SB-POL-RGRRZR INSTR_SKU# 94456
InstallatIon
d I F F I C u lt Y :
Slampak
If you choose to perform the installation yourself, it is absolutely vital that the
Slampak® be properly mounted to the vehicle according to these instructions.
Failure to mount the enclosure properly presents two problems:
out
oF
I n s t a l l a t I o n G u I d e
for the
1) The sub-bass performance will suffer due to the movement of the enclosure
caused by the force exerted by the woofer(s).
25
SB-POL-RGRRZR
2) A loose enclosure presents a serious safety hazard in the event of a collision
or sudden deceleration.
estImated tIme:
1-2 HouRs
sKu#94456
2009+
s t e P
1
Unpack the Slampak® mount the two brackets as shown
Thank you for choosing a JL Audio Slampak® for your side by side sport utility sound system. With
proper installation, your new vehicle-specific enclosed subwoofer system will deliver years of listening
pleasure.
s t e P
2
There are two each of the pictured clamps, the ones with
the short spacers (un-assembeled in the bag) go directly
in front of the speakers, the ones with the long spacers
(assembeled on the right) are installed from below, there are
also locking pins that are not shown that are available and,
can be put in place through the clamps to keep them in the
locked positions. Make sure that all of the hardware on each
of the clamps is snug so that when the arm is pushed flat,
the rubber section of the clamp is squeezed and expands to
hold the clamp in place.
We strongly recommend that you have your new Slampak® installed by your authorized JL Audio
dealer. The installation professionals employed by your dealer have the necessary tools and experience
to disassemble and reassemble your vehicle properly. Also, keep in mind that your warranty coverage
extends to 2 years if your system is installed or approved by your authorized JL Audio dealer. If you
prefer to perform your own installation, please read this installation guide completely
before beginning the process.
s t e P
3
Line up the brackets with the existing holes as shown in the
pictures at left and below.
Continued on Next Page
Download from Www.Somanuals.com. All Manuals Search And Download.
SB-POL-RGRRZR INSTR_SKU# 94456
s t e P 1 1
s t e P 1 4
As you run the cable up under the hood, take precautions
to remain close to the OEM harness securing the two har-
nesses together with zip ties as shown to ensure that there
is no slack and, that the cables avoid an moving parts of the
vehicle such as the steering components shown.
Hook up the power and, ground, securing the fuse block to
the cabling with the supplied zip-ties.
s t e P 1 5
s t e P 1 2
Looking towards the “firewall” from the drivers side front tire,
locate the hole where the OEM harness runs towards the
dash. Run the cabling along with the OEM harness.
C o n G R a t u l a t I o n s !
You have completed the installation for this model!
s t e P 1 3
If access to the amplifier is required, remove the four Allen
Head screws that secure the top cover.
From under the dash, run wires as needed to each of the
front speakers and, whatever source will be used. If using
a portable music source, run the remote turn-on wire to a
(+)12vdc switch to turn the amplifier on, off.
Looking at the control panel on the amplifier, these are the
recommended amplifier settings to optimize the perfor-
mance of the system. The final input sensitivity settings for
the amplifier may differ according to the source unit being
used.
s t e P 1 4 ( o P t I o n a l )
When running the wires from the firewall location as shown
above to each of the front speakers (for example, JL Audio
MX650-CCX-CG-TB as shown), make sure that those wires are
secured out of the way and cannot interfere with any safety
or control functions of the vehicle.
(954) 443-1100
note: if no speakers are being used in the front, the
speaker wires discussed above need to be insulated
and secured out of the way.
All specifications are subject to change without notice. “JL Audio®” and the JL Audio logo, “Stealthbox” and the Stealthbox logo are registered
trademarks of JL Audio, Inc. “Ahead of the Curve”and its respective logo is a trademark of JL Audio, Inc.
JLA-SKU# 94456 08-19-2009
•
Printed in USA
•
©2008 JL Audio, Inc.
•
U.S. PATENTS: #5,734,734 #5,949,898 #6,118,884 #6,229,902 #6,243,479
#6,294,959 #6,501,844 #6,496,590 #6,441,685 #5,687,247 #6,219,431 #6,625,292 #D472,891 #D480,709 Other U.S. & Foreign patents pending.
1
0
3
6
9
N
O
R
T
H
C
O
M
M
E
R
C
E
P
A
R
K
W
A
Y
•
M
I
R
A
M
A
R
,
F
L
O
R
I
D
A
•
3
3
0
2
5
•
U
S
A
Page 3 • JL Audio, Inc 2009
Download from Www.Somanuals.com. All Manuals Search And Download.
|