Ryobi Battery Charger Ap4001 User Manual

OPERATOR’S MANUAL  
Tek4® Lithium-ion  
4 volt Battery Pack  
AP4001  
skin, wash immediately with soap and water. If liquid  
gets into your eyes, flush them with clean water for at  
least 10 minutes, then seek immediate medical attention.  
Following this rule will reduce the risk of serious personal  
injury.  
Save these instructions. Refer to them frequently and use  
them to instruct others who may use this product. If you loan  
someone this product, loan them these instructions also.  
WARNING!  
Read and understand all instructions. Failure to follow  
all instructions listed below, may result in electric shock,  
fire and/or serious personal injury.  
Battery products do not have to be plugged into an  
electrical outlet; therefore, they are always in operating  
condition. Be aware of possible hazards when battery  
products are not in use, or when changing accessories.  
Following this rule will reduce the risk of electric shock, fire,  
or serious personal injury.  
Do not place battery products or their batteries near fire  
or heat. This will reduce the risk of explosion and possibly  
injury.  
COLD WEATHER OPERATION  
The lithium-ion battery pack can be used in temperatures down  
to -4°F. Put the battery pack in a product and use the product in  
a light duty application. After about a minute, the pack will have  
warmed up and begin operating normally.  
BATTERIES  
Thesebatterieshavebeendesignedtoprovidemaximumtrouble-  
free life. However, like all batteries, they will eventually wear out.  
Do not disassemble battery pack and attempt to replace the  
batteries. Handling of these batteries, especially when wearing  
rings and jewelry, could result in a serious burn.  
To obtain the longest possible battery life, we suggest the  
source  
following:  
Do not crush, drop or damage battery pack.  
Do not use a battery pack or charger that has been  
dropped or received a sharp blow. A damaged battery  
is subject to explosion. Properly dispose of a dropped or  
damaged battery immediately.  
Batteries can explode in the presence of  
a
of ignition, such as a pilot light. To reduce the risk of  
serious personal injury, never use any cordless product  
in the presence of open flame. An exploded battery can  
propel debris and chemicals. If exposed, flush with water  
immediately.  
Remove the battery pack from the charger once it is fully  
charged and ready for use.  
For battery pack storage longer than 30 days:  
Store the battery pack where the temperature is below 80°F  
and away from moisture.  
Store battery packs in a 30%-50% charged condition.  
Every six months of storage, charge the pack as normal.  
BATTERY PACK REMOVAL AND PREPARATION FOR  
RECYCLING  
This product contains lithium-ion batteries. Local, state or  
federal laws may prohibit disposal of lithium-ion batteries in  
ordinary trash.  
Do not charge battery products in a damp or wet location.  
Following this rule will reduce the risk of electric shock.  
Use battery products only with specifically designated  
battery packs. Use of any other battery packs may create a  
risk of injury and fire.  
Use battery only with charger listed. For use with 4V  
lithium-ion battery packs, see tool/appliance/battery  
pack/charger correlation supplement 988000-312.  
When battery pack is not in use, keep it away from other  
metal objects like: paper clips, coins, keys, nails, screws,  
or other small metal objects that can make a connection  
from one terminal to another. Shorting the battery terminals  
together may cause sparks, burns, or a fire.  
For best results, your battery product should be charged  
in a location where the temperature is more than 50°F but  
less than 94°F. To reduce the risk of serious personal injury,  
do not store outside or in vehicles.  
Under extreme usage or temperature conditions, battery  
leakage may occur. If liquid comes in contact with your  
WARNING:  
Upon removal, cover the battery pack’s terminals with heavy-  
duty adhesive tape. Do not attempt to destroy or disassemble  
battery pack or remove any of its components. Lithium-ion  
batteries must be recycled or disposed of properly. Also,  
never touch both terminals with metal objects and/or body  
parts as short circuit may result. Keep away from children.  
Failure to comply with these warnings could result in fire  
and/or serious injury.  
endommagé de quelque façon que ce soit. Une bloc-pile  
endommagée risque d’exploser. Éliminer immédiatement  
toute bloc-pile endommagée, selon une méthode appropriée.  
Les bloc-piles peuvent exploser en présence d’une source  
d’allumage, telle qu’une veilleuse. Pour réduire les risques  
de blessures graves, ne jamais utiliser un appareil sans fil, quel  
qu’il soit, en présence d’une flamme vive. En explosant, une  
bloc-pile peut projeter des débris et des produits chimiques.  
En cas d’exposition, rincer immédiatement les parties atteintes  
avec de l’eau.  
MANUEL D’UTILISATION  
Tek4® Blocs-piles de 4 V lithium-ion AP4001  
AVERTISSEMENT !  
Lire et veiller à bien comprendre toutes les instructions.  
Le non respect de toutes les instructions ci-dessous peut  
entraîner un choc électrique, un incendie et/ou des blessures  
graves.  
Ne pas recharger le bloc-piles dans un endroit humide ou  
mouillé. Le respect de cette règle réduira les risques de choc  
électrique.  
Utiliser exclusivement le bloc de pile spécifiquement  
indiqué pour l’outil. L’usage de tout autre bloc peut créer  
un risque d’incendie.  
Ne recharger les piles qu’avec l’appareil indiqué. Pour  
utiliser l’appareil avec des piles au lithium-ion de 4 V,  
consulter le supplément de raccordement pour chargeur/  
outils/piles/appareil ˚ 988000-312.  
Lorsque le bloc-piles n’est pas en usage, le tenir à l’écart  
d’articles métalliques tels que : Les attaches trombones,  
pièces de monnaie, clous, vis et autres petits objets  
Les outils fonctionnant sur bloc-piles n’ayant pas besoin  
d’être branchés sur une prise secteur, ils sont toujours  
en état de fonctionnement. Tenir compte des dangers  
possibles lorsque l’outil n’est pas en usage et lors du  
remplacement des accessoires. Le respect de cette  
consigne réduira les risques d’incendie, de choc électrique  
et de blessures graves.  
Ne pas placer les outils électriques sans fil ou leurs bloc-  
piles à proximité de flammes ou d’une source de chaleur.  
Ceci réduira les risques d’explosion et de blessures.  
Ne pas écraser, faire tomber ou endommager le bloc-piles.  
Ne jamais utiliser un bloc-piles ou un chargeur qui est  
tombé, a été écrasé, a reçu un choc violent ou a été  

Mitsubishi Electronics Peh 15 User Manual
Olympus B 20 Lpc User Manual
Samsung Aq18a9 0 Rcf User Manual
Samsung Aw07ph Series User Manual
Samsung Std 24b User Manual
Sanyo Eco G Sgp We170m1 User Manual
Sanyo Rcs Sh80ug User Manual
Studer Innotec Xth 6000 48 User Manual
Xerox Workcentre M15i User Manual
York Predator 120 User Manual