INSTALL INSTRUCTIONS C-VS-1200-EXPD-1
VEHICLE SPECIFIC CONSOLE
2007-2008 FORD EXPEDITION (w/ Console shifter)
TOOLS REQUIRED:
Ratcheting wrench
Sockets Set
Screwdriver set
T-20 torx bit
Panel pulling tool
HARDWARE:
QTY DESCRIPTION
PART #
4
4
#10 x ½” Phillips machine screw
#10 Keps nut
GSM33118
GSM30028
Always!
ꢀ Read all instructions before installing any Havis-Shields Equipment Corp products.
ꢀ Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
ꢀ Use hardware provided with install kit
ꢀ For product support, visit the Install Instructions Section of our website at
C-VS-1200-EXPD-1
#10 x ½” Machine
screws and keps nuts
Front
Rear
Remove (4) hex screws holding
armrest pad from hinge
Remove the rear OEM cup
holder
Pry up on accessory pocket trim
panel and remove
Remove hex head screws holding
side of accessory pocket
Remove hex head screws
holding rear of accessory pocket
Remove hex head screws holding
lower sides accessory pocket
Completely remove the container
of the accessory pocket
Parts removed from OEM
console
C-VS-1200-EXPD-1_INST_9-07
3
Replace the trim panel
previously removed earlier
Replace trim panel around
factory cup holder
Replace the trim panel around
gear shifter
Replace rear cup holders
Replace hex head screw on
accessory pocket
Position console so holes in side
of console align w/ holes in
factory console
Install #10 x ½” machine
screws and keps nuts as shown
above
View of specific application
including C-TCB-24, C-
ARM-2, C-3090-7, control
heads, etc..(Sold Seperatly)
View of console installed
C-VS-1200-EXPD-1_INST_9-07
4
|