly the  
«automatic» button s. The control lamp rlights up  
Always pull the plug out of the socket before clean-  
ing (all programmed functions are stored for approxi-  
mately 15 minutes). The appliance should never be  
immersed into water. Swing out the filter holder 8  
and pull it off upwards from the filter support bracket  
7(e). To replace, set the curved protruding rim of  
the filter holder 8on top of support bracket 7. Be  
sure that the rib under the rim of the filter holder 8  
fits snugly into the groove on the support bracket 7  
so that the filter holder 8fits nearly into place and  
so the filter holder closes easily into the machine.  
To wash, take the lid off the carafe (d). The carafe,  
lid and filter holder can be cleaned in the dishwasher  
All other parts should be cleaned will a damp cloth  
only. After cleaning, put the lid back on the carafe  
(d). Clean the hotplate 9with liquid cleansers only.  
Do not use abrasive cleansers. The filter support  
bracket 7can be taken off for cleaning. Swing it out,  
push it up and pull it off diagonally downwards (f).  
To replace, insert the top first.  
The water filter cartridge Dis suitable for drinking-  
water only. It gives your purer tasting coffee by  
removing chlrorine, bad tastes and odors as well as  
scale. Provided the cartridge is regularly replaced,  
it provides not only better tasting coffee, but also  
can increase the life of your coffeemaker by prevent-  
ing calcification.  
To switch on, press the «on/off» button t.  
The control lamp uwill light up red indicating that  
the coffeemaker is switched on and brewing is in  
process. To switch off the coffeemaker, press the  
«on/off» button t. The red control lamp uwill  
briefly flash and all control lamps will go off.  
green. Then press the button «1-3  
» qand the  
yellow control lamp pligts up.  
The coffeemaker will only brew small amounts of  
coffee in this mode if both the «1-3 cups» facility  
and the timing are pre-set.  
Automatic operation  
Installing the water filter cartridge  
Unpack the water filter cartridge D. Then put the fil-  
ter cartridge for 10 minutes in a receptable filled with  
water.  
To programme the automatic operation, press the  
«automatic» button suntil the green control lamp r  
begins to flash. Three noughts or the previously pro-  
grammed time appear on the display m.  
This function can be switched on or off during the  
brewing process. To switch off the function for small  
amounts, press the button «1- 3  
control lamp pwill go off.  
» q. The yellow  
.
Remove the space compensator 4from the water  
container and replace it by the water filter cartridge  
D. Make sure to keep the space compensator  
as it could be needed if you do not use the water filter  
any longer at a future point in time or for  
decalcification.  
When the green control lamp rbegins to flash,  
release the button sand, as described under  
«Setting the clock», programme the time for  
automatic operation by pressing the buttons «h» n  
and «min» o. After programming is completed, the  
green control lamp rwill go off after 5 seconds.  
Audio-visual «coffee ready» signal  
The signal indicates that brewing is finished and the  
water has run through the filter. The coffeemaker  
beeps 5 times and the control lamp uchanges from  
red to green. To switch off the coffeemaker  
4
5
Decalcifying  
If you are using vinegar essence, please proceed as  
follows:  
Guarantee  
If you have hard water and you use your coffee-  
maker without a water filter, it has to be decalcified  
regularly. The frequency depends on the hardness  
of your water and how often you use your coffee-  
maker. When using the water filter cartridge Dand  
exchanging it regularly, you normally will not need to  
decalcify.  
We grant a 1 year guarantee on the product com-  
mencing on the date of purchase.  
1. Fill the water container 3to the mark for 3 cups  
with cold water.  
Within the guarantee period we will eliminate, free of  
charge, any defects in the appliance resulting from  
faults in material or workmanship either by repairing,  
or exchanging parts or exchanging the whole  
appliance as we may choose.  
2. Add vinegar essence to the mark for 6 cups.  
3. Place the carafe with the lid onto the hotplate 9,  
close the filter holder 8(without any type of filter)  
and switch on the coffeemaker.  
However, if it is necessary to decalcify the coffee-  
maker, the decalcifying indicator «calc» kwill flash  
red when the coffeemaker is switched on. When the  
programmed heating time is over or the coffeemaker  
is switched off manually, the indicator «calc» will go  
off, together with the control lamps.  
Not covered by this guarantee: damage arising from  
improper use (operation with incorrect current/  
voltage, plugging it into an unsuitable power point,  
breakage), normal wear and defects which have a  
negligible effect on the value or operation of the  
appliance.  
4. Allow the decalcifying solution to run through.  
5. Repeat this procedure at least three times with a  
newly prepared descaling solution, in order to  
remove all calcium residues.  
Important: Replace the water filter by the space  
compensator 4for any decalcifying procedure.  
When decalcifying, turn the AromaSelect dial 5to  
The guarantee becomes void if repairs are under-  
taken by unauthorized persons and if original Braun  
parts are not used.  
6. Allow the maximum amount of fresh cold water  
to run through at least twice to cleanse the  
machine.  
the  
symbol.  
You can either use a commercially available decalci-  
fying agent which does not affect aluminium, or vine-  
gar essence, available in food stores.  
The guarantee only comes into force if the date of  
purchase is confirmed by the dealer's stamp and sig-  
nature on the guarantee card and registration card.  
1. Follow the instructions of the manufacturer of the  
decalcifying agent.  
This guarantee extends to every country where this  
appliance is supplied by Braun or its appointed dis-  
tributor and where no import restrictions or other  
legal regulations hinder or prevent service being  
given under guarantee.  
2. Repeat the procedure at least twice with a newly  
prepared decalcifying solution, in order to ensure  
that all calcium residues have been removed.  
Subject to change without notice.  
Service under the guarantee does not affect the  
expiry date of the guarantee. The guarantee on parts  
or entire appliances which are exchanged ends  
when the guarantee on this appliance expires.  
3. Allow the maximum amount of fresh cold water  
to run through at least twice to cleanse the  
machine.  
This product conforms to the  
EMC-Requirements as laid down by the  
Council Directive 89/336/EEC  
In the event of a claim under this guarantee, hand in  
the complete appliance with the valid guarantee  
card to your dealer, or send both to the nearest  
Braun Customer Service Centre.  
All other claims including for damages resulting from  
this guarantee are excluded unless our liability is  
legally mandatory.  
Those claims arising out of the sales contract with  
the vendor are not affected by this guarantee.  
For UK only:  
This guarantee in no way affects your rights under  
statutory law.  
6
7

Motorola I420 User Manual
LG Electronics VI 125 User Manual
Kyocera Cell Phone DURAMAX BY KYOCERA User Manual
HTC ROSE100 User Manual
Hamilton Beach 43324 User Manual
Fellowes P 35C User Manual
Dell GX240 User Manual
Aluratek AIRMM01F User Manual
Alpine CDE 9872 User Manual
Aleratec Copy Dock 1_3 Hard Drive Duplicator 350117 User Manual