JBL Speaker System SP6CSII User Manual

JBL SP6CSII SoundPoint® Series  
JBL Loudspeaker Troubleshooting/Repair Tips  
Most customers prefer to do simple loudspeaker repairs themselves. By following the steps below, a majority of loudspeakers can be returned to  
their original factory performance with minimum effort. Choose the example that best describes the problem you are experiencing.  
Problem 1: No sound or distorted sound from one loudspeaker in a pair (or set)  
Connect the dead/distorting loudspeaker to a different amplifier channel (one that had a functioning loudspeaker connected to it). If it functions  
normally, the problem is not loudspeaker-related. If the loudspeaker still makes no sound or sounds distorted, a wire may have become loose  
or disconnected, the network (also known as a crossover) may be defective, the drivers (woofer, tweeter, etc.) may be defective or, in very rare  
cases, all may be defective.  
Refer to the wiring diagram and exploded view below. The network is a small circuit board found on the inside of the terminal cup, or mounted to  
an inside wall of the enclosure. It sends low-frequency sounds to the woofer, high-frequency sounds to the tweeter and, if applicable, mid-frequency  
sounds to the midrange driver. Make sure all wires are secure and connected. Look for components on the network that look burnt, bulged,”  
or abnormal. If everything looks normal, connect the network to the drivers from another matching loudspeaker. MAKE SURE you attach the  
correct wires to each driver – mid- and low-frequency sounds can damage the tweeter! If there is still no sound or distorted sound, the network  
is defective. If there is clean undistorted sound, the drivers are defective.  
Problem 2: No sound or distorted sound from one or more (but not all) drivers in an enclosure  
Remove the problem driver(s) from the enclosure and make sure all wires are secure and connected. If they are, proceed with the following test:  
Woofer or midrange driver – Connect the driver’s + and – input terminals directly to the loudspeaker wires from your receiver/amplifier and play  
some music at a reasonable volume. If the driver now sounds normal (produces a clean, undistorted sound), the network is most likely defective.  
Tweeter – Replace the tweeter with a functioning tweeter from another loudspeaker. If the tweeter now functions normally (produces clean,  
undistorted sound), the original tweeter is defective. If the replacement tweeter also sounds distorted or produces no sound, the network is  
most likely defective.  
Problem 3: Loudspeakers distort, rattle or pop at higher volumes  
This is usually NOT a loudspeaker problem. Common causes are too much power (playing the loudspeakers too loud and causing them to distort),  
an amplifier with not enough power (the amplifier can’t produce the required volume without distorting), excessive equalization (turning the tone  
controls too far clockwise, and/or engaging the loudness/bass boost button on your receiver) or some combination of the above. If only one  
loudspeaker is exhibiting the problem, and you’re confident that it’s not caused by too little power/too much power/excessive equalization, see  
solutions for Problems 1 and 2.  
1
WIRING DIAGRAM  
EXPLODED VIEW  
2
WOOFER/TWEETER  
ASSEMBLY  
16PR90CZH-FC05-EP  
3
11  
4
CROSSOVER  
NETWORKS (2)  
013-7600-00871-EP  
10  
5
6
7
9
8
ITEM  
PART NO.  
DESCRIPTION  
GRILLE ASSEMBLY  
SCREW, BAFFLE  
BAFFLE ASS’Y COMPLETE  
(BAFFLE, DOG EARS, CAPS)  
COAXIAL DRIVER 6-1/2"  
WOOFER/TWT ASSEMBLY  
SCREW, WOOFER  
QTY.  
1
4
ITEM  
8
PART NO.  
DESCRIPTION  
QTY.  
1
2
3
329-060-00780-0WAE  
352-BM04050D386-E  
248-000-05010-0WBE  
309-ABS-05040-0WBE  
325-ABS-00446  
301-ABS-00373-0WBE  
316-PC-05201-0TAE  
406-000-05702-E  
N/A  
402-000-05759-E  
403-000-05006-E  
431-000-05054-E  
CAP, PLASTIC DOG EAR  
PLASTIC DOG EAR  
BAFFLE Only  
4
4
1
1
1
1
1
1
1
9
10  
11  
12  
13  
14  
15  
16  
1
JBL LOGO  
4
16PR90CZH-FC05-EP  
OWNER’S MANUAL  
WARRANTY CARD  
OUTER CARTON  
TEMPLATE  
1
4
2
4
5
6
7
352-FM04010D462-E  
013-7600-00871-EP  
352-CM04008D144-E  
CROSSOVER NETWORK  
SCREW, NETWORK  
FOAM PACKING (SET)  
SP6CSII ROUGH-IN FRAME PART NO. RIF6CS  
Download from Www.Somanuals.com. All Manuals Search And Download.  

Indesit Dishwasher IDE 750 User Manual
IOGear Switch GUWH104KIT User Manual
JL Audio Car Speaker SB F TRKEXT 8W1 User Manual
John Lewis Refrigerator JLBIFF 1802 User Manual
John Lewis Washer JLWM1201 User Manual
JVC Car Stereo System GET0638 001A User Manual
Kenmore Gas Grill 415162090 User Manual
Kenwood Car Video System KVT627DVD User Manual
KitchenAid Clothes Dryer KEYS977E User Manual
Konica Minolta Printer magicolor 2430 DL User Manual