HD7830
Coffee Machine
2
6
3
7
4
8
5
9
1
h
i
A
B
J
F
g
K
10
14
18
22
11
15
19
23
12
16
20
24
13
17
21
l
C
M
D
n
E
25
O
P
Q
R
26
30
34
27
31
35
28
32
29
33
Download from Www.Somanuals.com. All Manuals Search And Download.
The light rings around the 1-cup button q and the 2-cup
button qq indicate if there is still enough water left for
brewing one or two cups of coffee. If there is not enough
water left in the water reservoir for brewing two cups
of coffee, the light ring around the 2-cup button qq will
Be careful when you do this; make sure that the rubber
sealing ring does not get stuck under the edge of the
water distribution disc. If it does, the coffee machine will
start leaking!
Replacement
All removable parts can be ordered from your Philips
dealer or a Philips service centre.
Environment
Flushing
not go on and this button cannot be operated.
,
Do not throw the machine away with the normal
household waste at the end of its life, but hand
it in at an official collection point for recycling.
By doing this you will help to preserve the
environment (Fig. 35).
\
,
-
The SENSE coffee machine starts brewing.
The machine automatically supplies the selected
amount of water.
If you have not used the coffee machine for three days,
you have to flush it with fresh water before you use it
again.
-
You can interrupt the brewing process at any time
by pressing the on/off button 3. If you switch
the machine back on after having interrupted the
brewing process, the machine will not complete the
interrupted brewing cycle.
Flush the machine in the following way:
1
Fill the water reservoir with cold water up to
guarantee & service
the MAX indication and put it back into the
machine. (Fig. 3)
If you need service or information or if you have a
problem, please consult the worldwide guarantee leaflet
Do not remove the water reservoir during a brewing
cycle, as this will cause the machine to draw in air.When
this happens, the next cup will only be partly filled.
2
3
4
Put the 1-cup pod holder q or the 2-cup pod
holder qq in the machine without pod(s). (Fig. 13) contact the Philips Customer Care Centre in your
country; they will be happy to help you.
Put a bowl (with a capacity of at least 1500 ml)
The telephone number for the United Kingdom is: 0845-
under the coffee spout to collect the water (Fig. 8).
6010354.
Press on/off button 3 (1) and subsequently press
the 1-cup button q and the 2-cup button qq
briefly at the same time (2). (Fig. 32)
Note: If you only get a small quantity of coffee or no coffee
at all out of the machine, you have not flushed the machine
properly before first use.As a result, the boiler is not or not
completely filled. Flush the machine properly (see chapter
‘Preparing the machine for use’) before you brew another
cup of coffee.
You will find the telephone numbers for other countries
in the worldwide guarantee leaflet. If there is no
Customer Care Centre in your country, turn to your
local Philips dealer or contact the Service Department of
Philips Domestic Appliances and Personal Care BV.You
will find their address and fax number in the worldwide
guarantee leaflet.
The machine fills itself with water from the water
reservoir.While this happens, water comes out of
the spout.When the flushing cycle is finished, the
machine switches itself off. During the flushing cycle,
the machine produces more noise than during a regular
brewing cycle.
11 Remove the coffee pod(s) after use by lifting the
pod holder out of the machine and emptying it.
Be careful when doing this, for there may still be some
water/coffee on the coffee pod(s).
\
The purchase of the Philips SENSEO coffee machine
does not exhaust any of the rights of Sara Lee/Douwe
Egberts or Philips under any of their patents nor does it
confer upon the purchaser a licence under these patents.
Descaling
Tips
,
By rinsing the pod holders, the coffee collector and
the coffee spout regularly, you will make sure that
the coffee always tastes optimally.
Regular descaling will prolong the life of the coffee
machine and will guarantee optimal brewing results for a
long time.
\
,
,
The SENSEO coffee will taste best if you stir it
,
When you need to descale the machine, the
descaling indication b appears on
the display.This happens after 500 cups have
been brewed.After another 8 cups, the descaling
indication b disappears from the display
(whether or not you have performed the descaling
procedure). (Fig. 33)
before drinking it.
If you intend to make another cup of SENSEO
\
coffee later, just leave the coffee machine switched
on.The machine will automatically switch itself off
after 1 hour. (Fig. 22)
Cleaning
1
Fill the water reservoir up to the MAX indication
with descaler and water according to the
instructions on the package of the descaler.Then
put the water reservoir back into the coffee
machine. (Fig. 3)
\
Never immerse the SENSEO coffee machine in water.
