Remington Hair Dryer D 1000IS User Guide

29715_D-1000is_IB 6/20/06 10:12 AM Page 1  
Ion Glow Multi-Attachment Styler  
Use and Care Guide  
D-1000is  
Download from Www.Somanuals.com. All Manuals Search And Download.  
29715_D-1000is_IB 6/20/06 10:12 AM Page 4  
Safety Instructions  
1. Should the ALCI safety device trip (i.e.,  
ALCI Safety Device  
reset button pops out) during use, press  
the reset button. Should the hair dryer  
fail to reset, call 800-736-4648. Never  
operate this appliance if it has been  
dropped in water.  
This hair dryer is provided with an  
appliance leakage circuit interrupter (ALCI)  
safety device built into the plug. This device  
is designed to make the unit inoperable  
under some abnormal conditions, such as  
accidental immersion in water. The ALCI  
safety device is equipped with a test button  
so that its operation can be checked. This  
unit should be tested before each use to  
confirm that the safety device is  
2. The dryer is designed to work on  
ordinary household current only, 125  
volts A.C., 60 Hz. It is not intended for  
commercial use.  
GROUND FAULT CIRCUIT  
INTERRUPTERS CAN  
SAVE A LIFE!  
operational.  
3. This appliance is equipped with an  
automatic thermal limiter, which will  
cycle off when overheated and come  
back on when cooled down. If the unit  
cycles off, unplug the cord for several  
minutes before restarting.  
To test:  
After plugging in your hair dryer:  
If you must use your hair dryer in the  
1. Press the reset button on the  
ALCI device.  
bathroom, install a GFCI* now!  
Your local electrician can help you decide which type is best for you –  
a portable unit that plugs into the electrical outlet or a permanent  
unit installed by your electrician. The National Electrical Code now  
requires GFCI’s in bathrooms, garages, and outdoor outlets of all  
new homes.  
4. This appliance has a polarized plug  
(one blade is wider than the other). As  
a safety feature, this plug will fit in a  
polarized outlet only one way. If the plug  
does not fit fully in the outlet, reverse the  
plug. If it still does not fit, contact a  
qualified electrician. Do not attempt to  
defeat this safety feature.  
2. Press the test button. The reset button  
will pop out. This verifies that the safety  
device is operating properly.  
3. Press the reset button to reactivate your  
ALCI safety device.  
Why do you need a GFCI?  
Electricity and water don’t mix. If your hair dryer falls in water while  
it’s plugged in, the electric shock can kill you– even if the switch is  
off.” A regular fuse or circuit breaker won’t protect you under these  
circumstances. A GFCI offers you greater protection.  
4. Your hair dryer is now ready for use.  
Note: This unit may automatically trip  
when unplugged. If so, the unit must be  
reset after it is plugged in. If the dryer  
doesnt reset after following the above  
testing procedure, call 800-736-4648.  
A GFCI can save your life!  
Compared to that, the price is small!  
Dont wait… install one now!  
*GFCI is a sensitive device that reacts immedi-  
ately to a small electric current leak by stopping  
the electricity flow.  
4
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
29715_D-1000is_IB 6/20/06 10:12 AM Page 6  
Product Features  
Thank you for purchasing  
1875 Watts  
®
Ceramic Grill  
the Remington 1875 watt Ion  
Removable Filter  
Glow Multi-Attachment Styler  
Please carefully read the  
.
instructions contained in this  
booklet, and keep them in a  
safe place for future reference.  
ION  
Glow  
LED  
Key Features:  
Narrow Air  
Concentrator  
Ionic Conditioning  
Before  
After  
Negative ions neutralize the positive  
ions that cause static and frizz, giving  
hair a more healthy-looking shine.  
Cool Shot  
Ion Switch  
6 Style Settings  
3 Heats and 2 Speeds  
Ceramic Protection  
Emits far-infrared, radiant heat to help  
dry water molecules inside the hair  
strand. This fast and efficient process  
helps prevent heat damage to the outer  
cuticle for less frizz and more shine.  
Complete Ion Control  
ON for smooth, shiny hair OFF for  
maximum volume or fine hair  
6-foot Salon  
Length Cord  
Lift & Dry Diffuser  
Hang Loop  
Ion Switch  
6
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
29715_D-1000is_IB 6/20/06 10:12 AM Page 8  
How to Use  
Hair Care Tips  
To create a style with lots of body, apply  
Cool Shot:  
The Cool Shot sets the style by blowing a  
cool stream of air. Press and hold cool shot  
button to set style. Release button to return  
to warm air flow.  
Basic Drying Techniques  
Hair Care Tips  
volumizing mousse to towel dried hair.  
Distribute it evenly from roots to ends,  
then blow dry as usual. Hair will be soft,  
shiny, and full of volume.  
1. Gently towel dry hair to remove excess  
water. Avoid rubbing hair with towel –  
this creates split ends and frizziness.  
Detangle hair with a wide-toothed comb.  
Keep the dryer about 8 inches away  
from your head to avoid burning your  
scalp or damaging hair.  
Always keep the dryer pointed down  
the hair shaft to smooth the cuticle and  
create a silky, shiny style.  
For a super smooth, salon-like blow dry,  
finish by running a straightening iron  
over dried hair.  
For straight, smooth hair:  
2. Be sure dryer is turned off. Plug dryer  
into an electrical outlet.  
With the dryer turned off, attach the  
concentrator to the end of the nozzle. Brush  
hair from underneath using a large, round  
brush or paddle brush. Pull hair down until  
the hair is fully extended and taut. Run the  
dryer slowly down the length of the hair  
several times until dry. Repeat with all sec-  
tions of hair until it is completely dried. Lock  
in the style with Cool Shot.  
