®
WINEGARD
Model TR-3535 Tripod Mount
BUBBLE
LEVEL
PARTS INCLUDED:
ELEVATION ANGLE
Depending on your location, satellites will be at an elevation
angle between 30° and 60°. Southern states point more
toward 60°, northern states point more toward 30°.
FINDING THE SATELLITE
(3) STAKES
1. Be sure to connect the cables to the TV, receiver and
antenna before accessing satellite signal, and connect to
your power source.
TRIPOD
2. Check the instruction manual that came with your
receiver to determine how to access the on-screen signal
meter.
*STORAGE BAG AND
SATELLITE COMPASS
Not Shown
The signal meter shows you when you have locked onto
a satellite broadcast signal and gives the signal strength.
Be sure you select your type of dish antenna — pointing
coordinates will depend on the type of dish you have.
(3) LEG
EXTENSIONS
PIVOT
FOOT
3. Azimuth value is determined by the local zip code of
your location. Enter into your receiver menu.
ONE TIME ASSEMBLY: Remove contents from carton.
4. Rotate compass dial until azimuth value aligns with the
blue arrow.
Assemble each of the three legs by inserting the leg
extension into the attached leg until the leg extension locks
into place. See Figure 1.
5. Turn compass to align red pointer arrow to red “N”.
6. Point satellite dish in same direction as the blue arrow.
SET UP:
TO STORE THE TR-3535
1. Set all three legs to the
desired position by pinching the
Use these
extra holes
1. Remove the reflector.
tabs holding the legs in place
and moving the leg extension
until it locks into the desired
position.
determine
the optimal
height
2. Loosen the leg bracket knobs and collapse the three
legs into the folded position.
3. Pinch the tabs holding the leg in the extended position
and slide the leg extension back into the leg until it locks in
the storage position. See Figure 3.
setting.
2. Set up tripod in an area
with a clear view of the sky —
south west or south-southeast,
depending on your location in
the continental U.S.
4. Tighten the knobs and store the tripod.
3. Place bubble level on top of
mount pipe and loosen the lock
knobs on the adjustable legs.
Pinch
Tabs
Fig. 3
Fig. 1
4. Slide the legs towards or
away from the center of the unit
until the tripod is level.
TR-3535 IN
STORAGE POSITION
4. After leveling, tighten the
lock knobs and remove bubble
level.
5. Slide satellite antenna*
onto pole and secure it
to the pole. Use ground
stakes to stabilize mount if
necessary.
Fig. 2
*Compatible with all DISH®, SHAW DIRECT and BELL
TV™ antennas. Compatible with all DIRECTV® antennas
except the Slimline.
PUT STAKE
THROUGH
HOLE IN PIVOT
FOOT AND
PUSH INTO
GROUND.
See Figure 2.
Download from Www.Somanuals.com. All Manuals Search And Download.
|