QUICK SETUP GUIDE
RF-TVMLPT01
1 Install locking screw
Option 2: If the back of the TV is curved or to make room for cables
Attach the TV bracket [A] to the back of the TV using the washers (E), the spacers (F), and the screws (D).
Note: If the hole pattern on your TV is 75mm x 75mm the washers(E) will not be used.
Install the TV bracket locking screw (G) into the TV bracket (A) using the hex key (H).
Do not screw in more than three or four turns.
Thank you for choosing the
Rocketfish RF-TVMLPT01.
The RF-TVMLPT01 TV mount
is designed to support
a TV weighing up to
50 lbs. (22.7 kg).
G
H
Package contents
A TV bracket (1)
B Wall plate (1)
2 Attach the TV bracket
A
B
Option 1: If the back of the TV is ꢀat
Align the TV bracket (A) with the mounting screw holes
on the back of the TV. Place the washers (E) over
the screw holes on the TV bracket.
M4 bag
C M4 x 12 mm screws (4)
D M4 x 30 mm screws (4)
E M4 washers (4)
F M4 spacers (4)
M4 bag
Note: If the hole pattern on your TV is 75 mm x 75 mm,
do not use the washers. Insert the screws (C) though
the screw holes and tighten.
F
With washers
E
F
D
C
Miscellaneous bag
G Locking screw (1)
H 5/32 in. hex key (1)
M4 x 30mm
M4 x 12mm
F
M4
E
M4
A
Miscellaneous bag
D
H
G
in.
D
E
Without washers
Lag bolt bag
I 5/16 in. x 2¾ in. lag bolts (2)
J Concrete anchors (2)
A
C
A
Lag bolt bag
I
J
C
Tools you will need:
Without washers
With washers
A
• Stud finder
• Awl
• Level
• Hammer (Concrete Only) • 3/8 in. masonry
•Tape measure
• Power drill
drill bit(Concrete Only)
• Socket wrench with ½ in. socket
or adjustable wrench
• Pencil
• 3/16 in. wood drill bit
• Phillips screwdriver
Download from Www.Somanuals.com. All Manuals Search And Download.
|