BASIC OPERATION
Installation A
Installation B
Installation C
For Cisco models 7940 or higher
with a headset port
For phones without headset ports
For phones with headset ports
(Cisco phones see Installation C)
Charge headset in base for 4 hours
before first use. The multifunction
button on the headset will turn green
when fully charged. After use, this light
will turn red. It is not necessary for the
light to turn green to use the headset.
BLUEPARROTT B200
Controls & Components
Microphone Adjustment: To ensure
proper microphone performance, do the
following.
Pairing button
Multifunction button / Indicator lights
1. The microphone has
the word TALK or a dot
printed or embossed
on it (under the
Volume increase / Microphone mute
Volume decrease
Handset active
indicator light
cushion). This mark
must face your mouth.
Headset active indicator light
Standby/Pairing indicator lights
USE T-CORD
USE T-CORD
USE PATCH CORD
2. For quality sound and effective
background noise cancellation, position
microphone a finger’s width away from
your face just below your bottom lip.
The microphone is sensitive, minor
adjustments may be needed to achieve
optimum voice quality.
1. Remove handset cord from phone’s base.
2. Plug short end of T-cord into now empty
1. Leave handset plugged into your phone.
1. Leave handset plugged into your phone.
2. Plug the blue-banded end of the patch cord
The headset battery charges
continuously while the
headset is in the base.
2. Plug short end of T-cord into headset
port on phone.
Microphone volume adjustment
(located under base)
handset port
on phone.
into the headset
port on your phone.
3. Plug longer end of T-cord into port on B200
base marked “Phone” . Thread cord under
hook.
3. Plug longer end of T-cord into port on B200
base marked “Phone” . Thread cord under
hook.
3. Plug other end of the patch cord into port
Standby/Talk Time Modes: The headset
is in standby mode whenever you see a
slow-flashing yellow light on the headset
and the handset icon is lit on the front
on the B200 base marked “Phone”
Thread cord under hook.
.
AC adapter
Patch cord
4. Plug handset cord into port on T-cord.
5. Plug ACadapter into port on B200 base
4. Plug ACadapter into port on B200 base
4. Plug ACadapter into port on B200 base
marked and then plug AC adapter into the
wall electrical outlet.
of the base. If the headset icon
is lit,
T-cord
marked
and then plug AC adapter into
then the headset is active and Talk Time
is being used (even if you are not on a call).
the wall electrical outlet.
Cord wraps
marked
and then plug AC adapter into
the wall electrical outlet.
|