MG
SERIES
10CD
EMULATED
2 CHANNELS
CD INPUT
EQ
CLEAN
OVERDRIVE
CONTOUR
LINE OUT
Owners Manual
Download from Www.Somanuals.com. All Manuals Search And Download.
WARNING! - Important safety instructions
!
WARNING: This apparatus must be earthed!
A
B
PLEASE read this instruction manual carefully before switching on.
ALWAYS use the supplied mains lead, if a replacement is required please contact your
authorised Marshall Dealer.
Note: Closed back equipment with non-detachable mains cord.
When the equipment is not in use or is being transported, the mains
cord should be gathered and retained under the top strap handle to
prevent damage. See diagram.
C
D
E
NEVER attempt to by-pass the fuses or fit ones of the incorrect value.
DO NOT attempt to remove the amplifier chassis, there are no user serviceable parts.
Refer all servicing to qualified service personnel.
Servicing is required when the apparatus has been damaged in any way, such as when the
power supply cord or plug is damaged, liquid has been spilled or objects have fallen into the
apparatus, the apparatus has been exposed to rain or moisture, does not operate normally
or has been dropped.
F
NEVER use an amplifier in damp or wet conditions.
G ALWAYS unplug this apparatus during lightning storms or when unused for long periods of
time.
H PROTECT the power cord from being walked on or pinched particularly at plugs,
convenience receptacles and at the point where they exit from the apparatus.
I
DO NOT switch the amplifier on without the loudspeaker connected.
➲
Note: This equipment has been tested and found to comply with the requirements of the EMC
directive (Environments E1, E2 and E3 EN 55103-1/2) and the Low Voltage directive in the E.U.
➲
➲
EUROPE ONLY - Note: The Peak Inrush current for the MG10CD is 2 amps.
CAUTION: Any changes or modifications not expressly approved by the party responsible for
compliance may void the users authority to operate the equipment.
➲
Note: It is recommended that all audio cables used to connect to the MG10CD are of a high
quality screened type. These should not exceed 10 metres in length.
➲ WARNING: Always ensure free movement of air around the amplifier!
USA ONLY - DO NOT defeat the purpose of the polarised or grounding type plug. A
polarised plug has two blades with one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the third prong are provided for your safety.
When the provided plug does not fit into your outlet, consult an electrician for replacement of the
obsolete outlet.
Follow all instructions and heed all warnings
KEEP THESE INSTRUCTIONS !
Download from Www.Somanuals.com. All Manuals Search And Download.
2
MG10CD Front Panel Features
1
2
3
4
5
6
7
8
9
1. INPUT jack
Use a good quality guitar (screened) cable to
plug your guitar in here.
7. CD IN & EMULATED LINE OUT jack
The MG10CD cleverly combines its Line Out
and CD Input functions. If you want to jam to
your favourite CD or tape, merely connect the
headphone output of your CD or tape player
here, adjust the player’s volume to match that of
your guitar and ‘hey-presto’ – you've got the
perfect ‘play-along’ practice system.
2. Clean VOLUME control
When the OD Select switch is ‘out’, this control
adjusts the volume of the Clean Channel. At low
settings the sound will be very clean with a bell-
like ring. Turning this control above half way will
introduce a desirable, bluesy distortion as the
power amplifier is driven into ‘crunch mode’.
Alternatively, you can use this socket to
connect the MG10CD to your multi-track
recording machine and you’ll get a great guitar
sound direct to disk or tape.
3. OD (Overdrive) SELECT switch
Depressing the Overdrive Select Switch will
engage the Overdrive Channel.
HELPFUL HINT: for ‘silent’ recording merely
plug an unconnected jack plug to the headphone
socket and you’ll disconnect the MG10CD’s
internal speaker.
4. Overdrive GAIN control
Turning up the Overdrive Gain Control will
increase the amount of distortion generated in
the Overdrive channel. Low gain settings will
produce classic rock and blues tones. Crank the
Gain for fat and aggressive sounds that are
perfect for soloing or hard rock and nu-metal
riffs.
8. EMULATED HEADPHONES jack
Plug your headphones here for a killer speaker
emulated sound! Doing this mutes your
MG10CD's internal speaker for ‘silent’ practice.
9. POWER Switch & LED
The power switch turns your amplifier on and
off. The LED will be lit when your amplifier is on
and will not be lit when the amplifier is switched
off.
5. Overdrive VOLUME control
Amazingly enough, this control adjusts the
volume of the Overdrive channel!
Note: Before connecting to the mains
electricity supply, always ensure that your
electricity supply is compatible with your
amplifier, as detailed on the rear panel.
The louder this channel is set, the ‘looser’ the
amplifier will sound and feel. This behaviour is
exactly what a good all-valve amplifier does and
is a result of our proprietary FDD circuitry.
Please ensure the amplifier is switched off and
unplugged from the mains electricity supply
before being moved.
6. CONTOUR control
This highly effective tone control works on both
the Clean and Overdrive channels. By radically
modifying the mid-range (body), the tone can
range from traditional and woody sounding
(setting at 10), to aggressive, ‘scooped’ and
modern (setting at 0) and all points in-between.
Download from Www.Somanuals.com. All Manuals Search And Download.
3
MG
SERIES
10CD
Technical Specification
Especificaciones técnicas
Technische Daten
Caractéristiques techniques
Power Output
10W RMS into 8Ω
Potencia de salida
Ausgangsleistung
Puissance de sortie
10W RMS sobre 8Ω
10W RMS an 8Ω
10W RMS sous 8 ohms
10W RMS / 8Ω
Main Guitar • Input Impedance
1MΩ
Impedancia de entrada principal de guitarra
Guitar • Input Eingangsimpedanz
Impédance d'entrée
1MΩ
1MΩ
1MΩ
1MΩ
CD Input • Input impedance
3.3kΩ
Impedancia de entrada de CD
CD Input • Eingangsimpedanz
Impédance d'entrée CD
3.3kΩ
3.3kΩ
3.3kΩ
3.3kΩ
Emulated Output • Level
-10dBV
Nivel de salida de línea simulada
Emulated Output • Ausgangspegel
Niveau de sortie
-10dBV
-10dBV
-10dBV
-10dBV
Weight
5.0kg
Peso
5.0kg
5.0kg
5.0kg
5.0kg
Gewicht
Poids
Size (mm)
290mm x 290mm x 180mm
Tamaño (mm)
Maße (mm)
Taille (mm)
290mm x 290mm x 180mm
290mm x 290mm x 180mm
290mm x 290mm x 180mm
290mm x 290mm x 180mm
Download from Www.Somanuals.com. All Manuals Search And Download.
1 6
Here follows four sample settings to act as starting
points from which to develop your own sounds.
Suggested Settings
Configuraciones que sugerimos
Soundvorschläge
N.B. Volume should be adjusted to taste.
Exemples de Réglages
Out
In
In
In
Marshall Amplification plc
Denbigh Road, Bletchley, Milton Keynes, MK1 1DQ, England
Tel : [01908] 375411 Fax : [01908] 376118
Whilst the information contained herein is correct at the time of publication, due to our policy of constant improvement
and development, Marshall Amplification plc reserve the right to alter specifications without prior notice.
Download from Www.Somanuals.com. All Manuals Search And Download.
230V
|