Transition Networks Power Supply E MCC 1600 User Manual

DECLARATION OF CONFORMITY  
Minneapolis, MN 55344 USA  
Optional AC Power Supply Module  
for E-MCC-1600 Chassis  
E-MCC-PS  
Name of Mfg:  
Transition Networks  
6475 City West Parkway, Minneapolis MN 55344 USA  
Media Conversion Center AC Power Supply  
E-MCC-PS  
Model:  
Part Number:  
Regulation:  
EMC Directive 89/336/EEC  
Purpose: To declare that the E-MCC-PS to which this declaration refers is in  
conformity with the following standards.  
EMC-CISPR 22: 1985 Class A; EN 55022: 1988 Class A; EN 50082-1:1992;  
EN 60950 A4:1997; IEC 801.2, IEC 801.3, and IEC 801.4; IEC 950  
INSTALLATION GUIDE  
I, the undersigned, hereby declare that the equipment specified above conforms to the  
above Directive(s) and Standard(s).  
_April 8, 1999_____  
Stephen Anderson, Vice-President of Engineering  
Date  
COMPLIANCE INFORMATION  
UL Listed  
C-UL Listed (Canada)  
CISPR/EN55022 Class A  
FCC Regulations  
This equipment has been tested and found to comply with the limits for a class A digital device, pursuant  
to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful  
interference when the equipment is operated in a commercial environment. This equipment generates,  
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the  
instruction manual, may cause harmful interference to radio communications. Operation of this  
equipment in a residential area is likely to cause harmful interference, in which case the user will be  
required to correct the interference at the user’s own expense.  
Master/Slave Switch  
NOTE: Power Supply Modules can be “hot swapped”.  
The E-MCC-PS MAY or MAY NOT be shipped with the Master/Slave switch  
shown installed on the circuit board.  
Canadian Regulations  
If present, the Master/Slave switch allows the Power Supply Module to be  
configured as the primary (master) Power Supply Module or as the secondary  
(slave) Power Supply Module.  
This digital apparatus does not exceed the Class A limits for radio noise for digital apparatus set out on  
the radio interference regulations of the Canadian Department of Communications.  
Le présent appareil numérique n'émet pas de bruits radioélectriques dépassant les limites applicables  
aux appareils numériques de la class A prescrites dans le Règlement sur le brouillage radioélectrique  
édicté par le ministère des Communications du Canada.  
If any Power Supply Module WITHOUT a Master/Slave switch is installed in the  
E-MCC-1600 chassis, by default that Power Supply Module is secondary (slave).  
European Regulations  
Warning  
If neither Power Supply Module has a Master/Slave switch, primary/secondary  
status is automatic and non-configurable.  
This is a Class A product. In a domestic environment this product may cause radio interference in which  
case the user may be required to take adequate measures.  
Achtung !  
If both Power Supply Modules have Master/Slave switches and both are  
configured as the primary (master) Power Supply Module, each Power Supply  
Module contributes a portion of the power to the chassis (“load sharing”).  
Dieses ist ein Gerät der Funkstörgrenzwertklasse A. In Wohnbereichen können bei Betrieb dieses Gerätes  
Rundfunkstörungen auftreten, in weichen Fällen der Benutzer für entsprechende Gegenmaßnahmen  
werantwortlich ist.  
Attention !  
CAUTION: When installing a Power Supply Module that has a Master  
/Slave switch in a chassis with a Power Supply Module that does not  
have a Master/Slave switch, the Power Supply Module with the  
Master/Slave switch MUST BE CONFIGURED AS PRIMARY (MASTER).  
Ceci est un produit de Classe A. Dans un environment domestique, ce produit risque de créer des  
interférences radioélectriques, il appartiendra alors à l’utilsateur de prende les measures spécifiques  
appropriées  
Trademark Notice  
All registered trademarks and trademarks are the property of their respective owners.  
When installing two Power Supply Modules that have Master/Slave  
switches, at least one Power Supply Module MUST BE CONFIGURED  
AS PRIMARY (MASTER). Failure to observe this caution could result in  
Copyright Restrictions  
© 1999 TRANSITION Networks.  
All rights reserved. No part of this work may be reproduced or used in any form or by any means –  
graphic, electronic, or mechanical – without written permission from TRANSITION Networks.  
Download from Www.Somanuals.com. All Manuals dSeaamrcahgAendtoD,owannldoasdu. bsequent failure of, Power Supply Module(s).  
Printed in the U.S.A.  
33051.B  

Teledex Cordless Telephone SIP DECT Series User Manual
Thermador Oven PODC302 User Manual
Theta Digital DVD Player Compli User Manual
TRENDnet Webcam TVIP612WN User Manual
Tricity Bendix Oven BS 612 2 User Manual
Tricity Bendix Washer BIW 104 W User Manual
Uniden Conference Phone 1360 User Manual
Vermont Casting Indoor Fireplace DVHVAC36 User Manual
ViewSonic Projector VS13783 User Manual
Vizio Network Card TL WN727N User Manual