Thank you for purchasing this tablet DVD player. Please read this manual carefully
before operating and reserve it for future reference. It will be helpful to you if you
encounter any operational problem.
PACKAGE CONTENTS
PACKAGE CONTENTS....................................................9
10
10
11
12
12
13
14
15
15
16
FITTING PORTABLE DVD PLAYER TO
HEADREST MOUNT........................................................
16
17
CONNECTING THE ADAPTER TO THE DC IN 12V
SOCKET..........................................................................18
18
19
.........
20
21
CONNECTION
BETWEEN PLAYERS
AVP CABLE................................................................. 22
MOVIE SHARE OPERATION...................................... 22
25
25
26
27
28
28
28
29
29
29
30
30
30
30
30
31
32
32
33
PLAYING DivX FILES..................................................
USING THE USB PORT.............................................. 33
USING THE SD/MS/MS-PRO/MMC CARD SLOT......
34
35
36
36
37
38
38
38
39
39
40
40
41
41
IR HEADPHONE..........................................................
42
42
43
43
44
44
45
46
47
Normally clean the player with a soft, dry cloth. For tough dirt, apply some neutral
detergent diluted in 5 to 6 parts water to a soft cloth, wring out thoroughly.
Wipe off the dirt, then wipe off the player with a dry cloth. Note that alcohol, thinner,
benzene, insecticides, etc., may cause the print or coating to peel off.
Also avoid leaving rubber or plastic products in contact with the player for long
periods of time, as this may damage the cabinet. When using chemically treated
cloths, read the cloth's instructions carefully. Always unplug the power cord from the
power outlet before cleaning the player.
Two main units
Two AC / DC adapters
AVP cable
Two car power cables
Two earphones
Two AV Cables
Two card-type remote control units
Two Headrest mounts
Carrying bag
NOTES:Actual products' appearance might vary slightly from the pictures shown.
Press it to enter AV IN/OUT adjustment, brightness, color, TFT mode and view mode.
Press the button once to enter AV IN / OUT adjustment. Use M- / M+ to adjust.
Press the button again to enter BRIGHTNESS mode. Use M- / M+ button to adjust
among level 0 to level 8.
Press the button again to enter COLOR mode. Use M- / M+ button to adjust among
level 0 to level 8.
Press the button again to enter TFT mode. Use M- / M+ button to switch between
16:9 and 4:3.
Press the button again to enter VIEW mode. Use M- /M+ button to switch between
obverse picture and reverse picture.
Keep pressing the button for about 1.5 seconds to turn off the TFT display and press
it again to resume display.
11-EN
B
A
NOTE:
To prevent leakage of fluid from the
lithium battery, remove the battery
when not using the remote control
unit for long periods of time (one
month or more). If the battery leaks
fluid, carefully wipe it out of the
battery case, then change to a new
lithium battery.
Caution: The battery may present a
risk of fire if mistreated. Do not
recharge, disassemble, or heat it
above 100 C.
Replace battery with the same type.
Dispose of used battery properly,
keep away from children and do not
dispose of in fire.
15-EN
1. Place the two mounting straps over your headrest with the mount's sponge facing
headrest, and release button on top.
2. Adjust to your deserved viewing angle, then firmly secure the mount by tightening
the straps.
See diagrams below.
FITTING PORTABLE DVD PLAYER TO HEADREST MOUNT
Gentle slide the Portable DVD player down by aligning the backpanel groove with the
headrest mount, until you hear the click sound.
See diagram below.
16-EN
With this player, you can enjoy powerful Dolby Digital or MPEG sound. Output the
digital signals from the player's digital output to a decoder or amplifier with built-in
decoder.
Ma in unit rig ht p a ne l
19-EN
Output the digital signals from the player 's digital output to a digital amplifier that
is not Doby/MPEG compatible. For instructions of audio settings, refer to AUDIO
OUT of AUDIO SETUP.
Ma in unit rig ht p a ne l
Carefully check the player s digital
output settings before connecting
the player to an amplifier equipped
with a digital audio input jack which
is not Dolby Digital / MPEG
compatible.
