750,20ꢀm
reV. a 05/2008
Log PLacement
guide
ELDV3530/ELDV4035/ELDV4540
ELitE SEriES
Log PLacement guide for eLdV3530/eLdV4035/eLdV4540
eLite SerieS gaS aPPLianceS
generaL information
This log placement guide has been prepared to present detailed place-
ment illustrations and provide instruction to assist in the initial (new
appliance) setup and after the annual cleaning and inspection cycles.
The information provided here is to be used in conjunction with the
Care and Operation Instructions provided together with this document
in the appliance literature packet. Please read the Care and Operation
Instructions completely before completing the procedures detailed in
this placement guide.
Figure 1
glowing embers
(rockwool)
main Ports
glowing embers
(rockwool)
initiaL inStaLLation conSiderationS
If the logs are being installed for the first time, the following para-
graphs apply:
DO NOT attempt to install the logs until the appliance installation
has been completed, the gas line connected and tested for leaks and
the initial burner operation has been checked out.
Step ꢀ. Remove the appliance front door.
Step 2. Cut and remove the nylon strapping securing the log set
inside the fireplace.
do not Place
embers on
main Ports
mixture of Vol-
cano Stone
& Vermiculite
Place embers
in front of
Ports Here
Step 3. Remove the logs from their packaging. Handle logs care-
fully to prevent breakage.
Figure 2
Log and gLowing ember PLacement
Step ꢀ. Position the individual logs as shown in Figures 3, 4 and 5.
Logs should be placed in the order shown.
Proper log and twig placement is critical to encourage outstanding
flame appearance and prevent sooting.
Step 2. Separate the Glowing Ember (Rockwool) into pieces about
the size of a nickel (see Figure 1). Keep the pieces fluffed up with
torn edges and not matted. Distribute these pieces over the burner as
shown in Figure 2. Do not use more than necessary. When properly
positioned, the Glowing Embers will cover approximately 10% of the
burner. Do not place embers on main ports.
These fires are designed to provide a rich orange/red glow on the logs.
Rear log (2) placement is critical. An adjustment of one quarter of an
inch can have significant effect on flame color and height. Pull rear log
(2) forward as far as it will go on the pins.
Note: The log set and fire are artistically arranged to provide a random
asymmetric look to the fire. The fire intentionally does not burn in the
left rear quarter of the log set.
Step 3. Place a mixture of volcanic stone and vermiculite around the
burner as shown. do not place the mixture on the burner.
Note: Excessive use of embers may result in sooting or poor flame.
This appliance is provided with enough Glowing Embers for several
applications, do not feel compelled to use all that is in a new bag. For
best glowing effect, replace the ember material annually. Replacement
Glowing Embers are available (Catalog Number 88L53).
US
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Download from Www.Somanuals.com. All Manuals Search And Download.
eLdV4035 Log PLacement
Log
number
2
description
1
2
3
4
5
Log, Center
Log, Rear
Log, Front
Log, Left
4
5
Log, Right
catalog number for the entire
log set: H4657
3
ꢀ
baffle Pins
align the holes at the bottom of log (4)
over the pins on logs (ꢀ) and (2)
baffle
ꢀ
2
4
3
grate
assembly
burner
align holes at the bottom of log (ꢀ) over the
pins on the burner
align groove at the bottom of log (3)
over the grate as shown.
ꢀ
Step ꢀ
Step 3
align the groove at the bottom of log (5) over the grate as-
align holes at the bottom of log (2) over the pins
sembly and on the landing area of log (4) as shown.
of the back baffle.
2
4
5
ꢀ
Step 2
Step 4
Figure 4
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
3
Download from Www.Somanuals.com. All Manuals Search And Download.
eLdV4540 Log PLacement
(Repeat StepS 1 thRu 4 FRom eLDV4035 Log pLacemeNt aND theN aDD the FoLLowiNg StepS)
Log
number
4
7
2
description
1
2
3
4
5
6
7
Log, Center
Log, Rear
6
Log, Front
Log, Left
Log, Right
Log, Right/Rear
Log, Left/Rear
catalog number for the entire
log set: H4658
ꢀ
5
3
Place log (7) over log (4) as shown
Place log (6) between log (2) and log (5) as shown
7
4
2
6
5
Step 5
Step 6
Figure 5
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Lennox Hearth Products reserves the right to make changes at any time, without notice, in design, materials, specifications, prices and also to discontinue colors, styles and products.
Consult your local distributor for fireplace code information.
Printed in U.S.A. © 2006 by Lennox Hearth Products
LHP
P/n 750,20ꢀm reV. a 05/2008
ꢀꢀꢀ0 west taft avenue • orange, ca 92865
Download from Www.Somanuals.com. All Manuals Search And Download.
|