Start Here
Easy Setup Instructions
4 Prepare the print head.
5 Insert the print head.
READ THIS SHEET FIRST
Thank you for purchasing the Canon PIXMA MP760. To prepare your machine for use, please follow these
(2) Push back.
Easy Setup Instructions before referring to any other documentation.
Do not touch!
(1) Insert.
IMPORTANT
Remove the protective cap and discard it.
Do not connect the USB cable until after the software is installed. See the rear side of this sheet for details.
Do not touch!
6 Lower the lock lever.
1 Unpack and install the machine.
Click
Lower the lock lever
until you hear a click
as it locks into place.
Check the package contents.
• Machine
• Power cord
• Print head
5 Install the ink tanks.
1 Prepare the ink tanks.
Remove the orange-colored
protective film. If it is not
removed completely,
Remove the protective cap
and discard it.
MP760
• Ink tanks
Black BCI-3eBK
problems with printing
may occur.
Black
Cyan
BCI-6BK
BCI-6C
Magenta BCI-6M
Yellow BCI-6Y
Do not touch!
2 Insert the ink tanks.
• Easy Setup Instructions • Quick Start Guide
• Setup CD-ROM (Windows: silver, Macintosh: white)
The Setup CD-ROM contains the MP Drivers, as well as the User's Guide, Software Guide and Photo
Application Guide in electronic format. Please read these guides.
Click
A printer cable is not included. You must purchase a USB cable (less than 10 ft./3 m) to connect your
machine to a computer.
Press down until the ink
tank clicks into place.
Good example
Bad example. Tank 6Bk is
not fully inserted. Make
sure to press it down until
you hear a click.
2 Connect the power cord.
1 Connect the power cord.
3 Close the Inner Covers and the Scanning Unit (Printer Cover).
1. Connect one end of the power cord to the rear of the machine.
2. Connect the other end to the AC outlet.
2 If the message <There is no print head installed. Install the print head.>
appears, go to Step 4, "Install the print head."
Click
Click
Pull the Scanning Unit Lever
towards you to close the
Scanning Unit.
3 Load the paper.
IMPORTANT
Be sure to hold the Scanning Unit firmly with one hand.
1 Open the Paper Support, then pull out the extension.
Close the two Inner Covers.
2 Load a few sheets of letter-size blank paper into the Auto Sheet Feeder.
(1) Open the Paper
Load the paper with the print side face up.
Pinch and adjust
the paper guide
to the width of
the stack.
Support.
6 Align the print head from the Operation Panel.
Be sure to align the print head to ensure print quality.
1 Press [OK] to start print head alignment.
(1) This message appears.
(4) The machine will print
the print head position
pattern and automatically
align the print head.
(2) Press [ ] to select <Yes>.
Ensure the paper stack
does not exceed the paper
limit mark.
(2) Pull out the extension
until it stops.
4 Install the print head.
1 Ensure that the Paper Output Tray is
open. Then lift the Scanning Unit
If this message
does not appear
after closing the
Scanning Unit,
see "Aligning
The Print Head
Automatically"
in the Quick Start
Guide.
(1) If the Paper Output
(3) Press [OK].
Tray is not open,
press the Open
Button.
(Printer Cover) until it locks into place.
(3) Lift the
Scanning
Unit.
IMPORTANT
Be sure to hold the Scanning Unit firmly with one
hand.
Click
(2) Pull
the
If the printed pattern matches the illustration, print head alignment is complete.
Scanning
Unit
Lever.
You can change the language displayed on the LCD.
For details, see "Selecting The Language For The LCD" in the Quick Start Guide.
2 Remove shipping tape from the
Inner Cover and Open Both Inner
Covers.
The Print Head Holder moves to the center.
Do not touch the Print Head Holder while it is
moving.
3 Raise the lock lever.
Hardware setup and print head alignment is complete.
If you are connecting the machine to a computer for use, see the rear side of this sheet for
instructions on installing the software.
Touch only the lock lever!
Raise lock lever
completely.
Inner Covers
Canon and BCI are registered trademarks and PIXMA is a trademark of Canon Inc. in the United
States and may also be registered trademarks or trademarks in other countries.
All other products and brand names are registered trademarks or trademarks of their respective owners.
Specifications subject to change without notice.
HT7-0228-000-V.1.0
© CANON INC. 2004
PRINTED IN CHINA
|