20-EN
CONNECTION BETWEEN PLAYERS
AVP CABLE
Video
Audio
DC IN
Video
Audio
DC OUT
Connect the two players with AVP cable as described below:
1. First, connect the AVP cable and the Master unit by inserting the DC IN
section of the cable to the DC OUT socket of the Master unit.
2. Second, plug the DC OUT section of the cable to the DC IN socket of the Slave unit.
Master
Slave
MOVIE SHARE OPERATION
WHEN SHARING A SAME MOVIE:
Master
Slave
22-EN
CONNECTION BETWEEN PLAYERS
1. Connect the two players with AVP cable first, and then plug the car power cable
to DC IN socket of the Master unit.
2. Turn on the two players.
3. Switch the Slave unit to AV IN status (refer to page 11 ) to stop normal playback
and let it act as a TFT monitor.
4. Put a disc into the Master unit to play the movie.
5. Then two of you can enjoy the same movie with your own player simultaneously.
WHEN ENJOYING TWO DIFFERENT MOVIES:
Master
Slave
1. Connect the two players with AVP cable first, and then plug the AC/DC adapter or
car power cable to DC IN socket of the Master unit.
2. Turn on the two players.
3. Put two different discs into these two players respectively.
4.The fantastic thing is that you can enjoy two different movies on these two players
at the same time.
One AC/DC adapter cannot supply enough power for two DVD players
simultaneously. Therefore it is recommended to enjoy movie-share in car only for
the car power cable does so.
IR CHANNELS ADJUSTMENT
1.When sharing a same movie, i.e. one DVD player acts as a monitor, the two DVD
players can choose the same IR channel option simultaneously.
23-EN
CONNECTION BETWEEN PLAYERS
2.When enjoying two different movies, the IR channels of the two DVD players
must be adjusted to channel A and channel B respectively. Or the channel
separation phenomenon will appear and interfere the receiving quality.
3.The relevant IR headphones should be switch to the corresponding channels in
compliance with the IR channel options of DVD players of all times.
CHANNEL
A
B
CHANNEL A
CHANNEL B
OFF
24-EN
1. Open the batteries cover.
2. Replace the 6 PCS AA batteries.
3. Generally speaking, DVD playback time will be more than two hours with 6 PCS
NI-MH batteries of 2300 mAH.
3. Remove the batteries when the player is not turned on.
4. Rechargeable batteries cannot be charged with the player.
27-EN
PLAYING DivX FILES
1. If the disc is playing, the USB card can not be read.
2. The player may not work properly if using USB connecting cable. Suggested not
to use it.
3. Supply USB 1.1 use.
33-EN
CD/DVD Dics, or USB device must be removed from the portable DVD player for
SD/MS/MS-Pro/MMC card to be read by the unit.
Install the card-reader as the following picture shows:
This product has been tested with most brand name flash media cards.
Using poor quality flash cards may affect the readability of the unit.
This unit can read flash memory card up to the capacity of 1Gb.
34-EN
Step1: for first time use: enter 0000 as password or assigned password to unlock.
Step2: once parental control is unlock, go to rating meun and assign rating.
Step3: enter new password of your choose in 4 digit number to lock player rating.
if you forget your assigned password, you can use 0000 to unlock the rating again.
38-EN
Highlight the AUDIO LANG option, and press the Arrow buttons to choose the audio
language you prefer. Press ENTER to confirm. If the disc you are playing has that
language available, it will output audio in that language. There are 8 optional audio
languages: Chinese, English, Japanese, French, Spanish, Portuguese, Italian and
German.
39-EN
Highlight the IR HEADPHONE item and use the Arrow buttons to choose the following
options: CHANNEL A, CHANNEL B and OFF. Press ENTER to confirm.
The selected IR option on the DVD player should be conformed to the adjustment
of the receiving IR earphone. Or no voice can be heard.
The default setting is OFF.
CHANNEL A
CHANNEL B
OFF
41-EN
Choose this setting to adjust the line out compressing ratio and get different effects.
If adjusting to FULL, the audio signal peak value will be compressed to be minimum;
while adjusting to OFF, to be maximum.
44-EN
DIVX(R) V IDEO ON DEMAND
Y OUR REGISTRATION CODE IS:
X XXXXXXX
[DONE]
The registration code will be changed each time you use it to download the DivX
files. You have to use new code to carry out downloading operation next time.
45-EN
|
