®
Stealthbox
I N S TALLATI O N GUI DE
START
HERE
for the
6.5”
6.5”
SB-GM-SLVEXT/10W6v2
(1999-2005 Chevrolet Silverado /
GMC Sierra Extended Cab Trucks
with full rear bench seating.)
(These instructions show for both enclo-
sures. These enclosures are
➔
➔
➔
➔
➔
X
X
6.0”
6.0”
sold separately )
Passenger’s Side
Driver’s Side
STEP 3: Thread in the supplied socket cup
set screw into the/each enclosure, leaving
about 1/2” of the treads exposed.
STEP 1: Remove all contents from the rear
STEP 1: Remove all contents from the rear
floor area.
floor area.
Make sure that the cup end of the set screw
is on the outside of the enclosure.
Remove the paper backing and place the sup-
plied wax square on the passenger’s side rear
floor.The middle of the wax square needs to
be placed 6.5” in front of the rear bulkhead
and 6.0” away from the transmission tunnel.
Remove the paper backing and place the sup-
plied wax square on the driver’s side rear floor.
The middle of the wax square needs to be
placed 6.5” in front of the rear bulkhead and
6.0” away from the transmission tunnel.
*CAUTIO N*
Before drilling, make sure that you are not going
to be drilling into any gas lines, brake lines, trans-
mission lines, electrical wiring, transfer case(4x4
vehicles) or anything else that might cause a
reduction in your weekly pay. Always wear eye
protection when drilling.
This Stealthbox is a product which
requires professional installation skills and
tools.
Please read this installation guide thor-
oughly before beginning the project. It
will guide you step by step through the
installation. Several of the steps in this
process may require two people to
accomplish.
➔
It is absolutely vital that the enclosure
be properly mounted to the vehicle
according to these instructions. Failure
to mount the enclosure properly pres-
ents two problems: 1) The sub-bass
performance will suffer due to the
movement of the enclosure caused by
the force exerted by the woofer(s) and
2) A loose enclosure presents a serious
safety hazard in the event of a collision
or sudden deceleration.
STEP 4: Place the/each enclosure into posi-
tion and press down firmly.
STEP 5: With the use of a 1/2” drill bit and drill.
Drill out the floor at the impression on the wax
square(s).
Remove the/each enclosure.The wax square
should have an impression of the socket cup
set screw.
Please enjoy your JL Audio Stealthbox
responsibly.
Continued on Next Page ➔
SB-GM-SXT/10W6v2, JL AUDIO, Inc 2006
Page 1
Sheet SKU#011199 Revision 1/12/2006
Download from Www.Somanuals.com. All Manuals Search And Download.
|