Opacity Shield Kit (JH063A) Installation Instructions-5P100
BOM: 3105A033
Part number: 5998-6342
HP 5900 and HP FlexFabric 5700 switches meet the requirement of FIPS security
level 2.
Make sure the operating temperature is not higher than 40°C (104°F).
Ensure enough clearance for installation.
Face the front of the chassis to locate the installation positions (left and right).
If the device has been mounted in a rack, remove it from the rack.
Components of the opacity shield kit
Installing the opacity shield
Opacity shield
(1 in total)
M3 hex bolt
(3 in total)
M3 countersunk-head
screw (3 in total)
Only use the screws and hex bolts that are supplied in the opacity shield kit to
secure the opacity shield.
Tamper evidence label
12 mm (0.47 in)
60 mm (2.36 in)
Tamper evidence labels do not come with the FIPS opacity shield kit. You must
order them from HP by using the product code JG585A (30 count) or JG586A
(100 count).
Remove the three screws from the top of the chassis.
Applicable products
HP 5900AF-48G-4XG-2QSFP+ Switch (JG510A)
HP 5900AF-48G-4XG-2QSFP+ TAA-compliant Switch (JH038A)
M3 countersunk-
head screw
HP FlexFabric 5700-48G-4XG-2QSFP+ Switch (JG894A)
HP FlexFabric 5700-48G-4XG-2QSFP+ TAA-compliant Switch (JG895A)
Preparing for installation
M3 hex bolt
The installation procedures must be performed by qualified personnel.
Before installation, read the compliance and safety manual for the compatible
device of the FIPS opacity shield kit.
Wear an ESD wrist strap, and make sure the wrist strap makes good skin
contact and is reliably grounded.
Attach the opacity shield to the top of the chassis.
|