Indoor/Outdoor Modular Intercom System
43-3101
OWNER’S MANUAL — Please read before using this equipment.
Your Indoor/Outdoor Modular Intercom
System operates as a two-tone doorbell
intercom and an indoor intercom. The
doorbell is simple to install without wiring and
you can add additional stations.
Warning: Dispose of old batteries promptly
and properly. Do not burn or bury them.
Caution: If you do not plan to use the
doorbell for two weeks or longer, remove the
batteries. Batteries can leak chemicals that
can destroy electronic parts.
PREPARATION
If the doorbell unit operates under severe
cold weather, use a lithuim type AA battery.
Installing the Doorbell’s Batteries
Your doorbell intercom uses four AA
batteries (not supplied) for power. For the
best performance and longest life, we
recommend RadioShack alkaline batteries.
Setting the Channel
The doorbell and indoor intercoms have
three selectable operation channels to
prevent interference from similar products
nearby. Select the same channel for both the
doorbell intercom and the indoor intercom.
Caution: Use only fresh batteries of the
required size and recommended type. Do not
mix old and new batteries, different types of
batteries (standard, alkaline, or
rechargeable), or rechargeable batteries of
different capacities.
On the doorbell intercom, slide CH inside the
battery compartment to 1 (49.835MHz), 2
(49.860MHz), or 3 (49.885MHz).
1. Use a Phillips screwdriver to loosen the
screws in the doorbell intercom’s battery
compartment cover, then lift the cover
off.
On the back of the indoor intercom, set
OUTDOOR CHANNEL to the same channel
number (1, 2 or 3) you chose for the doorbell
intercom.
2. Insert four AA batteries into the
compartment as indicated by the polarity
symbols (+ and –) marked inside.
Note: If the doorbell occasionally sounds
without anyone pressing BELL on the
doorbell, change the channel settings.
3. Replace the cover and tighten the
screws.
Changing the Doorbell’s Tone
Use a small flat-blade
screwdriver to
Hint: For convenience, set the channel
(see “Setting the Channel”) while you
have the battery cover removed.
carefully pull out the
jumper TONE switch
located in the battery
compartment, then
insert the jumper TONE
switch into the other
two pins.
Replace the batteries when the battery level
is low and the doorbell sends an alert tone to
the indoor intercom. The POWER indicator
on the indoor intercom flashes until you
replace the batteries.
© 2001 RadioShack Corporation. All Rights Reserved.
RadioShack and RadioShack.com are trademarks
used by RadioShack Corporation.
Download from Www.Somanuals.com. All Manuals Search And Download.
Using the Doorbell
Calling Another Intercom Station
Your visitor presses BELL on the doorbell to
sound the doorbell.
Be sure the intercom stations you plan to use
are turned on and adjusted to the desired
volume. Press CALL to sound a tone alerting
the person at the other station that you are
about to speak. The CALL indicator lights.
Hold down TALK TO DOOR on the indoor
intercom to reply to the caller. The TALK TO
DOOR indicator lights. When you release
TALK TO DOOR, the caller can reply by
pressing PRESS TO TALK on the doorbell
intercom.
Hold down TALK and speak in a normal voice.
The TALK indicator lights. When you finish
speaking, release TALK and listen for a
response.
Notes:
Notes:
• If there is no voice communication
between the doorbell and the indoor
intercom within about 10 seconds, the
doorbell intercom may be disabled and
should be initialized by pressing BELL
again.
• Only one party can talk at a time. Wait
until the other party finishes before
answering.
• If your voice sounds distorted, you might
be speaking too loudly or too close to the
station’s microphone.
• You can also use other intercoms to reply
to the doorbell as long as they are set on
the same frequency.
WARNING: To reduce the risk of fire or shock
hazard, do not expose this product to rain or moisture.
• If the channel is occupied by other
intercom users, the door chime cannot be
sent to the intercoms in use. The
conversation between intercoms will not
be sent to the doorbell.
CAUTION
RISK OF ELECTRIC SHOCK.
!
DO NOT OPEN.
CAUTION: TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT REMOVE
COVER OR BACK. NO USER-SERVICE-
ABLE PARTS INSIDE. REFER SERVICING
TO QUALIFIED PERSONNEL.
USING MULTIPLE
INTERCOMS
You can set up several indoor intercoms for
station-to-station communication. Simply set
CHANNEL A/B/C on the back of each intercom
to the same frequency as other stations with
which you want to communicate.
