Juniper Networks Network Router J4300 User Manual
J4300 and J6300 Services Router PIM  
Installation Instructions  
4 November 2004  
Part No: 530-011519-01  
Revision 1  
This document describes how to remove and replace a Physical Interface Module  
(PIM) on Juniper Networks J4300 and J6300 Services Routers. For hardware  
installation and basic troubleshooting procedures for J-series Services Routers, see  
the J-series Services Router User Guide.  
Contents  
Tools and Parts Required........................................................... 2  
Replacing a PIM..................................................................... 2  
Removing a PIM ............................................................... 2  
Installing a PIM................................................................. 3  
List of Technical Publications ...................................................... 4  
Requesting Support................................................................. 6  
Revision History .................................................................... 7  
1
Download from Www.Somanuals.com. All Manuals Search And Download.  
7. Loosen the captive screws on each side of the PIM faceplate.  
8. Grasp the handles on each side of the PIM faceplate and slide the PIM out of  
the router. Place it in the electrostatic bag or on the antistatic mat.  
9. If you are not reinstalling a PIM into the emptied slot, install a blank PIM panel  
over the slot to maintain proper airflow.  
Figure 1: Removing a PIM  
5/0  
SLOT  
0
0
3
J4  
T
C
E
J
E
H
S
A
I
N
L
F
T
C
A
P
M
3/0  
O
C
E
S
U
T
E
SLOT  
0
0
N
T
R
E
O
L
/1  
0
H
T
1
T
R
1
S
O
P
E
1/0  
SLOT  
ATUS  
ST  
1
T
POR  
IG  
F
M
N
N
O
L
R
O
A
R
L
E
C
A
S
U
IA  
R
T
A
ST  
E
S
W
O
0
P
RT  
PO  
Captive screws  
Installing a PIM  
To install a PIM (see Figure 2):  
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and  
connect the strap to the ESD point on the chassis, or to an outside ESD point if  
the Services Router is disconnected from earth ground. For more information  
about ESD, see the J-series Services Router User Guide.  
2. Press and release the power button to power off the router. Verify that the  
POWER ON LED blinks and then turns off.  
3. Align the notches in the connector at the rear of the PIM with the notches in  
the PIM slot in the Services Router, and then slide the PIM in until it lodges  
firmly in the router.  
CAUTION: Slide the PIM straight into the slot to avoid damaging the components  
on the PIM.  
Installing a PIM  
3
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
J4300 and J6300 Services Router PIM Installation Instructions  
4. Tighten the captive screws on each side of the PIM faceplate.  
5. Insert the appropriate cables into the cable connectors on the PIM.  
6. If necessary, arrange the cables to prevent them from dislodging or developing  
stress points:  
Secure the cable so that it is not supporting its own weight as it hangs  
to the floor.  
Place excess cable out of the way in a neatly coiled loop.  
Use fasteners to maintain the shape of cable loops.  
7. Press and release the power button to power on the router. Verify that the  
POWER ON LED lights steadily after you press the power button.  
8. Verify that the PIM status LED lights steadily green to confirm that the PIM  
is online.  
You can also verify correct PIM functioning by issuing the show chassis fpc  
pic-status command described in the JUNOS Protocols, Class of Service, and  
System Basics Command Reference.  
Figure 2: Installing a PIM  
5/0  
SLOT  
0
0
3
4
J
T
C
E
J
E
N
S
H
S
I
A
L
F
T
C
A
P
M
3/0  
E
O
C
U
T
E
SLOT  
0
0
N
T
R
E
O
L
/1  
0
H
T
1
T
R
1
S
O
P
E
1/0  
SLOT  
S
ATU  
ST  
1
T
POR  
IG  
F
M
N
N
O
L
R
O
A
R
L
E
C
A
S
U
IA  
R
T
A
ST  
E
S
W
O
0
P
RT  
PO  
List of Technical Publications  
Table 1 lists the software and hardware guides and release notes for Juniper  
Networks routing platforms that use the JUNOS Internet software and describes  
the contents of each book.  
4
List of Technical Publications  
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
Table 1: Juniper Networks Technical Documentation  
Book  
Description  
JUNOS for J-series, M-series, and T-series Routing Platforms Configuration Guides  
Feature Guide  
Provides a detailed explanation and configuration examples for  
several of the most complex features in the JUNOS software.  
System Basics  
Provides an overview of the JUNOS software and describes how to  
install and upgrade the software. This manual also describes how  
to configure system management functions and how to configure  
the chassis, including user accounts, passwords, and redundancy.  
Network Interfaces and Class of Service  
Provides an overview of the network interface and class-of-service  
functions of the JUNOS software and describes how to configure  
the network interfaces on the router.  
MPLS Applications  
Multicast Protocols  
Network Management  
Provides an overview of traffic engineering concepts and describes  
how to configure traffic engineering protocols.  
Provides an overview of multicast concepts and describes how to  
configure multicast routing protocols.  
Provides an overview of network management concepts and  
describes how to configure various network management features,  
such as SNMP, accounting options, and cflowd.  
Policy Framework  
Routing Protocols  
Services Interfaces  
Provides an overview of policy concepts and describes how to  
configure routing policy, firewall filters, and forwarding options.  
Provides  
an overview of routing concepts and describes how to  
configure routing, routing instances, and unicast routing protocols.  
Provides an overview of the services interfaces functions of the  
JUNOS software and describes how to configure the services  
interfaces on the router.  
VPNs  
Provides an overview and describes how to configure Layer 2 and  
Layer 3 virtual private networks (VPNs), virtual private LAN service  
(VPLS), and Layer 2 circuits. Provides configuration examples.  
