R
+
SWRHN-62B
RADIO REPLACEMENT
SWC RETENTION
Radio Replacement with Steering Wheel Retention for
Select HONDA Vehicles
INTERFACING SOLUTIONS
PRODUCT FEATURES:
- Retains factory features in select Honda vehicles while functioning with an aftermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- Retains Factory Auxiliary Input.
- Includes Antenna Adapter.
- EIA color coded wiring for easy installation.
NOTES:
1. Does not support amplified systems.
2. Does not retain Rear Seat Entertainment system (RSE).
3. Does not retain factory navigation system.
PARTS INCLUDED:
SWRHN-62B MODULE
SWRHN-62B HARNESS
ANTENNA ADAPTER
SWC CABLE
INSTALLATION DIAGRAM:
12V Constant
+12V ACC
Ground
Yellow
Red
Black
AFTERMARKET
RADIO
Amplifier Turn On
Illumina�on (+)
Illumina�on (-) (Not Used)
Right Front (+)
Right Front (-)
Blue/White
Orange/White
Orange/Black
Gray
Gray/Black
White
Le� Front (+)
Le� Front (-)
Right Rear (+)
Right Rear (-)
Le� Rear (+)
White/Black
Violet
Violet/Black
Green
HONDA
SWC SETTING
(OFF ON ON OFF)
AFTERMARKET
RADIO SELECTOR
(See Chart)
Le� Rear (-)
Vehicle Speed Sense (VSS) White/Green
Security Signal (Not Used)
Aux Detect (Ac�ve-Low)
Green/Black
ON RADIO VEHICLE
SWC
MODULE
Brown
Red/Black
12-Pin Black
Connector
1
2
3
4
5
6
7
8
K Line (Not Used) Yellow/Black
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS”section.
TO FACTORY
HARNESS
4-Pin
Connector
Insulate with tape
if not being used
BLUE / YELLOW (for Kenwood & JVC)
BLUE / Power Antenna
rev.020420
1 of 2
Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
|