Never clean the machine by flushing it with the lid open.
1
2
Always unplug the machine before cleaning it.
Clean the outside of the machine with a moist
cloth.
Use a liquid descaler based on citric acid.
2
Press the on/off button 3. (Fig. 9)
3
4
Remove the coffee collector (Fig. 23).
The machine is ready for use when the indicator light
burns continuously.
Take the coffee spout out of the machine by sliding
it upwards (Fig. 24).
3
Place the 1-cup pod holder q in the coffee
machine, preferably with a used coffee pod in it.
Close the lid and make sure it is properly locked.
The coffee spout can only be taken out after the coffee
collector has been removed.
,
You can disassemble the coffee spout for more
thorough cleaning! (Fig. 25)
We advise you to put a used coffee pod in the pod
holder when you descale the machine.This pod will serve
as a ‘filter’ to prevent the sieve in the pod holder from
getting clogged with scale residues.
5
Clean the coffee spout, the coffee collector and
the drip tray in hot water, if necessary with some
washing-up liquid, or in the dishwasher (Fig. 26).
4
Put a bowl with a capacity of at least 1500 ml
under the spout openings to collect the mixture of
descaler and water. (Fig. 8)
6
Hold the cup tray in your hand while cleaning it
with hot water, if necessary with some washing-up
liquid (Fig. 27).
5
Press the 2-cup button qq for 2 cups and let
the machine operate. Repeat this until the water
reservoir is empty. (Fig. 34)
The cup tray can also be cleaned in the dishwasher.
To clean the cup tray, always remove it from the
machine, as it might prove sharp when handled
incorrectly.Always handle it carefully.
\
Never descale the SENSEO coffee machine with the
lid open. Make sure the lid is properly locked.
7
Clean the pod holders in hot water, if necessary
with some washing-up liquid, or in the
dishwasher. (Fig. 28)
6
7
8
Repeat steps 1 to 5 with a new mixture of descaler
and water.
Empty the water reservoir to remove the mixture
of descaler and water.
Check if the sieve in the centre of the pod holder is
clogged. If this is the case, unclog the sieve by rinsing the
pod holder under a running tap. Use a washing-up brush
to clean the sieve, if necessary.
Rinse the machine at least 3 times by repeating
steps 1 to 5, now using fresh water.
Do not refill the water reservoir with used hot
water.
,
8
Clean the water reservoir in hot water, if necessary
with some washing-up liquid. (Fig. 29)
9
Clean the pod holder after descaling to prevent the
sieve in the centre from getting clogged.
Note: If you are using a washing-up brush, be careful not to
damage the valve in the bottom of the water reservoir.
Frost-free storage
9
Do not use an object with sharp edges to clean the
water inlet on the machine (Fig. 30).
If the coffee machine has already been used and
therefore has been flushed with water, it may only be
used and stored in a frost-free place to prevent it from
becoming damaged.
10 Rinse the parts with fresh water after cleaning and
put them back into the machine.
11 Clean the water distribution disc with a moist
cloth (Fig. 31).
4222.001.9946.2
3/4
Download from Www.Somanuals.com. All Manuals Search And Download.
Problem
Solution
Problem
Solution
Troubleshooting
If you have a problem, you may find the solution in the
table below. If the table does not provide the solution
to your problem or if you have a question, see chapter
‘Guarantee & service’.
\
the sealing ring is not stuck
under the edge of the water
distribution disc.
The SENSEO
Make sure that:
coffee is not strong
enough.
the water drops on the
worktop are not the result of
placing or removing the water
reservoir or removing used
coffee pods;
you have used the correct
number of pods and have
pressed the right button. Use
1 pod in combination with the
1-cup pod holder q and the
1- cup button q.
Problem
Solution
The indicator light
continues to blink
slowly.
You have not yet flushed the
coffee machine (see chapter
‘Preparing the machine for use’).
you do not remove the water
reservoir when the coffee
machine is heating up.This may
cause water that normally ends
up in the water reservoir to
leak out of the machine.
Use 2 pods in combination with
the 2-cup pod holder qq and
the 2-cup button qq.
\
You have used the SENSEO
coffee machine at an altitude
higher than 2200 metres above
sea level.This has caused the
water in the machine to start
boiling before it has reached
the required temperature,
which prevents the machine
from functioning properly.