This symbol is intended to alert you to
the presence of uninsulated danger-
ous voltage within the product’s enclo-
sure that might be of sufficient
magnitude to constitute a risk of elec-
tric shock. Do not open the product’s
case.
For example, you could set a station installed
in the kitchen to channel A, a station installed
in the family room to channel B, and a station
installed in a bedroom to channel C. Using the
station installed in the kitchen, you can
communicate with the station in the family
room by setting the channel selector to B, or
with the station in the bedroom by setting the
channel selector to C. If you set all stations to
channel A, you can communicate with the
other two stations from any station.
This symbol is intended to inform you
that important operating and mainte-
nance instructions are included in the
!
literature accompanying this product.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
• Increase the separation between the
equipment and receiver.
CARE
Keep the system dry; if it gets wet, wipe it dry im-
mediately. Use and store the system only in nor-
mal temperature environments. Handle the
system carefully; do not drop it. Keep the system
away from dust and dirt, and wipe it with a damp
cloth occasionally to keep it looking new.
• Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio
TV technician for help.
Modifying or tampering with the system’s internal
components can cause a malfunction and might
invalidate its warranty and void your FCC autho-
rization to operate it. If your system is not per-
forming as it should, take it to your local
RadioShack store for assistance.
You must use shielded cables with this system to
ensure compliance with the Class B FCC limits.
Your system is ETL listed to UL standards and
meets all applicable FCC requirements.
Limited Ninety-Day Warranty
This product is warranted by RadioShack against manufacturing
defects in material and workmanship under normal use for ninety
(90) days from the date of purchase from RadioShack company-
owned stores and authorized RadioShack franchisees and deal-
ers. EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO
EXPRESS WARRANTIES AND ANY IMPLIED WARRANTIES,
INCLUDING THOSE OF MERCHANTABILITY AND FITNESS
FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION
TO THE DURATION OF THE WRITTEN LIMITED WARRANTIES
CONTAINED HEREIN. EXCEPT AS PROVIDED HEREIN, Ra-
dioShack SHALL HAVE NO LIABILITY OR RESPONSIBILITY TO
CUSTOMER OR ANY OTHER PERSON OR ENTITY WITH RE-
SPECT TO ANY LIABILITY, LOSS OR DAMAGE CAUSED DI-
RECTLY OR INDIRECTLY BY USE OR PERFORMANCE OF
THE PRODUCT OR ARISING OUT OF ANY BREACH OF THIS
WARRANTY, INCLUDING, BUT NOT LIMITED TO, ANY DAM-
AGES RESULTING FROM INCONVENIENCE, LOSS OF TIME,
DATA, PROPERTY, REVENUE, OR PROFIT OR ANY INDIRECT,
SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES,
EVEN IF RadioShack HAS BEEN ADVISED OF THE POSSIBIL-
ITY OF SUCH DAMAGES.
FCC STATEMENT
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
Warning: Changes or modifications to this unit
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment.
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
Some states do not allow limitations on how long an implied war-
ranty lasts or the exclusion or limitation of incidental or conse-
quential damages, so the above limitations or exclusions may not
apply to you.
In the event of a product defect during the warranty period, take
the product and the RadioShack sales receipt as proof of pur-
chase date to any RadioShack store. RadioShack will, at its op-
tion, unless otherwise provided by law: (a) correct the defect by
product repair without charge for parts and labor; (b) replace the
product with one of the same or similar design; or (c) refund the
purchase price. All replaced parts and products, and products on
which a refund is made, become the property of RadioShack.
New or reconditioned parts and products may be used in the per-
formance of warranty service. Repaired or replaced parts and
products are warranted for the remainder of the original warranty
period. You will be charged for repair or replacement of the prod-
uct made after the expiration of the warranty period.
This warranty does not cover: (a) damage or failure caused by or
attributable to acts of God, abuse, accident, misuse, improper or
abnormal usage, failure to follow instructions, improper installa-
tion or maintenance, alteration, lightning or other incidence of ex-
cess voltage or current; (b) any repairs other than those provided
by a RadioShack Authorized Service Facility; (c) consumables
such as fuses or batteries; (d) cosmetic damage; (e) transporta-
tion, shipping or insurance costs; or (f) costs of product removal,
installation, set-up service adjustment or reinstallation.
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
RadioShack Customer Relations, 200 Taylor Street, 6th Floor,
Fort Worth, TX 76102
• Reorient or relocate the receiving antenna
12/99
11A01
AO0073AAA1
43-3101
Printed in China
Download from Www.Somanuals.com. All Manuals Search And Download.
|