Battery installation and Make, answer and end a call Outgoing announcement
charging
The telephone is preset with a greeting that
Make a call
answers calls with “Hello, please leave a
Install the battery as shown below. After
1. Press
/FLASH or
.
message after the tone.” You can use this
preset announcement, or replace it with
your own.
installing the battery, you might be able
to make and receive short calls. For best
performance, charge the handset battery for
at least 16 hours before use.
2. Dial the number.
-OR-
Quick start guide
for models LS6125/LS6125-2/
LS6125-3/LS6125-4/LS6125-5/
LS6126-3/LS6126-5
To record your own announcement:
1. Dial the number.
2. Press
/FLASH or
.
1. Press ANNC while the telephone is not
in use and the system will announce
“Announcement. Press PLAY or press
RECORD.”
1
2
Install the telephone base and
charger(s)
Plug the battery securely Place the battery with the
into the plug inside
the handset battery
compartment, matching the battery compartment.
the color-coded label.
label THIS SIDE UP facing
up and the wires inside
2. Press RECORD and the system
announces, “Record after the tone. Press
STOP when you are done.”
Install the telephone base and charger(s) as
shown below.
Telephone
wall jack
Charger
adapter
(small)
Telephone base
power adapter
(large)
3. After the tone, speak towards the
microphone at the bottom front of
the telephone base from about nine
inches away.
Answer a call
DSL filter (not
included) required
if you have DSL
high-speed
• Press
keys (0-9, #, ).
/FLASH,
or any of the dialing
*
Internet service
4. Press /PLAY/STOP when finished.
End a call
5. The answering system will automatically
play the newly recorded announcement.
Press /PLAY/STOP to stop the playback
at anytime.
Electrical outlet
Telephone line cord
not controlled
• Press OFF/CLEAR or put the handset in
the telephone base or charger.
by a wall switch
To play messages:
Activate the answering system
3
4
• Press PLAY/STOP to play messages and
stop playback.
Charge the handset by
placing it in the telephone
base or charger. The
CHARGE light will be
on when the handset is
charging.
Align the cover flat
against the battery
compartment, then slide
it upwards until it clicks
into place.
The answering system must be turned on
to answer and record messages. Press
ANS ON/OFF to turn the answering system
on or off. When the answering system is
turned on, it will announce “Calls will be
answered,” and the ANS ON/OFF light will be
on. When the answering system is turned off,
it will announce “Calls will not be answered,”
and the ANS ON/OFF light will be off.
• Press X/DELETE while a message is
playing to delete it.
Charger
Telephone base
•
Press /SKIP to skip to the next message.
• Press /REPEAT to repeat the current
message.
CHARGE light
• Press VOL / to raise or lower playback
volume.
MENU
SELECT
VOL
CID
FLASH
CLEAR
NOTES:
IMPORTANT!
If your product is not working properly:
• Refer to the Troubleshooting section of
the user’s manual.
com or call 1 (800) 595-9511. In Canada,
1. Use only the power adapter(s) and
battery(ies) supplied with your VTech
telephone.
2. For complete feature instructions,
please refer to your user’s manual.
267-7377.
96-006809-010-100
Download from Www.Somanuals.com. All Manuals Search And Download.
|