40-4074.fm Page 1 Wednesday, August 11, 1999 10:28 AM
Cat. No. 40-4074
STS 150 Speaker System
Your Optimus STS 150 Speaker Sys-
tem has a 2-way acoustic suspension
design that utilizes an 8-inch specially
treated cone surrounded by rubber to
yield excellent low-end response and
tight, clean bass. A 1-inch mylar
tweeter diaphragm provides clear and
natural high-frequency sound repro-
duction.
Where and how you position each
STS-150 speaker has a great effect
on the overall performance of your
sound system.
For the best sound and stereo effect,
place the speakers so the distance
between them is about the same as
the distance between the listening
area and a point halfway between the
speakers.
The speaker cabinet is solid in con-
struction and is finished in woodgrain
vinyl. The decorative grille is acousti-
cally transparent.
b
a
Note: You need speaker wire (not
supplied) to connect your speaker.
a = b
SPEAKER PLACEMENT
Cautions:
If you place the speakers too far apart,
a sound “hole” could occur and you
might not get the proper stereo image
in the listening area. Compensate for
this by angling the speakers slightly in
toward the listening area.
• To prevent the cabinet from warp-
ing or discoloring, do not place the
speaker where it is exposed to
direct sunlight or excessive
humidity.
• Do not place the speaker where it
might be knocked over or hit by
falling objects.
If you place the speakers too close to-
gether, you could cancel out the ste-
reo image and the sound might seem
to be monaural. Compensate for this
by angling the speakers slightly away
from the listening area.
© 1996 Tandy Corporation.
All Rights Reserved.
Optimus is a registered trademark used by Tandy Corporation
RadioShack is a trademark used by Tandy Corporation.
Download from Www.Somanuals.com. All Manuals Search And Download.
40-4074.fm Page 3 Wednesday, August 11, 1999 10:28 AM
4. Press the right speaker’s red
(positive) terminal tab and insert
the marked conductor into the
opening, then release the tab.
MAINTENANCE
Your Optimus STS 150 Speaker Sys-
tem is an example of superior design
and craftsmanship. The following sug-
gestions will help you care for the
speaker so you can enjoy it for years.
• Keep the speaker dry. If it gets
wet, wipe it dry immediately. Liq-
uids contain minerals that can cor-
rode electronic circuits.
• Keep the speaker away from dust
and dirt, which can cause prema-
ture wear of parts.
Note: Improper phasing can
decrease bass sounds. Be sure to
connect speaker terminals in
proper phase (+ to + and – to –).
• Occasionally wipe the cabinet with
a cloth dampened with furniture
polish to keep it looking new. Do
not use harsh chemicals, cleaning
solvents, or strong detergents to
clean the speaker cabinet.
5. Press the right speaker’s black
(negative) terminal tab and insert
the other conductor into the open-
ing, then release the tab.
• Use and store the speaker in nor-
mal temperature environments.
6. Insert the other end of the marked
conductor into your receiver/
amplifier’s right positive terminal.
Temperature
extremes
can
shorten the life of electronic cir-
cuits.
7. Connect the remaining conductor
to the receiver/amplifier’s right
negative terminal.
Caution: Do not clean the speaker
with a vacuum cleaner. This might
permanently damage it. Clean the
speaker grille with a feather duster or
soft cloth.
8. Repeat these steps for the left
speaker.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
40-4074.fm Page 4 Wednesday, August 11, 1999 10:28 AM
SPECIFICATIONS
Speaker Complement .............................................8-Inch High-Compliance Woofer
1-Inch Ferrofluid Cooled Tweeter
Impedance ......................................................................................Nominal 8 Ohms
Frequency Response..........................................................................65 Hz–18 kHz
Power Handling...................................................................................50 Watts RMS
Maximum Power ........................................................................................100 Watts
Sensitivity.......................................................................................... 89 dB @2.83 V
Dimensions (HWD) ...........................................................141/4 ¥ 109/16 ¥ 81/4 Inches
(35.5 ¥ 25.4 ¥ 21 cm)
Shipping Weight ................................................................................................ 11 lb
(4.9 kg)
Specifications are typical; individual units might vary. Specifications are subject to
change and improvement without notice.
RadioShack Limited Warranty
This product is warranted against defects for 5 years from date of purchase from RadioShack
company-owned stores and authorized RadioShack franchisees and dealers. Within this period,
bring your RadioShack sales slip
we will repair it without charge for parts and labor. Simply
as
proof of purchase date to any RadioShack store. Warranty does not cover transportation costs.
Nor does it cover a product subjected to misuse or accidental damage.
EXCEPT AS PROVIDED HEREIN, RadioShack MAKES NO EXPRESS WARRANTIES AND
ANY IMPLIED WARRANTIES ARE LIMITED IN DURATION TO THE DURATION OF THE
WRITTEN LIMITED WARRANTIES CONTAINED HEREIN. Some states do not permit limitation
or exclusion of implied warranties; therefore, the aforesaid limitation(s) or exclusion(s) may not
apply to the purchaser.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
10/95
We Service What We Sell
RadioShack
A Division of Tandy Corporation
Fort Worth, Texas 76102
7/96
Printed in the USA
Download from Www.Somanuals.com. All Manuals Search And Download.
|