Lumex Syatems Mobility Aid 80500 User Manual

Freedom Walker  
Item 80500  
Contents:  
(1) Partially assembled walker frame, outriggers,  
adjustable seat and gate  
(1) PVC back section with mesh vinyl backrest sling  
(4) Four caster wheels (2 braking / 2 non-braking)  
(2) Two each parallel arms  
(4) Four safety wire lock pins, pins are to secure the  
adjustable height section  
(1) Adjustable safety belt  
(14) Fourteen (14) each ½" stainless steel screws  
(2 each for the back section, 4 each for the  
caster section, 8 each for the out-riggers)  
(6) Six each 1" stainless steel screws (4 each for the  
adjustable arm section, 2 each for the swing gate)  
Assembly Instructions:  
Step 1  
Remove partially assembled walker from shipping container/box.  
Step 2  
Caster Assembly and Outriggers:  
1. Install one caster into each of the female fittings on the bottom frame section.  
2. Secure each caster by inserting one ½" screw into the pre-drill pilot hole on the  
female fitting and tighten with a Phillips screwdriver.  
3. Insert the outrigger into each side of the walker next to the casters. The front section  
of the outrigger (three way fitting) must connect into the front section (four way  
fitting on the frame). Secure the outrigger with one ½" stainless steel screw. Insert the  
vertical support legs into the outrigger (4 each of leg piping). Secure each vertical  
support leg with one ½" stainless steel screw.  
Step 3  
Adjustable Seat:  
1. Align bottom of the seat section fittings with the top of the 1" PVC pipe that extends  
out from the lower base near the casters. Slide the 1" PVC pipe vertically into the seat  
section until the last vertical adjustable hole is exposed. The four safety wire lock pins  
fit into each fitting that accommodates the 1" PVC pipe. The (T) fittings and the four  
(FOUR WAY) fitting takes 1 safety wire lock pin to secure the 1" PVC pipe from moving.  
2. Connect the seat section with the bottom half of the 1" PVC pipe. The 1" PVC pipe  
needs to be secure with the fittings located above the casters.  
3. Secure the 1" PVC pipe and with 1 each of the 1" stainless steel screws.  
80500-INS-LABRevA06  
Download from Www.Somanuals.com. All Manuals Search And Download.  

LaCie Computer Drive CloudBox User Manual
Linksys Network Card USB100TX User Manual
Makita Impact Driver 6917FDWDE User Manual
Marantz Stereo Amplifier ZC4001 User Manual
Mark Levinson Stereo Amplifier N434 User Manual
Maytag Washer 120 V User Manual
McCulloch Lawn Mower 96012010300 User Manual
Meade Telescope 90AZ ADRB User Manual
Memorex MP3 Player MPD8857 User Manual
MicroNet Technology Switch SP648B User Manual