3. Set the ion switch to the on position.  
Turn the dryer on and set it to a high  
heat and speed. Remove some of the  
additional moisture from your hair by  
briskly blowing it all over, using your  
fingers to comb” through hair.  
To help prevent heat damage and add  
shine, spritz damp hair with a heat  
protection spray before blow drying.  
For a quick touch-up between  
shampoos, mist hair to dampen  
it, then style with dryer.  
4. When hair is almost dry, lower the heat  
and speed to the desired settings and  
begin to style.  
For curly hair:  
Use dryer on a low heat and speed setting  
and move it quickly about your head. As  
you dry your hair, scrunch it with your  
favorite styling product or twirl strands of  
hair around your fingers to add definition.  
When finished drying, lock in the style with  
the Cool Shot.  
5. Set ion switch to off position. Divide hair  
into manageable sections. Begin at the  
nape of your neck and brush hair, follow-  
ing the movement of the brush with the  
dryer. Continue working your way up to  
your scalp, then to the sides and the  
front, drying small sections at a time.  
6. Once your desired style is achieved, push  
the Cool Shot button to set the style with  
a cool flow of air.  
8
9
Download from Www.Somanuals.com. All Manuals Search And Download.  
29715_D-1000is_IB 6/20/06 10:12 AM Page 10  
Warranty  
Cleaning and Maintenance  
Storage  
Maintenance Instructions  
The dryer needs minimum maintenance to  
ensure the best performance and long life.  
Full Two-Year Warranty  
Spectrum Brands, Inc.  
When not in use, unplug the unit. Allow it to  
cool, and store out of reach of children in a  
safe, dry location. Never wrap the cord  
around the appliance, as this will cause the  
cord to wear prematurely and break.  
Handle cord carefully, and avoid jerking,  
twisting, or straining it, especially at plug  
connections.  
Spectrum Brands, Inc. warrants this product  
against any defects that are due to faulty  
material or workmanship for a two-year  
period from the original date of consumer  
purchase. This warranty does not include  
damage to the product resulting from  
accident or misuse.  
Money-back Offer  
If within 30 days after you have purchased  
your Remington® branded product, you are  
not satisfied and would like a refund,  
return it with the sales slip indicating  
purchase price and date of purchase to the  
retailer from whom it was purchased.  
Spectrum Brands, Inc. will reimburse all  
retailers who accept the product within 30  
days from the date of purchase. If you have  
any questions concerning the money-back  
guarantee, please call 800-736-4648 in the  
U.S. or 800-268-0425 in Canada.  
Do not attempt to repair the appliance  
yourself.  
Keep all intake openings clear of dust  
accumulation. See Cleaning Instructions”  
below. No other maintenance or  
lubrication is required.  
If the product should become defective  
within the warranty period, we will repair  
it or elect to replace it free of charge.  
Please call 800-736-4648 in the U.S.  
or 800-268-0425 in Canada.  
If the cord becomes twisted due to use,  
periodically straighten it. Store appliance  
and cord where they will not be damaged.  
Do not wrap cord around dryer.  
SPECTRUM BRANDS, INC. SHALL NOT  
BE RESPONSIBLE FOR ANY INCIDENTAL,  
SPECIAL OR CONSEQUENTIAL DAMAGES  
RESULTING FROM THE USE OF THIS  
PRODUCT. ALL IMPLIED WARRANTIES,  
INCLUDING BUT NOT LIMITED TO  
IMPLIED WARRANTIES OF FITNESS  
AND MERCHANTABILITY, ARE LIMITED  
IN DURATION TO TWO YEARS FROM  
DATE OF ORIGINAL PURCHASE.  
125 VAC 60 Hz  
Questions or comments:  
Cleaning Instructions  
The air filter should be cleaned regularly,  
since a dirty or clogged filter will impair the  
efficiency of the dryer.  
Call 800-736-4648 in the U.S. or  
800-268-0425 in Canada.or visit  
REMINGTON is a trademark of ROVCAL, Inc.  
1. To clean air filter, make sure dryer is  
turned off and unplugged.  
©2006 ROVCAL, Inc.  
This warranty gives you specific legal rights  
and you may also have other rights which  
vary from state to state. Some states do  
not allow the exclusion or limitation of  
incidental, special, or consequential  
damages.  
2/06 Job# CS29715  
T22-21341  
2. Gently pull the air inlet grille away from  
the dryer.  
Spectrum Brands, Inc.  
800-736-4648  
3. Use a soft bristle brush to gently remove  
any particles that are lodged in filter.  
MADE IN CHINA  
4. If the unit is dirty, wipe it with a damp  
This product is listed by  
cloth.  
Underwriters Laboratories, Inc.  
and bears the mark.  
5. To replace the air inlet after cleaning,  
align locking tabs and press back into  
place to secure.  
10  
11  
Download from Www.Somanuals.com. All Manuals Search And Download.  
29715_D-1000is_IB 6/20/06 10:12 AM Page 12  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Radio Shack Range 49 1003 User Guide
Raritan Computer Clock Radio 12 898 User Guide
RCA DVR AVC 776 User Guide
RedMax Brush Cutter BCZ2401S CA User Guide
Samsung Digital Camera ST71 User Guide
Samsung Printer 500N User Guide
Sanyo Camcorder 210148 User Guide
Sears Saw 43783163 User Guide
Sears Smoker 20070211 User Guide
Seiko Instruments Heat Pump MT 17E 003 D User Guide