VHF FM REPEATER/ UHF FM REPEATER
TKR-740/ TKR-840
KENWOOD CORPORATION
© B62-1136-00 (K)
09 08 07 06 05 04 03 02 01 00
INSTRUCTION MANUAL
•
If you detect an abnormal odor or smoke coming from the unit,
disconnect the power from the unit immediately. Contact your
KENWOOD service center or dealer.
THANK YOU!
We are grateful you purchased this KENWOOD repeater.
We believe this easy-to-program repeater will be highly
effective in your communications system, and will keep
personnel operating at peak efficiency.
NOTICES TO THE USER
FCC WARNING
KENWOOD incorporates the latest in advanced
technology into all of our products. As a result, we feel
strongly that you will be pleased with the quality and
features of this product.
This equipment generates or uses radio frequency energy. Changes or
modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
FEATURES
◆
GOVERNMENT LAW PROHIBITS THE OPERATION OF
UNLICENSED RADIO TRANSMITTERS WITHIN THE
TERRITORIES UNDER GOVERNMENT CONTROL.
ILLEGAL OPERATION IS PUNISHABLE BY FINE OR
IMPRISONMENT OR BOTH.
•
•
•
•
•
You can easily program channel data using the KPG-47D
version 2.00 or later (optional) on a PC.
You can recall 1 of 32 preset channels using either a PF key or
the external control line.
◆
◆
REFER SERVICE TO QUALIFIED TECHNICIANS ONLY.
The firmware can be written to the Flash memory through an
external source.
QT/DQT signalling can be programmed on each channel. It
simultaneously decodes up to 16 different QT/DQT tones.
UNPACKING AND CHECKING EQUIPMENT
Note: The following unpacking information is for use by your KENWOOD
dealer, an authorized KENWOOD service facility, or the factory.
When using the KPG-47D version 2.00 or later (optional), RX
PLL lock voltage, RX input signal strength, TX PLL lock voltage,
TX output power, and the power supply voltage can be
monitored on a PC.
Carefully unpack the repeater. We recommend that you
identify the items listed in the following table before
discarding the packing material. If any items are missing
or have been damaged during shipment, file a claim with
the carrier immediately.
•
•
The interface port can be used with external equipment, such
as a repeater controller.
The repeater has multi-mode capability.
Wide: 30 kHz, 25 kHz/ Narrow: 15 kHz,12.5 kHz (TKR-740)
Wide: 25 kHz/
Narrow: 12.5 kHz
(TKR-840)
Item
Part Number Quantity
•
You can adjust the following functions from a PC:
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
CW ID Deviation
Front glass
Fuse (4 A)
B10-2590-X4
F06-4027-X5
K01-0421-X5
E37-0711-X5
1
1
1
1
1
1
1
1
Digital Pager Balance
Digital Pager Deviation
DQT Deviation
Handles and screw set
Power cable assembly
Maximum Deviation
QT Deviation
Remote TA
Lead wire with connector (15 pin) E31-3228-X5
Repeat Gain Level
TX Power
Square plug (12 pin)
Dressed screw
E59-0410-X5
N08-0543-X4
B62-1136-XX
RX Audio Signal Output (RA)
RX Detector Signal Output (RD)
Signalling Balance
Signalling Deviation (SD)
Squelch (Analog/ RSSI)
Test Tone Deviation
TX Audio Input (TA)
Voting Tone Level
Instruction manual
INSTALLATION
To install the handles onto the front panel of the repeater,
align the handles with the holes on the front panel, then
secure the handles using the supplied screws.
Please consult your dealer for installing the repeater and
antenna.
PRECAUTIONS
•
•
•
•
Do not expose the unit to rain or moisture; to prevent fire or
electric shock.
MICROPHONE
Connect an optional KMC-27A, KMC-27B, or KMC-9C
KENWOOD microphone to the MICROPHONE jack on
the front panel.
Do not open the unit under any circumstances; to avoid risk of
electric shock.
Do not expose the unit to long periods of direct sunlight, nor
place it close to heating appliances.
Do not place the unit in excessively dusty and/or humid areas,
nor on unstable surfaces.
Download from Www.Somanuals.com. All Manuals Search And Download.
|