Switch the machine off and no
longer use it at altitudes higher
than 2200 metres above sea
level.
the coffee pod(s) have been
placed properly in the centre
of the pod holder, to prevent
water from escaping along the
edge of the pod(s).When you
are using two coffee pods on
top of each other, make sure
that the convex sides of both
pods are pointing downwards
and press the pods lightly into
the pod holder;
In all other cases, contact the
Philips Customer Care Centre
in your country.
The coffee spout
The coffee spout can only
cannot be taken out be taken out after the coffee
of the machine.
collector has been removed.
\
The SENSEO
You have not yet flushed the
coffee machine does coffee machine.When you use
The lid cannot be
opened.
A vacuum may have
temporarily formed under
the lid.
you have not used the same
pod twice by accident;
not produce coffee
when used for the
first time.
the machine for the first time,
you have to flush it before you
can start brewing coffee (see
chapter ‘Preparing for use’).
Switch the machine off. Pull the
lever up as far as it will go and
wait 24 hours before opening
the lid.You may need to use
quite some force.
the coffee in the pod is evenly
distributed;
The display doesn’t
work when the
You have not yet flushed the
If you prefer a more robust
coffee machine.The display
\
flavour, SENSEO coffee pods
machine is switched starts working after the
on for the first time. machine has been flushed (see
chapter ‘Preparing for use’).
with a stronger blend are
available.
Make sure that the sieve in
the centre of the pod holder
is not clogged. If it is, unclog
the sieve by holding the pod
holder under a running tap.
If necessary, you can use a
washing-up brush or a pin to
unclog the sieve.
\
The SENSEO
If you prefer a milder flavour,
The indicator light
continues to blink
rapidly.
Make sure that:
\
coffee is too strong. SENSEO coffee pods with a
milder blend are available.
The coffee is not
hot enough.
Do not use cups that are too
large, as they will cause the
coffee to get cold more quickly.
Make sure the cups have a
capacity of at least 100 ml
when brewing small cups f,
150 ml when brewing medium
cups g and 170ml when
brewing large cups h.
the water reservoir has been
properly placed;
If problems continue to occur,
contact the Philips Customer
Care Centre in your country.
there is enough water in the
water reservoir (i.e. above the
q MIN level if you want to
brew 1 cup);
The coffee machine Perhaps the sieve in the centre
produces less coffee of the pod holder is clogged. If
the ambient temperature is
than before.
this is the case, unclog the sieve
by rinsing the pod holder under
a running tap. Use a washing-
up brush to clean the sieve, if
necessary.
c
not lower than 10 C. If it is,
the machine will not function
properly.
The preferred coffee Make sure that there is enough
volume cannot be
selected.
water in the water reservoir.
The 2-cup button
qq cannot be
operated.
Make sure that there is enough
water in the water reservoir
for brewing 2 cups of coffee. If
the light ring around the 2-cup
button qq is out, there is not
enough water in the water
The coffee volume
indication does
not appear on the
display and it is not
possible to select a
volume.
Make sure that there is enough
water in the water reservoir.
Descale the machine (see
chapter ‘Descaling’).
\
The SENSEO
You have not flushed the
coffee machine
machine properly before first
use.As a result, the boiler is
not or not completely filled.
Flush the machine properly (see
chapter ‘Preparing the machine
for use’) before you brew
another cup of coffee.
reservoir for brewing 2 cups.
brews only a small
quantity of coffee
or no coffee at all
when it is used for
the first time.
Water leaks from
the coffee machine.
Make sure that:
the lid is properly closed (the
lever must be properly locked);
The lid cannot be
closed properly.
Check if a used coffee pod
is sticking to the water
distribution disc. If this is the
case, remove the used pod.
the water reservoir has not
been filled beyond the MAX
level;
the sieve in the centre of the
pod holder is not clogged. If it
is, unclog the sieve by holding
the pod holder under a running
tap. If necessary, you can use a
washing-up brush or a pin to
unclog the sieve;
Check if you used the correct
pod holder. Use 2 pods in
combination with the deeper
2-cup pod holder qq.
Use 1 pod in combination with
the 1-cup pod holder q.
The machine has
been stored in a
room that was not
frost-free.
Contact the Philips Customer
Care Centre in your country.
the coffee pod has been put
properly in the centre of the
pod holder;
4222.001.9946.2
4/4
Download from Www.Somanuals.com. All Manuals Search And Download.
|