JUNOS References  
Network and Services Interfaces Command  
Reference  
Describes the JUNOS Internet software operational mode  
commands you use to monitor and troubleshoot network and  
services interfaces on Juniper Networks routing platforms.  
Protocols, Class of Service, and System Basics  
Command Reference  
Describes the JUNOS Internet software operational mode  
commands you use to monitor and troubleshoot most aspects of  
Juniper Networks routing platforms.  
System Log Messages Reference  
Describes how to access and interpret system log messages  
generated by JUNOS software modules and provides a reference  
page for each message.  
JUNOScript API Documentation  
JUNOScript API Guide  
Describes how to use the JUNOScript application programming  
interface (API) to monitor and configure Juniper Networks routers.  
JUNOScript API Configuration Reference  
JUNOScript API Operational Reference  
Provides reference pages for the configuration tags in the  
JUNOScript API.  
Provides reference pages for the operational tags in the JUNOScript  
API.  
List of Technical Publications  
5
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
J4300 and J6300 Services Router PIM Installation Instructions  
Book  
Description  
JUNOS Comprehensive Index and Glossary  
Comprehensive Index and Glossary  
Provides a complete index of all JUNOS Internet software books  
and the JUNOScript API Guide. Also provides a comprehensive  
glossary.  
Hardware Documentation  
Hardware Guide  
Describes how to install, maintain, and troubleshoot routers and  
router components. Each platform has its own hardware guide.  
PIC Guide  
Describes the router Physical Interface Cards (PICs). Each router  
platform has its own PIC guide.  
JUNOScope Documentation  
JUNOScope Software User Guide  
Describes the JUNOScope software graphical user interface (GUI),  
how to install and administer the software, and how to use the  
software to manage router configuration files and monitor router  
operations.  
J-series Services Router Documentation  
J-series Services Router User Guide  
Contains instructions for installing, configuring, and managing a  
J-series Services Router. The guide explains how to prepare your  
site for installation, unpack and install the hardware, power on the  
router, configure secure routing, monitor network operations, and  
perform routine maintenance.  
Release Notes  
JUNOS Internet Software Release Notes  
Provide a summary of new features for a particular software  
release. Software release notes also contain corrections and  
updates to published JUNOS and JUNOScript manuals, provide  
information that might have been omitted from the manuals, and  
describe upgrade and downgrade procedures.  
Hardware Release Notes  
Describe the available documentation for the router platform  
and summarize known problems with the hardware and  
accompanying software. Each platform has its own release notes.  
JUNOScope Software Release Notes  
J-series Services Router Release Notes  
corrections and updates to the published JUNOScope  
manual, provide information that might have been omitted from  
the manual, and describe upgrade and downgrade procedures.  
Contain  
Briefly describe Services Router features, identify known hardware  
problems, and provide upgrade and downgrade instructions  
Requesting Support  
For technical support, open a support case using the Case Manager link at  
http://www.juniper.net/support/ or call 1-888-314-JTAC (within the United States) or  
1-408-745-9500 (outside the United States).  
For documentation issues, fill out the bug report form located at  
http://www.juniper.net/techpubs/docbug/docbugreport.html.  
6
Requesting Support  
Download from Www.Somanuals.com. All Manuals Search And Download.  
 
Revision History  
4 November 2004—Revision 1.  
Copyright © 2004, Juniper Networks, Inc. All rights reserved.  
Juniper Networks, the Juniper Networks logo, NetScreen, NetScreen Technologies, the NetScreen logo, NetScreen-Global Pro, ScreenOS, and  
GigaScreen are registered trademarks of Juniper Networks, Inc. in the United States and other countries.  
The following are trademarks of Juniper Networks, Inc.: ERX, ESP, E-series, Instant Virtual Extranet, Internet Processor, J2300, J4300, J6300, J-Protect,  
J-series, J-Web, JUNOS, JUNOScope, JUNOScript, JUNOSe, M5, M7i, M10, M10i, M20, M40, M40e, M160, M320, M-series, MMD, NetScreen-5GT,  
NetScreen-5XP, NetScreen-5XT, NetScreen-25, NetScreen-50, NetScreen-204, NetScreen-208, NetScreen-500, NetScreen-5200, NetScreen-5400,  
NetScreen-IDP 10, NetScreen-IDP 100, NetScreen-IDP 500, NetScreen-Remote Security Client, NetScreen-Remote VPN Client, NetScreen-SA 1000 Series,  
NetScreen-SA 3000 Series, NetScreen-SA 5000 Series, NetScreen-SA Central Manager, NetScreen Secure Access, NetScreen-SM 3000, NetScreen-Security  
Manager, NMC-RX, SDX, Stateful Signature, T320, T640, T-series, and TX Matrix. All other trademarks, service marks, registered trademarks, or registered  
service marks are the property of their respective owners. All specifications are subject to change without notice. Juniper Networks assumes no responsibility  
for any inaccuracies in this document. Juniper Networks reserves the right to change, modify, transfer, or otherwise revise this publication without notice.  
Requesting Support  
7
Download from Www.Somanuals.com. All Manuals Search And Download.  
 

Indesit Washer IWE81281K User Manual
Intel Computer Hardware 273561 003 User Manual
Jacuzzi Hot Tub U961000G User Manual
JL Audio Car Speaker SB T 4RNR 10W User Manual
Johnson Controls Furnace TM9V MP User Manual
Kenwood Car Video System KVT 735DVD User Manual
Kenwood Power Supply PS 53 User Manual
King Canada Portable Generator KCG 1500G User Manual
KitchenAid Projector KAWE450V User Manual
Kole Audio electronic Stereo Amplifier PH1 2000D User Manual